wall coefficient的例句大全

Airflow temperature; Thermal conductivity; Unsteady heat transfer coefficient; Wall rock heat transfer;

风流温度；导热系数；不稳定传热系数；围岩传热；

In addition, radiation absorption coefficient had a remarkable effect on maximum combustion temperature and maximum wall heat flux in the new phosphoric acid tower.

辐射吸收系数对最高燃烧温度和壁面最大热流影响很大，随辐射吸收系数的增大，最高燃烧温度和烟气出口温度会下降，而壁面最大热流和平均热流会上升。

The finite element method is used to analyze maximum temperature, maximum wall temperature of cooled hole and maximum stress of the pre-designed photon shutter. A heat transform coefficient of 0.015 W/ mm~ 2 and bulk temperature 30 ℃ are used in the calculations.

通过有限元方法，分析了挡光器在热交换系数为0.015W/mm2、冷却水温度为30℃的工作条件下，挡光器的最高温度、最高冷却槽壁温以及最大热应力。

Compared with bare soil ( ck), planting Bahia grass on level bench terrace wall was the most effective method to conserve soil and water, it reduced average runoff coefficient by 85.19% and amount of soil erosion by 98.85%. Others also had various effects.

与全园裸露（对照）比较，水平梯田梯壁植草水土保持效果最佳，其平均径流系数减少85.19%，土壤侵蚀量减少98.85%，其他各处理也有不同程度防治水土流失的效果。

Wax deposition of Xinjiang crude oil is investigated on a test loop and the following conclusion can be derived: the deposit coefficient decreases as the shear stress at the pipe wall increases incurred by the change of the temperature or velocity of tile flow.

通过对新疆的几种油样进行试验研究，结果表明，当温度或流速发生变化从而引起管壁剪切应力变化时，沉积系数随着管壁剪切应力的增大而减小。

Based on the three-factor rolling theory in which Okamoto introduced v_m, the average deformation coefficient, the author derived the criterion and the formula for calculating the change in wall thickness of steel pipe during hollow drawing.

本文根据冈本丰彦引入平均形状变化系数u m的三元轧制理论，推导出钢管空拔时壁厚变化的判据和计算式；

Fifth, pile length, pile diameter, cut rigidity coefficient of side soil, and rigidity coefficient of bottom soil are main factors which influence working properties of thin-wall pipe pile using cast-in-situ concrete.

对影响筒桩承载性状的主要因素分析表明，桩长、桩径、桩侧土的抗剪刚度系数及桩端土的抗压刚度系数等是影响筒桩工作性状的主要因素；

The internal portion of nozzle afterbody is designed using the theory of expansion wave. The upper wall is designed for better thrust coefficient. The propulsion performance of nozzle afterbody is improved.

介绍了后体喷管的参数化设计方法，应用膨胀波理论设计后体内部喷管，以推力系数为目标设计上壁型面，提高了后体喷管的推进性能。

The Nusselt number ratio decreases with increasing Kn and decreasing thermal accommodation coefficient when one wall heated alone.

单环加热时，换热系数随内外径比的变化随Kn数的增加而下移；

The integrated boundary layer equations are employed for the solution of the laminar heat transfer of plane plate with stepwise-varying wall temperature and Pr < 1. The Mathematical expressions of the ratio of the thermal to the hydrodynamic boundary layer thickness and the heat-transfer coefficient are presented.

本文采用边界层积分方程组法，求解了Pr

The heat transfer coefficient and thermal inertial factor of exterior wall main body meet the requirement and that is suitable for energy saving alteration in hot summer warm winter area.

选择采用外墙内保温，即内抹玻化微珠保温砂浆的做法，外墙主体部位的传热系数、热惰性指标均符合要求，适用于夏热冬暖地区的节能改造。

The calculation model for tubular radiation recuperator has been established and the thermal transmission characteristics ( preheating temperature of air, temperature of furnace wall and thermal transmission coefficient) of the radiation recuperator for car-type heat treating furnace has been therefore analyzed.

建立了筒状辐射换热器传热计算模型，分析了台车式热处理炉上使用燃气辐射换热器的传热特性（空气预热温度、壁温和传热系数）。

As for the radiation heating surface of the furnace, take the effective coefficient of the thermal water wall as the fouling characteristic parameter, and then establish the overall monitoring model of a slagging heating surface based on the lumped parameter model and furnace exit gas temperature.

然后，对炉膛辐射受热面，以水冷壁热有效系数作为受热面的灰污特征参数，基于集总参数模型和炉膛出口烟温，建立了炉膛辐射受热面结渣的整体监测模型。

The amplitude and phase distribution depend on material thermal properties, wall thickness and local heat transfer coefficient.

利用博里叶变换分析温度基波相位和幅值变化，进而推算壁面的局部换热系数。

Measurement of Effective Thermal Conductivity and Wall Individual Heat Transfer Coefficient of Catalysts for Vinyl Acetate Synthesis

乙烯基乙酸酯合成催化剂的有效导热系数和壁给热系数测定

In order to save soil resources and reduce building principal part structure engineering cost, finite difference method, harmonic wave method and response coefficient method have been utilized to analyze the unsteady thermal characteristics of wall insulation in low energy consumption building.

为节约土地资源和降低建筑主体结构工程造价，采用有限差分法、谐波法和反应系数法对节能建筑复合墙体的非稳态热工性能进行全面分析。

After comparison of the result from pushover and IDA, The structural influencing coefficient and deflection amplification factor of the semi-rigid connected steel frame-steel plate shear wall structures that designed according to building seismic code of China are suggested. 7.

对Pushover分析与IDA分析的结果进行了对比，根据两种分析方法的结果，提出了按照我国规范设计的半刚性连接钢框架钢板剪力墙结构的结构影响系数和位移放大系数的取值。

Calculation of Heat Transfer Reaction Coefficient of Wall

墙体传热反应系数的计算

Analysis and determination of items amount of reaction coefficient for unsteady heat transfer calculation of wall

墙体不稳定传热计算中反应系数项数的分析与确定

Analysis of unsteady heat transfer-method of reaction coefficient in new type energy saving wall

新型节能墙体的动态传热反应系数法分析