weld metal的例句大全

Mechanical test of base metal and weld metal revealed no degradation of tensile properties.

拉伸试验结果表明，母材和焊缝金属的抗拉性能没有劣化；

For different shielding gases and welding wires, the influences of residual aluminium on hydrogen porosity in weld metal are different with each other.

低合金钢气体保护焊实心焊丝中的残余Al对焊缝金属氢气孔的影响，既取决于焊丝的合金体系，又与保护气体氧化性的强弱有关。

Addition of activating agent has no obvious effect on fracture toughness of weld metal.

添加活性剂对焊缝金属的断裂韧性没有明显作用。

The effect of Ti in the V and N coexistent weld metal

Ti在V、N共存焊缝中的作用

In this paper, the temperature field of weld metal solidification cracking in the stainless steel was analyzed and simulated.

进行了不锈钢焊接凝固裂纹温度场分析与数值模拟。

Hydrogen Induced Delayed Fracture of 308L and 347L Weld Metal

308L和347L焊缝金属的氢致滞后断裂行为

The dynamic mechanics property test of weld metal under three kinds of different vibration conditions ( 0, 0.3g and 0.6g) was carried out. The welding parameters and other test conditions were consistent. The vibration can obviously improve the storage modulus of weld metal.

对三种不同振动加速度（0、0.3g和0.6g）下的焊缝金属进行动态力学性能试验，结果发现：振动可以明显改善焊缝金属的储能模量；

Corrosion Behaviour of Strained SUS 316L Weld Metal in Melten Sodium With High Temperature

受应变SUS316L焊缝在高温液态钠中的腐蚀行为

The microstructure of the weld metal was found to be tempered martensite with a little of delta ferrite.

焊缝显微组织主要是回火马氏体和块状δ铁素体组织。

Experimental study of diffusible hydrogen in weld metal

焊缝金属中可扩散氢含量的试验研究

Effect of torrefied conditions of basic welding rod coating on diffusible hydrogen ( H_D) in weld metal

碱性焊条药皮处理条件对焊缝金属扩散氢影响的研究

The interaction of rare-earth alloys and their oxides with diffusible hydrogen in steel weld metal was investigated. The resul(?)

本文探讨了稀土金属合金及其氧化物与焊缝金属中扩散氢作用的规律。

The effect of different kinds and different content rare earth oxide added in coated electrode on low temperature notch toughness, weld metal microstructure and diffusible hydrogen was studied.

通过向焊条药皮中加入稀土氧化物的方法，研究了在焊条药皮中加入不同种类、不同含量的稀土氧化物对焊缝金属低温冲击韧性、显微组织以及扩散氢含量的影响。

The test block within the hydrogenation reactor after 5 year service exposure is investigated and the susceptiblity to temper embrittlement of weld metal in the test block is assessed.

对在役运行5a后加氢反应器中的试验试块进行研究，评定了试验试块焊缝金属的回火脆性。

Bending test results show that weld metal has excellent plasticity.

弯曲试验表明焊缝具有良好的塑性。

The authors studied the welding technology and parameters for the tin-plate can and thier influence on welding speed and quality, investigated the microstructure and properties of the weld, analysed the distribution of tin in weld metal and carried out the flange test of the can body.

本文研究了罐身马口铁激光焊接工艺和焊接参数对焊接速度和质量的影响，检验了焊接接头的组织和性能，分析了Sn在焊缝中的分布，并进行了空罐的翻边试验。

The results showed that the low-temp toughness of weld metal could be improved markedly through the welding method of two beads per layer, so that the recrystallization occurred in the middle zone of weld.

结果表明：通过采用每层两道的焊接工艺，使对接焊缝中心部位全部发生重结晶，是焊缝金属低温韧性提高的关键。

Because the side beam is asymmetric, and the external four longitudinal weld locate four corner of longitudinal neutral axis ( X axis) of the side beam. For the groove weldment, the shrinkage of weld metal is the main factor making residual welding deformation.

由于侧梁非严格对称，且外部4条主焊缝环绕在纵向中性轴（X轴）的四个角点；焊缝金属收缩是形成焊接残余变形的主要因素。

Measurement of Diffusible Hydrogen within Weld Metal by a Gas Chromatography

应用色谱法测定焊缝金属中的扩散氢

Weld Metal Toughness of Submerged Arc Welding Wire WQ-1

WQ-1高韧性埋弧焊丝焊缝金属强韧性的研究