verified by的例句大全

The accuracy and practicability of the simulation program are verified by simulation on chopper, three-phase all-controlled bridge rectifier and three-phase half-controlled bridge rectifier.

通过对于瓦格纳斩波器、三相全控整流桥和三相半控整流桥的仿真验证仿真程序的正确性和实用性。

The performances of several typical AQM schemes are verified by NS simulator.

通过NS仿真器，深入研究了几个AQM算法的性能。

The validation of this method is verified by the comparison of the calculation results and the experiment results on a third harmonic excitation synchronous generator. So it can provide the mathematical base for the design of the harmonic excited synchronous generator.

最后用在谐波励磁同步发电机上的实验结果与计算结果的比较说明了方法的正确性，可为谐波励磁同步发电机的设计提供理论依据。

The accuracy of three-dimensional reconstruction was verified by experiment.

并通过实验的方法验证了三维重构的精度。

The results are20% more accurate in lifting coefficient calculation and70% more accurate in thrust coefficient calculation, which are verified by the computational and experimental data.

算法仿真表明，采用该模型可使平均升力和平均推力计算精度分别提高20%和70%左右。

It is verified by both theory and practice that this rotor-bearing system, to which small thrust load is applied, is suitable for small load and high-speed machine with cantilevered end.

从而从理论和实践上证实了这种轴承系统适用于受有较小推力载荷的悬臂支承轻载高速机械。

The damage of the cathode can be verified by measuring the surface temperature of the cathode rob head and the voltage reducing of the sub-bus-line.

通过测量阴极棒头表面温度及阴极小母线的压降可判断槽底是否破损。

A mathematical model of 7 degrees of freedom of the tractor is established by the paper. Transfer performances and dynamic responses of front axle of the tractor are emphatically analyzed. The preceding theoretical analysis results are verified by excitation test of the tractor on MTS road simulator.

建立了拖拉机整机7自由度的数学模型，着重分析了拖拉机前桥系统的传递特性和动态响应，通过拖拉机在MTS道路模拟机上的激振试验对上述理论分析结果进行了验证。

The characteristics of pressure distribution between rolls of HC mill and the variation regulations of the pressure distribution with axial displacement of middle roll have been calculated and analyzed by influence function method and elasticity basic beam model, and verified by three-dimensional photoelasticity stress analyzing test.

应用影响函数法和弹性基础梁模型计算分析了HC轧机的辊间压力分布的特性以及中间辊抽动时辊间压力分布的变化规律，并用三维光弹性应力分析法进行了实验论证。

The desulfurization characteristics of industry alkalinous wastes were verified by using TGA/ SDTA851e thermal balance and the high temperature tube reactor. Pore-structure of industry alkalinous wastes was detected with method of nitrogen adsorption.

利用高温管式炉和TGA/SDTA851e热重分析仪对工业碱基废弃物的固硫性能进行了试验研究，采用压氮法对工业碱基废弃物的孔结构进行了研究。

Data Processing and Analysis of Goniometer Verified by Non-Integral Degrees Polygon

用非整度多面棱体检定测角仪器的数据处理与分析

The formulae for SMIS are derived and verified by case simulation, the solution of critical clearing time ( CCT) of three-phase short fault in MMS is theoretically discussed.

对单机无穷大母线系统进行了公式推导和仿真验证，从理论上探讨了多机系统的三相短路故障临界切除时间求解方法。

The theoretical relationship between suspended concentration and settling velocity of sediment group during the settling procedure is established. The result is verified by experimental data.

本文通过数模对蓄泥库泥沙群体静水沉降速率进行了研究，并得到实验验证结果.这一分析结果最后表明：建立的浓度沉速时程关系是合理的；

The effectiveness of proposed system was verified by locomotive test at standstill.

机车定置试验进一步证实了本文方法的有效性。

The methodology was verified by experiments on the test cell and demonstrated a relatively high success rate.

对单一故障进行定性的诊断已经取得了试验验证，结果表明神经网络具有较高的诊断准确率。

Finally, in order to guarantee the synchronicity of multiple video input and output in true three-dimensional system, the multiple video frame synchronization software was designed. And the performance of it was verified by test with frame synchronization hardware device.

最后，为了保证真三维系统中多路视频输入输出的同步性，对多路视频帧同步软件进行了设计，并与帧同步硬件设备联合测试，验证了该软件的帧同步性能。

The genes of unknown function were verified by RT-PCR results and RT-qPCR results.

对5个未知功能基因进行RT-PCR和实时荧光PCR方法验证，结果与基因芯片结果相一致。

The above-mentioned method is verified by Hertz classical contact problem.

选用经典的Hertz接触问题对上述方法进行验证。

The vibration simulation model of a transducer system in thermosonic wire bonding was established by finite element method and verified by electrical sine sweeping exciting experiment.

在建立热超声引线键合换能系统各子部分运动方程的基础上，利用有限元方法建立空载情况下换能系统的振动特性仿真模型，并采用正弦扫频方法验证仿真模型。

Secondly, the 2-D triangle element, 3-D tetrahedral constant-strain element, 3-D hexahedral constant-parameter element dynamic consolidation finite element programs were compiled, and then verified by small examples respectively.

其次编写了二维三角形单元、三维四面体常应变单元和三维六面体等参数单元的动力固结程序，并通过算例对它们进行了验证。