vacuum cooling的例句大全

HOSES: Check radiator, cooling, heating and vacuum hoses for cracks and bulges.

软管: 检查散热器 、 冷却 、 供热和真空等软管有无裂缝和膨胀处.

High vacuum will speed up cooling process while it makes the mass loss increase.

提高真空度可以加快预冷过程,但会增加物料的质量损失.

The system consisted of vacuum tube collectors, one adsorption chiller, hot water tank, cooling ceiling, fan coil and independent dehumidification unit. The system provided air-condition to the 50 m2 test room.

该系统主要包括U型管式真空管太阳能集热器、吸收式制冷机组、蓄热水箱、辐射吊顶、风机盘管和独立除湿机组等，此系统为50m~2的测试房间提供夏季空调。

The neural network models for steam turbine power output and power needed in cycle cooling water system are established for the reference values of vacuum value of condenser and have a high precision and reliability.

建立汽轮机发电功率和循环水系统功耗神经网络模型以确定不同工况下凝汽器真空运行最优值，实现对二者的模拟预测，有很高的精度和可靠性。

Vacuum packer can complete the whole process of pumping air into vacuum state, sealing, lettering, cooling and exhaust in terms of the process, but just need to press the vacuum cover.

产品说明：真空包装机只需按下真空盖即自动按程序完成抽真空、口、字、却、气的全过程。

Heat rate Reducing, condensate overcooled removing, vacuum improving, reasonable material selecting and reasonable availing of the cooling area are contents to reengineer and design for improving the thermal efficiency of middle/ large scale steam turbine.

降低热耗、消除凝结水的过冷现象、提高真空、合理地选材和冷却面积最有效地合理利用是当今改造、设计，提高中、大型汽轮机组热效率的内容之一。

Research on Forced Cooling rate in High Pressure Vacuum Gas Quenching Furnace

真空高压气淬炉强化冷却速率的研究

Outer circling vacuum evaporator Study on feasibility of unilization of cooling water from steam turbine condenser

外循环列管式真空蒸发器蒸汽轮机凝汽器循环水再利用可行性分析

The conditions of crystallization are vacuum degree of 2 339 Pa, time period of 2 h, the terminal cooling temperature of 30 ℃.

确定了硝酸钾溶液真空冷却结晶操作条件为，真空度2339Pa，结晶时间2.0h，冷却终点温度30℃。

Test of Cooling Cylinder by Vacuum Pumping out Air

真空抽吸空气冷却汽缸试验

Development on Vacuum Valve for Closed Container of Thermoelectric Cooling Video Camera

热电制冷摄象机密封腔真空阀的研制

The problems about design of vacuum sealed container, thermoelectric cooling system, matched power and controllers are considered. A simulation CMOS video camera has been developed replacing the similar imported pro-ducts.

为了研制能够替代进口产品的模拟热电制冷CMOS摄像机，在设计时考虑了真空密封腔体、热电制冷系统和配套的一体化电源及控制器等问题。

other steps including large vents (open man-ways) and slowly cooling the tank are necessary to prevent excessive internal vacuum.

为防止罐内真空过高，需要采取其他措施，包括大的通气口（敞开的人孔）和缓慢冷却储罐。

Based on the simulation of vacuum tightness test in various operation conditions of condenser, the affection of vacuum tightness test in various operation conditions of condenser on stress of cooling tube is analyzed.

通过对凝汽器在不同运行参数条件下汽轮机真空系统严密性试验的仿真，分析了凝汽器在不同运行条件下，真空系统严密性试验对凝汽器冷却管热应力的影响。

selection of vacuum pump for large direct dry cooling unit

大型直接空冷机组真空泵的选择

The vacuum box is outside of the optical box, can keep good vacuum at a level of 10-6 Torr. The vacuum box, vacuum pump and a refrigerator are composed of the cooling system of the camera.

光学箱外部是真空箱，是整个系统的机械支撑，保证良好的真空密封性能，和真空泵、冷冻机一起构成了相机的致冷系统。

The heat load to the vacuum vessel thermal shield ( VVTS) is analyzed by FLUENT finite element software in order to demonstrate that the design of cooling tubes is reliable.

采取有限元法对内冷屏的受热状况进行了计算分析，以验证内冷屏氦冷却管道设计方案的可靠性。

Under the vacuum condition, the cooling rate of the zero dimensional metal droplets is between 10 5K/ s and 10 8K/ s.

零维液滴在真空条件下的冷却速度在105～108K／s之间。

fast cylinder cooling by low vacuum compound ventilation for 200 mw power generators

200MW汽轮机组低真空复合通风快速冷却汽缸的实践

Based on vacuum pumping accompanied with throttling process, presenting several superfluid helium cooling cycles and analyzing their flow principle and cooling characteristic.

以抽真空与节流相结合为基础，给出了几种超流氦冷却循环方式；