x ray diffraction的例句大全

Studies on X ray diffraction pattern of traditional Chinese medicinal materials

中药材X-射线衍射图谱研究

The principle of residual stress analysis by X ray diffraction was introduced.

利用X射线衍射应力分析的sin2ψ法测量、计算出氮化硅陶瓷试样的残余应力。

Surface components were measured by X ray diffraction.

X衍射仪表征颜料的表面成分；

Preliminary Report on the X Ray Diffraction Characteristics of Several Modified Phosphorus Fertilizers

几种改性磷肥的X射线衍射特征初报

The predicted values are consistent with results of X ray diffraction stress testing.

估计结果得到X射线应力测试的验证。

The reaction behavior, phase transition and microstructure of the membrane were investigated by different techniques, such as thermogravimetric analysis, energy dispersive spectroscopy, X ray diffraction, thermomechanical analysis and scanning electron microscopy. The structure of alumina hollow fiber membrane is asymmetrical.

采用热重分析、能量色散谱、X射线衍射、热机械分析和扫描电镜等手段对烧结过程中的反应行为、相转变及膜的微观结构进行了研究。

X ray Diffraction analyses are performed to establish the mineralogical changes following treatment.

为了更好地了解淤泥在水泥处理前后的物理化学性质变化，做了X射线衍射试验。

Preparation and X Ray Diffraction Analysis of C 60 Br 24 Single Crystal Powders

C（60）Br（24）粉末单晶的制备及X-射线衍射分析

Determine for Surface Phases of Ti base Alloys Anode by X Ray Diffraction

钛基合金阳极表面物相的研究&X射线衍射法

The petrologic characteristic and the pore types of Y8~ Y10 reservoir are studied by X ray diffraction method, the quantitative mineral clay analysis method and thin section analysis method.

利用X衍射全岩分析方法、粘土矿物定量分析方法和薄片鉴定等方法研究了城华地区延8-延10储层岩石学特征和孔隙成因类型。

Test plate of Fe 6 5% Si alloy is prepared by directional solidification, which is studied by optical microscope observation, X ray diffraction analysis, EBSD investigation and magnetic determination.

采用定向凝固方法制备了Fe65%Si实验合金板，并进行了金相观察、X射线衍射分析、EBSD分析和磁性测定。

The nano crystalline powder were characterized by applying such means as X ray diffraction, differential thermal analysis and infrared absorption spectrum.

运用X射线衍射（XRD）、差热分析（DTA）和红外吸收光谱（IR）等分析手段对纳米晶粉进行表征。

The mechanism of reinforced oxygen bleaching of Soda AQ reed pulp was investigated by means of FT IR and X ray diffraction analyses.

用X射线衍射法和傅立叶变换红外光谱法（FT IR）进行Soda AQ法苇浆的强化氧气漂白机理研究。

under the acid free condition, 3 acetyl 2 hydroxy 6 methyl pyran 4 one ( 8) was obtained and its structure was confirmed by x ray diffraction analysis.

在没有酸催化的条件下，反应生成3乙酰基2羟基6甲基-吡喃4酮（8），并通过单晶X射线衍射分析确定了产物的结构；

In quantitative analysis of diffraction experiment by X ray diffraction meter, resolving time of Geiger counter would result in metrical omitting.

用X射线衍射仪做定量分析衍射实验，会出现因盖革计数器存在分辨时间而漏计的现象。

The characterization of the crack in palm of the roller bit produced by overlaying welding and heat treatment was studied with the scanning electron microscope ( SEM) and its residual stress was tested with X ray diffraction ( XRD).

运用扫描电子探针对三牙轮钻头牙掌堆焊和热处理后产生的裂纹特征进行了分析，并采用X射线衍射仪测定了牙掌试件的残余应力。

By X ray diffraction technology, phase structure of carbonaceous char being formed in the process of combustion of intumescent coating has been studied systematically.

采用X射线衍射技术，对膨胀型防火涂料经过大板燃烧后所形成的炭质层的物相结构进行了系统研究。

the structure of the thin film was characterized by means of fourier transform infrared spectrometry, x ray photoelectron spectrometry, x ray diffraction, and transmission electron microscopy.

采用X射线衍射仪、傅立叶红外光谱仪、X射线光电子能谱仪及透射电子显微镜等对薄膜结构进行了表征。

The structure of permeated layers was analysed through scanning electron microscope, X ray diffraction, energy spectrum and corrosion measuring system.

通过扫描电子显微镜、X射线衍射、能谱和腐蚀测量系统对渗层组织进行了分析。

Based on the crystallography properties of carbon fiber, a method of determining the interfacial residual stress in carbon fiber reinforced epoxy composites by X ray diffraction technique was established in this paper.

根据碳纤维的晶体学特点，提出了利用X射线衍射技术分析碳纤维/树脂基复合材料界面残余应力的新方法。