vertical angle的例句大全

The angle subtended by any two neighbouring lines ( horizontal or vertical) is always equal to 5 degrees of ocular deviation movement.

任何两条相邻的横线条或直线条之间所含的角度恒等于5°的眼位偏转。

In this paper, the author analyzes the difference between the theoretical surface and the three types of practical surfaces which is processed by no spilling plane end mills, spilling level on plane end mills and spilling circle angle on plane end mills in vertical machining center.

针对用不倒角、倒斜角和倒圆角平头立铣刀在立式加工中心加工斜面时的情况，分别对理论表面与3种实际加工后的表面进行了分析。

The allowable settlement of pile head is suggested and vertical pile can bear load with inclination of less than 10 °, and batter pile bearing vertical load can be angle of less than 10 °.

以桩顶沉降控制作为桩基承载力设计的标准，认为直桩可以承受小于10°倾角的倾斜荷载，承受竖直荷载的斜桩可以有小于10°的倾角。

The length of the model is 5 m, it is maded of angle iron seat sensor, the beam on regulator vertical column; it's precision error has only been realized the support-country rock effect and the affinity of model for 0.5%;

实验选用的5m平面模拟架，主要由角钢座、调高块、立柱、传感器和顶梁组成，其精度误差仅为0.5%，实现了支架-围岩作用与原型的相似；

Methane excessive limit in upper corner angle area is a major problem during roof-coal-caving operation, when it is difficulty to lay out specialized methane discharging roadways in thinner coal seams, besides using E ventilation mode, vertical roof boreholes are used to discharge methane.

上隅角瓦斯超限是放顶煤开采遇到的主要安全问题，除采用E型通风方式外，在较薄煤层布置专用瓦斯排放巷困难时，可以采用顶板纵向钻孔抽排瓦斯。

The angle of inclination from the vertical of a vein, fault, or lode. Construction Technology of Long Curved Hoisting Transportation System in Steep Inclined Shafts

倾斜余角因矿脉，断层或矿井倾斜而与垂直面形成的角度大倾角斜井长曲线提升机运输施工技术

Angle. Brief analysis of quality control for fillet welding in vertical position

浅谈立角焊的质量控制

The legs' supporting angle of sector in the last step of run-up before the take-off has much effect on the drop of body center, horizontal speed and vertical speed in broad jump.

助跑最后一步摆动腿着地时，其小腿支撑扇角对踏板前的身体重心下降、水平速度以及离板瞬间的重心垂直速度有重要影响。

Measure the distance between the center point of aneurysmal neck and the nearest point of ipsilateral anterior and posterior clinoid and the angle between the major axis of aneurysm and the aneurysmal vertical projection line on horizontal plane, coronal plane and sagittal plane.

测量后交通动脉瘤的瘤颈中心到同侧前、后床突最近点之间的距离以及瘤颈长轴在水平轴面、冠状面和矢状面三个平面偏离中线的角度。

The utility model applies locking or unlocking of the bolt to fixedly lock a front fork vertical bar and the handgrip and adjust the angle of the handgrip, which is very convenient.

本实用新型借助螺杆的锁紧或松放，即可锁紧固定前叉竖杆与把手并能调整把手角度，调整便捷。

Design for slant angle of swing shaft of vertical wiper in road sweeper

清扫机立刷摆动轴倾角的设计

From the vertical perspective, it is a historical necessity; from the horizontal angle of view, in a time knowledge economy, the linkages between universities and high-tech industry is much stressed in each country.

从纵向角度看，高校与高技术产业的联结是历史发展的必然；从横向角度看，世界各国在知识经济时代都非常强调高校与高技术产业的联结。

This paper analyses the interactive development of Yangtse River Economy Belt from vertical and horizontal angle.

文章从横向和纵向2个方面分析了长江经济带的联动发展。

Experiments were carried on the guide within level, oblique and vertical, respectively. Matlab was used to achieve curve fitting for PC angle and displacement data, and perpendicularity errors of the guide was shown in the form of intuitive chart.

分别进行了导轨平放、斜放和垂直实验，用Matlab软件对传到上位机倾角和位移数据进行曲线拟合，以直观图的形式将导轨垂直度误差呈现出来。

There is larger vertical normal stress when the incident angle is less than 30 °;

当入射角小于30°时，基础容易产生较大的竖向应力；

In a general way, aerial image is not orthograph, most buildings exist slope angle as well as vertical lines in aerial images.

一般，得到的航空影像并不是正摄影像，在影像中对大多数建筑物均存在倾斜视角，且绝大多数建筑物还存在垂直边缘。

In order to segment character image correctly, vertical edge of sample form image is extracted firstly, then Hough transform is used to detect slant angle of image.

为保证字符图像正确分割，先提取样本表格图像垂直边缘，然后使用Hough变换检测图像倾斜角度。

development of special type belt conveyor, such as bending belt conveyor, the angle or vertical conveyor machine.

开发特殊型带式输送机，如弯曲带式输送机、大倾角或垂直提升输送机等。

mixing angle is adjustable with horizontal position for small-amplitude mixing and vertical position for fully mixing.

可调整混合角度，水平位置用于小幅混合，垂直位置用于完全混合。

rotary angle of vertical milling head

立铣头回转角度