vacuum process的例句大全

development of white quick-dry coating for vacuum process castings

真空造型法白色快干涂料的研制

two kinds of process of depleted brine dechlorination were introduced, which were the process of air purge and vacuum dechlorination. after comparing, it showed that the process of vacuum process was better than the air purge dechlorination.

介绍了淡盐水空气吹徐脱氯工艺和真空脱氯工艺，通过对工艺的特点进行比较，认为真空脱氯工艺优于空气吹除脱氯工艺。

Using vacuum process the production of axle housing is described.

为避免这些不足，采用真空负压法试生产驱动桥获得成功。

High pure thallium iodide was made through the process of dissolving thallium in nitric acid, precipitating thallium ion by potassium iodide then subliming thallium iodide in vacuum.

以金属铊为原料，用硝酸溶解碘化钾沉淀真空升华的方法制备了高纯碘化铊，并且制备出多种球形碘化铊复合卤化物。

Study on Technology of Metal Matrix Composites Prepared by V EPC Method Selection of Vacuum Pump and Capacity Calculation of Dust Separator in Lost Foam and V-process Casting

负压实型铸造法制备金属基复合材料的工艺研究消失模与V法铸造用真空泵的选型和负压罐的计算

To resolve the key problems in the preparing process, such as the super high vacuum, the accurate controlling of Cs flux, the temperature of cathode, a new photocathode preparation chamber has been designed for the DC-SC electron gun.

针对制备中的超高真空、精确控制Cs原子流量和阴极温度等关键问题，设计了用于DC SC光阴极微波电子枪中的光阴极制备室。

The concept of relative water loss rate is advanced to judge the degree which actual water loss is higher than theoretical water loss in the process of vacuum cooling.

提出相对失水率的概念，作为比较真空冷却过程中实际失水高于理论失水程度的判断依据。

The Research on Spinning Formation Process of Stainless Steel Vacuum Thermos

真空不锈钢保温容器旋压成形工艺

Three-dimensional Consolidation Analysis of Sand Drain's Ground Under Combined Vacuum and Surcharge Preloading Considering Loading Process

考虑加载过程的真空联合堆载砂井地基三维固结分析

The analysis of thickness distribution control process of vacuum forming part by rigid visco plastic shell FEM

真空成形制件厚度分布控制工艺的刚粘塑性壳有限元分析

Using sponge iron reduced by iron ore concentrate powder as raw material, the smelting process of pure iron is investigated through non vacuum induction furnace and vacuum induction furnace.

以由铁精矿粉直接还原出来的海绵铁为原料，以非真空感应炉和真空感应炉为冶炼设备，对纯铁的冶炼工艺进行了研究与试验。

In the light of high quality casting production requirement, this article analyses the process of coating primary layer with silicasol, and put forward the method to coat the primary layer in vacuum.

本文通过对硅溶胶涂料面层涂覆工艺的分析，结合高质量铸件的生产要求，提出采用面层涂料真空涂制工艺进行特种铸件的生产。

Production process of artificial stone wall and floor tile by plane vibration press vacuum

人造石墙地砖平面振压真空生产工艺

Comparison between the Application of Tilting Pan filter and Rotary Vacuum Disk Filter in Wet Process Phosphoric Acid

转台式真空过滤机与翻盘过滤机的对比翻盘过滤机与转台过滤机在湿法磷酸生产中的应用比较

Connecting Technology of Vacuum Channel on Producing Titanium Sponge by Kroll Process

克劳尔法生产海绵钛的真空通道连接技术

The paper introduces the process of exhausting and ageing of 126 kV vacuum interrupter, and describes the exhausting and ageing methods of the vacuum interrupter and the application of absorbing agent and titanium pump.

介绍了126kV真空灭弧室的排气和老炼的研究过程，并阐述了烘烤排气和老炼去气的方法以及吸气剂与钛泵的应用。

Best Assembling Vacuum Unit on Producing Titanium Sponge by Kroll Process

试论克劳尔法生产海绵钛的最佳真空机组

Vacuum distillation is the key process to remove foreign materials from titanium sponge. Rational choosing of assembling vacuum unit is of vital importance to improving the quality of titanium sponge.

真空蒸馏是除去海绵钛中杂质的关键过程，合理选择真空机组对提高海绵钛的质量至关重要。

According to the features of reduction distillation technology and characteristics of all kinds of vacuum pumps, the best assembling vacuum unit on producing titanium sponge by Kroll Process was has been brought forward.

根据镁还原-真空蒸馏工艺的特点及各种真空泵的特性，提出了克劳尔法生产海绵钛工艺中真空蒸馏的最佳真空机组。

Study on Vacuum Anneal Process of Titanium Precise Profile Wire

精密异型钛材热处理工艺研究