wire diameter的例句大全

This operation consisted of drawing wire through a die to reduce it to the desired diameter.

这项作业通过拉线模,把钢丝拉成符合要求的直径.

A new non-contact method for dynamic measuring the diameter of wire rod is presented.

提出一种新的 非接触式 动态测量金属线材直径方法.

The main manufacturing technique of single-crystal copper wire is drawn-bench by draw die, it is considerably difficult to measure the diameter size.

单晶铜线材主要是采用拉模拉丝方式生产，很难在生产现场实时测量其直径。

Points out that using wire rope as main span wire is of great limitations in suspension crossing design and high-strength steel wire of parallel bunch as main span wire is imperative to large pipe diameter and large span suspension crossing engineering.

指出在悬索跨越设计中用钢丝绳作主索的局限性很大，而对大管径、大跨度悬索跨越工程采用高强钢丝平行束作为主索势在必行。

This last error depends on the wire spacing and diameter.

后者引起的误差取决于导线的距离和直径.

The specification of the copper wire is indicated in nominal diameter, as shown in Table 2.

圆铜线的规格用标称直径表示,其范围符合表2规定.

The elastic modulus of the surface layer does not change with a decreasing nanowire size whereas the elastic modules of core layer decrease with a decreasing wire size, leading to the fact that the overall elastic modulus of nanowires decreases as the diameter decreases.

结果表明，金属纳米线的弹性模量具有尺度效应，随着直径减小，整体弹性模量减小，主要是因为核心层弹性模量减小，表面层弹性模量变化不大。

The theoretical error of scattering pattern method for measuring the diameter of metal thin wire and it's modification

用散射图法测量微金属丝直径的理论误差及其修正公式

Optimum Selection on Diameter Ratio of Wheel to Rope in Tension Gear of Steel Wire Rope on Quayside Container Gantry Crane

岸桥钢丝绳张紧机构轮绳径比的优化选择

According to features of thick wire electrode ( diameter 1mm) ( aging bending deformation, loss lengthen, torsion deflection and protuberant deformation), weights constant tension mechanism, roller institutions and block pin parts were designed.

针对粗电极丝（直径特性（时效弯曲变形、损耗加长、扭转变形和突起变形），设计了砝码恒张力机构、辊压机构及挡销部件。

When the hulling cylinder speed is 25 r/ min, the diameter of steel wire is 2.3 mm, the clearance between steel wire tip and hulling cylinder is 50 mm, the quality of walnut hulling is the best.

在剥皮滚筒转速为25r/min，钢丝直径为2.3mm，物料入口处钢丝顶端与滚筒的间隙在50mm条件下，可获得较理想的作业质量。

The working characteristic of wire rope for well drilling, and the use conditions, structure, specification and production technology requirements of large diameter wire ropes for drill oil derrick base rising are analyzed.

分析钻井用钢丝绳的工作特点，钻机井架底座起升用粗直径钢丝绳的使用工况条件、结构、规格和生产技术要求；

The range analysis of experimental data shows the degree of influence of the four factors including porosity, diameter of wire, inner diameter of spiral coil and blank-laying methods on the resistance of MR and its law of change.

对正交试验数据进行极差分析，得出了孔隙度、金属丝直径、螺旋卷内径和毛坯铺设方式4个因子对金属橡胶材料电阻的影响程度大小以及电阻的变化规律。

The welding apparatus is flexible for adjustment and has good stability, and can be used for single and double wire internal welding, especially satisfied with the requirements of internal welding techniques of small diameter spiral pipe production.

该该新型螺旋焊管内焊装置调节灵活，稳定性好，可应用于内焊单丝或双丝焊接，特别适合于小口径螺旋焊管生产的内焊工艺要求。

Production Research and Development Present Situation and Suggestion of Large Diameter Steel Wire Rope in China

我国粗直径钢丝绳的生产研发现状及建议

Ultra-fine-pitch wire bonding may make some parameters to their physics extreme, require the free air ball and bonded ball of smaller diameter and the diameter of gold line adopted.

超细间距引线键合将部分参数推向其物理极限值，要求更小直径的金球（Free Air Ball）和键合球（bonded ball），所采用的金线直径更小。

And the anode is mad by gild tungsten wire of 0. 025 mm diameter.

阳极丝是0.025mm镀金钨丝。

To introduce the selecting and using principle of wire rope for engineering machine. It is pointed out that the rotation direction of wire rope should be against that of rope groove, rope diameter is less 1% than pitch of rope groove.

简述工程机械用钢丝绳的选用原则，指出钢丝绳的旋向应与绳槽相反，绳径应比绳槽节距小1%。

Application of machine vision on measuring diameter size of single-crystal copper wire

应用机器视觉技术测量单晶铜线材的直径

The laying quality of wire rope can be improved by means of controlling the diameter of rope core, lay length ratio of all lay strands, parameters of preforming and postforming, adjusting the structure of wire rope in the course of practice production.

在实际生产过程中，通过控制绳芯直径、各层绳股的捻距配比、预变形和后变形等工艺参数以及调整钢丝绳结构等方法提高钢丝绳的捻制质量。