working electrode的例句大全

Based on a screen printed carbon electrode which contained a sensitive film prepared by crosslinking acetylcholine esterase ( AChE) with glutaraldehyde on the surface of working electrode, an amperometric enzyme biosensor was taken on the determination of organophosphorus ( OP) pesticide in water environment.

采用丝网印刷技术制作厚膜型电极，通过交联法将乙酰胆碱酯酶固定在电极上，开发快速检测水中有机磷农药的酶传感器。

Therefore, any changes in the cell are ascribable to the working electrode.

因此, 电池中的任何变化,都归因于工作电极.

In this paper, the electrode materials of VRB were modified, and the kinetic parameters of varies working electrodes reaction were also calculated.

本论文针对钒电池电极材料进行了改性研究，计算了不同工作电极反应的动力学参数。分析了电池充放电过程中电池性能的变化及其电池失效的原因。

Three-electrode system is introduced to test the difference. Ni ( OH)_2/ NiOOH is used as the counter electrode, CNTs-Ni ( the mass ratio is 1:9) as the working electrode and Hg/ HgO as the reference electrode.

采用三电极体系，Ni（OH）2/NiOOH为对电极，CNTs-Ni（质量比为1：9）为工作电极，Hg/HgO为参比电极，30%的KOH作为电解液。

The working electrodes such as gold electrode, platinum plate electrode and glass carbon electrode have been researched to choose a proper one.

工作电极就金盘电极、铂盘电极和玻碳电极进行了研究和选择。

Peaks on polarization curves of fast sweep of Pt working electrode, which reduced the limiting current region and was the restricting factor to decide the etching current density by high sweep rate of potential, corresponded to the reduction reaction of Fe 3+ to Fe 2+.

快速电位扫描获得的Pt电极极化曲线上有波峰出现，相应于溶液中Fe3＋还原为Fe2＋。波峰缩短了极限电流平台区，成为利用快扫描获得合金蚀刻电流密度的限制性因素。

Development of an amperometric immunosensor for the diagnosis of sub-clinical mastitis in dairy cows: self-assembled process of the working electrode and its characterization of performance

诊断奶牛隐性乳腺炎的电流型免疫传感器的研究&工作电极的自组装及性能表征

The article introduces a pneumatic electrode clamper used for ferroalloy furnaces, including its composition and working principle.

本文介绍铁合金炉气动电极夹紧机构的结构组成及工作原理。

The spindle electrode head of EDM completing working and retracting, until entirely leaving the cutting fluid, will obtain the resistant effect of liquid.

电火花成形机主轴电极头在回退、直至完全离开工作液的过程中，会受到工作液对其表面产生的阻力作用。

There are four working modes of ER damper, flow mode of fixed electrode, shear mode of slide electrode, mixer mode of slide electrode and squeeze damper.

电流变减振器的工作模式可以分为固定电极的流动模式、滑动电极的剪切模式、滑动电极的复合模式和挤压膜减振器。

The arc current and arc voltage are the input of the electrode controller which is the principal section of the electric arc furnace control system. It is the premise of assuring the normal working of electrode controller that arc current and arc voltage are measured accurately.

电弧电流和电弧电压是电弧炉控制系统最重要环节电极控制器的输入，精确测量电弧电流和电弧电压是保证电极控制器正常工作的前提。

At the current density of 17 mA/ cm~ 2, the batteries show a flat working voltage, little electrode polarity effect and nearly theoretical capacity.

充放电测试结果表明，在17mA/cm2的电流密度下，材料工作电压平稳，电极极化效应较小，容量接近其理论值。