yield load的例句大全

Studying bearing capacity including crack load, yield load and ultimate load, formability, wasted energy by testing load displacement stagnates time of curve and horizontal load strain of curve. 3.

通过试验墙板的荷载&位移滞回曲线、荷载-应变关系曲线，研究现浇剪力墙板和叠合式剪力墙板的承载能力（开裂荷载、屈服荷载、极限荷载）、变形性能和耗能能力。

The areas of hysteresis and yield load in KO group were ten and fourteen times greater respectively in Sham group.

治疗组滞后环面积、屈服载荷分别为阳性对照组的10倍、14倍。

Cracking load, yield load and ultimate load are obviously higher.

开裂荷载明显提高，屈服荷载和极限荷载均显著提高。

Inelastic yield load formula of axial compression middle long columns was deduced through the use of tangent modulus theory.

并用切线模量理论推导出计算钢管煤矸石混凝土轴压中长柱非弹性屈曲荷载的计算公式；

The FEM calculation shows that with increasing loading rate, general yield load Pgy, stress and strain rate ahead of notches for the notched specimens increase.

有限元计算表明：缺口试样的整体屈服载荷Pgy，缺口前的应力，应变率均随加载速率的增加而增加。

Evaluation of ultimate load of inner-edge-clamped annular plates based on Mises yield criterion

用Mises屈服条件求内边界固支环板的极限荷载

On load carrying capacities of ring plates under Mises yield condition by using the method of weighted residuals

用加权残数法求环板在Mises屈服条件下的极限载荷

Investigation of the limit load of circular plate with the method of weighted residuals under Mises yield condition;

而后根据极限状态的原始定义，利用有限元法求出极限载荷的精确结果。

Under harmonic loads, when the load frequency is less than the basic frequency of the SDOF systems, the amplitude is reduced with the increase of the post-yield stiffness.

在简谐荷载作用下，当荷载频率低于结构自振频率时，总体上振幅随后期刚度增大而减小；

The analysis results show that the stability of long span curve continuous rigid frame is actually the ultimate load carry capacity considering the yield strength of material and the effect of the geometric nonlinear effect to structure can not be ignored.

结果表明：弯连续刚构桥梁的稳定问题已经转化为考虑结构材料屈服强度的极限承载力问题，同时几何非线性对稳定的影响亦不能忽略。

Whereby the modulus of elasticity E and yield strength are measured from recorded load-displacement curves.

用自动描绘的力变形曲线测得弹性模量E和屈服强度σ（0.2）。

The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.

搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。

Yield line method for calculation of the load-carrying capacity of stepped K-type gapped RHS-joints

不等宽K型间隙方管节点承载力计算的塑性铰线法

The results showed that flour yield of C1A was controlled at about 35%, the load was more balance both C1A and C2A in eight_roller mill.

实验结果表明：C1A的取粉率控制在35%左右时，八辊磨C1A与C2A的负荷比较均衡。

Mixed engine assembly line is the process to assemble a sequence of different models of engine. Whether it can achieve load, variety and yield the balance of production, depending on the assembly line planning and designing.

汽车发动机混流装配生产线是对不同型号发动机顺序装配的流水线工艺过程，混流装配生产线规划设计的好坏决定了能否实现生产线负荷、品种、产量的均衡化生产。

the yield line model of stepped k-type gapped rhs-joints subjected to the combined chord axial compression load and branch axial loads is established in the paper.

建立了考虑弦杆轴向压力影响的不等宽K型间隙方管节点的塑性铰线模型，并推出了节点承载力计算公式。

Farmers took several payments for each load of product and inflated their yield reports.

每批农产品,农民们都分好几次付款支付,并以此夸大其产量报告.

Modifying the yield line pattern in reference 〔 1 〕, a defect of the theoretical solution in reference 〔 1 〕 is mended, that is, with increasing the area of the steel plate, the load carrying capacity will increase to infinite.

改进了文献〔1〕的塑性铰线模式，修补了文献〔1〕的理论解的一个缺陷，即随着粘钢板的面积增加，承载力上升至无穷大。

Meanwhile, the failure load predicted by net section yield criterion of multiple cracks is presented.

同时采用了多处损伤剩余强度净截面屈服判据预测破坏载荷.

Thanks to tensile membrane action, the actual load capacity was much grater than the design capacity using yield-line theory.

由于受拉薄膜效应的存在，混凝土板的实际承载力比按塑性铰线理论的计算结果高得多。