valve stem的例句大全

These sets consist of a coupling which attaches to standard valve stem and an extension rod.

这些装置由可连接标准阀门阀杆的联结器和加长杆组成.

The molded step of the diaphragm should point down towards the relief valve stem.

隔膜的模制台阶应该对着安全阀阀杆.

Hammer blow and standard valve stem coupling designs available.

锤击和标准阀杆耦合设计可用.

Improvement on the structure between gate valve stem nut and bearing gland

闸阀阀杆螺母与轴承压盖结构的改进

the joint of the driving motor and the rotation valve stem is installed with a preloaded spring;

所述的驱动电机和旋转阀杆的连接处安装有预紧弹簧；

At this point, the air valve stem end is just the counter-plate surface in contact.

此时, 空气阀柱端部刚好与反作用盘的表面相接触.

Remove the relief valve assembly ( includes cover O-ring, stem and diaphragm assembly ).

拆卸安全阀总成 ( 包括阀盖O形环, 阀杆和隔膜总成 ).

The stem has a slightly smaller diameter than the valve bore.

阀杆的直径略小于阀体孔的直径.

For field replacement, specify valve type and size. Square Stem only.

如果用于现场更换, 请说明阀门类型和通径. 仅限于方形阀杆.

In the closed position, they are seated by thrust from the stem like a globe valve.

在关闭状态下,这种阀门正如截止阀一样, 通过阀杆推力将阀座封闭住.

the stem position indicates to the observer if the valve is opened or closed.

阀杆位置的高低,指明了阀门处于开启或关闭状态.

Operating Principle: The tied-diaphragm valve is a handwheel-operated valve, utilizing a two-stem connected through the diaphragms.

运转原理: 束缚隔膜阀是采用通过横膈膜连接的两个阀杆的手轮 型 阀门.

Stem sealing structure for high temperature gate valve

高温闸阀阀杆密封结构

GUD electric high vacuum ( pressure) ball valve uses electric device to drive the stem and ball for open and close, thus to put through or cut off the medium flow in vacuum ( pressure) pipeline.

GUD型-电动高真空球阀是以电动装置驱动阀杆与球芯来执行启闭动作，达到接通或切断真空系统管路中的介质流。

Gate valves serve as efficient stop valves with flow in either direction. rising-stem double-disk parallel slide valve

闸阀可作为流体双向有效的关闭阀。明杆平行式双闸滑阀

Under certain injection and production pressure, the stem position depends on the interaction between the flow in the chamber and the sliding rod in the valve.

在一定的注入压力和生产压力下，阀杆行程取决于阀腔内流体和浮动阀杆的相互作用。

The diaphragms may become permanently inverted and the elastomeric stem tip can cold flow down the throat of the valve.

横膈膜会永久性的翻转，人造橡胶阀杆尖端会冷变形到阀门的喉管处。

Non-rotating Stem with precision Acme threads and burnished finish. Valve suitable for horizontal installation.

不旋转阀杆具有精密梯形螺纹和经过抛光的表面光泽度。

The stem and diaphragm assembly will normally remain with the cover as it is removed. A gate or ball type valve can be used or the isolation valve can be installed further upstream.

阀杆和隔膜总成通常附在阀盖上与阀盖一起拆离。可以采用闸阀或球阀，或者可以将隔离阀安装在更上游的地方。

As the camshaft rotates, the lobe, or high spot of the cam, pushes against parts connected to the stem of the valve. Collar head rivet. Use in conjunction with other rivet ends.

当凸轮轴旋转时，凸轮凸起的或者高点的位置，推动气门座。凸边铆钉。与其他铆钉端点结合使用。