velocity control的例句大全

The growth time and anode oxidize velocity control the thickness and porosity. Porous silicon layers were formed by anodization of Si wafers in hydrofluoric ( HF) solu-tion.

通过在阳极氧化反应中采用不同的HF溶液的浓度、电流密度和反应时间来控制多孔硅的膜厚、孔隙度等特性。

design of the arm wrestling robot based on force/ velocity control

基于力/速度控制方法的掰手机器人设计

At room temperature 20-22 ° C, the test preparation process must be controlled temperature, speed control, velocity control and the five washer process should make note that the actual operation would greatly improve the accuracy of detection.

在室温20-22℃条件下，试验制备过程中必须做到控温度、控转速、控流速及洗板过程中应注意事项，这样可大大提高在实际操作过程中检测的准确性。

In this paper, we use artificial fields to steer and control the steering angle and derive a linear velocity control law to guarantee the optimal convergent trajectory.

该文通过建立人工场的方法来引导和控制方向角，通过辅助的线速度控制前进或后退，以获取最佳收敛路径。

Then a angular velocity control law is designed for the robot to track the desired environmental boundary in constant linear velocity.

然后，为机器人设计了角速度控制率使得机器人最终以常线速度跟踪期望的边界曲线。

The paper establishes a double-loop control model suitable for three-phase electric regulating valve with large capacity, presents the mathematical model of the velocity generator, which takes increment of valve position as input, and the velocity control strategy for fuzzy parameter self-aligning PID.

本文构建了适用于大流量三相电动调节阀的双闭环控制模型，提出了以阀位增量为输入量的速度发生器的数学模型和模糊参数自整定PID的速度控制策略。

In this scheme, we establish the automotive emulation mode and select increased-PID control method. Through the simulation by Matlab/ simulink software, the cruising mode can completely achieve the automotive running in constant velocity control mode.

利用MATLAB／Simulink建立汽车仿真模型及整个系统的仿真模型并进行仿真，仿真结果表明，该控制方法能够实现汽车恒速控制。

Research on Combine Harvesters' Velocity Control System Based on Feed Quantity

基于喂入量的联合收割机速度控制系统的研究

Each of the shortage was analysed as the body slip angle as the control target for the four-wheel steering system, and as the yaw velocity as the control target for the stability system, and the integrated control system was made up of two subsystem.

分析了以质心侧偏角为控制目标的四轮转向系统和以横摆角速度为控制目标的车辆稳定性系统的各自特点，将两个子系统结合起来构成集成控制系统。

A guidance and control strategy for attaching the small solar system body is presented. The small solar system body attachment control is decomposed into the velocity direction and deceleration control.

提出了一种微小探测器软着陆小行星的制导与控制策略，将软着陆小行星控制分解为速度方向控制和减速控制。

First of all, with thrice Hermite interpolation to element displacement, the control equation of dynamics is derived in space-time domain. Two groups of space-time finite element formulae solving displacement and velocity are obtained.

作者首先对单元位移采用时域上三次Hermite插值多项式，在空间域和时间域中联合离散控制方程，分别推导出了动力学问题的两组递推公式，以求解位移和速度。

Combining depth-averaged numerical seepage flow model and 2-dimensional profile seepage flow model, seepage rate, seepage velocity field and hydraulic gradient of seepage control work in left abutment of Shawan hydropower station have been obtained.

采用深度平均渗流模型结合2维立面渗流模型，对沙湾水电站左岸坝肩“地窗式”防渗方案进行了渗流量、渗流场及渗透坡降的计算；

Such influencing factors as sulfonated drilling fluid's temperature, fluid velocity and Cl~-content, corrosion time, pH and moisture on corrosion rate were examined by the utilization of dynamic coupon, temperature and moisture control equipment and also electro chemical instrument.

利用动态挂片装置、调温调湿箱和电化学仪器，通过改变磺化钻井液温度、流速、Cl-含量、腐蚀时间、磺化钻井液pH值和湿度等条件，考察了这些因素对钻具腐蚀速度的影响。

Driver Follower Control Model with Vehicle Target Velocity Based on Preview Follower Theory

基于预瞄跟随理论的驾驶员跟随汽车目标速度的控制模型

After mental workload, compared with control group, lower reading velocity and IMC were found in obese group, mistake rate was higher ( P < 0.05), and test time was significantly longer than normal ones.

脑力作业负荷后，肥胖组阅读速度I、MC均低于对照组，错误率高于对照组（P

The system with double 8051 chips collaboration realizes frequency measurement, improves reaction velocity of measurement system greatly and can be widely used in real time control systems.

该系统采用双8051芯片相互协作实现频率测量，使测量系统的反应速度大大提高，特别适合于在许多实时控制的系统中推广应用。

The tension control system has many good characteristics such as good stability, quick reaction velocity, high control precision.

该张力控制系统稳定性好，反应速度快，控制精度较高。

The constant-gain negative velocity feedback, Lyapunov feedback as well as a linear quadratic regulator ( LQR) approach had been used for active vibration control with the beam subjected to impact excitations and/ or thermal loads.

采用常增益速度负反馈控制、Lyapunov反馈控制和基于独立模态的线性二次型调节器（LQR）设计主动控制器，实现了层梁结构脉冲激励和热载荷作用下的振动主动控制。

This paper solved the problem of how to analysis and control the programming error when machining complex surface, Based on the theory of spatial engagement, this paper present an algorithm of simulating complex surface, which is called velocity decomposed method.

本文从理论的角度探讨了复杂曲面数控加工中编程误差的分析方法问题，以空间点接触啮合的基本原理为理论基础，提出了一种数控加工复杂曲面的速度分解仿真算法。

A Method of Adaptive Control of Low and Constant Velocity

一种低速恒速自适应控制的方法