variable nozzle的例句大全

Pneumatic Actuating Mechanism for Variable Nozzle of VGT Based on PWM

基于PWM方式的变几何涡轮增压器可调喷嘴气动执行机构

Development of New Variable Nozzle Turbocharger Electronic Control System Based on PIC Microprocessor

基于PIC单片机的变喷嘴涡轮增压器电控系统设计

The CNG engine a Variable Nozzle Turbo ( VNT ) turbocharging intercooling system.

该发动机采用了增压中冷技术及可变喷嘴涡轮增压技术.

Variable Nozzle Turbocharger ( VNT) is the chief type of VGT and it can match with the diesel engine by rotating its nozzle pivots.

可变喷嘴涡轮增压器（VNT）作为VGT的一种主要型式是通过改变喷嘴环流通截面积的大小而实现增压器与柴油机的匹配。

The characteristics of the far-field noise of impinging jet with 3-millimeter diameter axisymmetric convergent nozzle under the condition of variable nozzle-to-plate distance, and their methanism were investigated experimentally.

测量了3毫米口径轴对称收缩喷嘴射流冲击大平板产生的噪声随冲击距离变化的特性。

with high temperature and high pressure in nozzle of wind tunnel , the effect of variable specific heat on nozzle design must be considered.

本文针对超音速、高超音速喷管内马赫数、温度变化剧烈的特点，研究了比热容变化对设计喷管型面产生的影响。

Spraying: Use an airless spray gun with a variable jet nozzle.

刷涂: 小面积粗略的材料可使用毛刷或辊.

The vehicle variable geometry turbocharger ( VGT ) with pneumatic and symmetric nozzle ring vane was researched.

对应用气动型与对称型喷嘴环叶片的车用 可变 几何涡轮增压器进行了研究.

this paper presents a method for thermodynamic calculation of the axial flow turbocharger turbine with variable geometry nozzle.

本文提出具有可变几何喷嘴的增压器轴流涡轮热力计算方法。

A random process model of structural functional function of components attached to vectoring thrust nozzle was employed, in which strength and stress of components were respectively taken as random variable and stochastic process.

本文将矢量喷管构件的强度考虑为随机变量，将构件的应力考虑为随机过程，建立了构件结构功能函数的随机过程模型。

Calculation for effect of variable specific heat capacity on nozzle flow field and performance

变比热容对喷管流场和性能影响的计算

The calculation and experiment results show that the maximum lifting pressure performance decreases with the increase in throat diameter of channel of variable section, water flux of low pressure and pressure ratio of steam nozzle, and has its minimum value with water nozzle annular space.

计算及研究表明：极限升压能力随变截面混合腔喉部直径、被升压的低压水流量和蒸汽喷嘴压比增加而降低，随环形水喷嘴间隙的变化出现了最小值；

nozzle governing and the variable operating mode of control stage

喷嘴调节及调节级变工况