wear value的例句大全

It is expected that the wear value of automotive clutch part used in certain condition can be predicted to control the part wear and determine the reasonable maintenance and repair time.

汽车离合器在实际使用过程中，希望能预测出一定条件下工作的零件的磨损值，以便于控制零件的磨损和制订合理的维修期限。

As for UHMWPE-base composites reinforced by Cu powder, the one whose filling Cu powder makes up 15% of the composite by weight has lower friction coefficient and smaller wear value than the others.

填料Cu粉质量分数为15%时的复合材料摩擦系数较小，磨损量较低；

Experimental result shows that, under magnetic field the comprehensive load capacity can be improved greatly and composite wear value of the ferrofluid can be increased by 1.3 times.

试验结果表明，磁流体润滑膜在外加磁场作用下，综合承载能力得到了很大的提高，最大可提高至原来的1.3倍。

It is proved that most kinds of polymer additives can improve the composite wear value of oiliness and EP agent.

结果证明多数粘度指数改进剂可提高油性极压剂的综合磨损值。

Research on a Calculation Method of Wear Value of a Cam-Follower in an Internal-Combustion Engine

内燃机凸轮挺柱磨损数值计算方法的研究

The wear value is real-time displaying on the measurement software interface, and we can also view the current processed rail curve.

处理后的磨耗值实时显示在测量软件界面上，并能查看当前点处理后的钢轨轮廓曲线。

Firstly the variable cutting parameters of spiral rod milling are analyzed to extract the eigenvalue of vibration and power signals. Then the mapping between the signal eigenvalue and the tool wear value is established.

该方法针对螺杆加工中变切削参数的工况，提取了振动信号和功率信号的刀具磨损特征值，并建立了信号特征值与刀具磨损量之间的映射关系，从而得到刀具磨损模型。

Firstly, according to standard wear limit, original data were transformed into BOOL value.

首先依据各种分析方法的标准磨损界限值，将原始数据进行了预处理，统一转换成故障征兆的布尔值；

The three body corrosion wear behaviors of martensitic ductile iron and low chromium white cast iron under the test conditions of different pH value slurries have been studied.

对马氏体球墨铸铁在不同pH值石英砂浆中的静载三体腐蚀磨损特性进行了试验研究，并与低铬白口铸铁进行了对比。

Things such as plant equipment were assigned a market value expected to wear out over time.

工厂和设备等物品都被赋予市场价值,而且将会随着时间的推移而逐渐损耗.

Wear loss decrease as speed increases and reach a plateau when speed reaches certain value.

在一定转速范围内，磨损量随着转速的增加而减小，减小到一定值后趋于平稳。

When the sliding velocity or load exceeds a certain critical value, the wear volumes of the two nitrided layers increase with increasing the sliding velocity or load.

当超过一定的滑动速度或载荷时，两种渗氮层的体积磨损量随载荷或滑动速度的增加而迅速增加。