locknut

Tighten valve adjusting screw locknut to 27 N · m ( 20 lb-ft ).

将气门调节螺丝防松螺母拧紧至27牛顿·米 ( 20磅 - 尺 ).

So far, the studies of Fe-Mn-Si shape memory alloy threaded connection locking have focused on the locknut, and based on the recovery of Fe-Mn-Si shape memory alloy constraints locking bolt has not yet published in the paper.

至今，对Fe-Mn-Si形状记忆合金螺纹连接防松研究均集中于防松螺母，而基于Fe-Mn-Si形状记忆合金约束恢复的防松螺栓研究还未见报道。

Hold the adjusting screw from turning with screwdriver and tighten locknut to27 N · m ( 20 lb-ft).

用螺丝刀止住调节螺丝不让其移动，并将防松螺母拧紧至27牛顿·米（20磅-英尺）。

Tighten locknut 1 to fix the thread stand.

拧紧固定螺母1不让线架装置松动.

Numeric analysis of the anti-breaking mechanism of Fe-based SMA locknut

铁基形状记忆合金防松螺母防断机理的数值分析

For example jersey cloth, rayon locknut and nylon tricot are made in this method.

例如紧身运动套衫面料 、 粘胶长丝经平绒针织物和尼龙经编织物都是用这种方法制成的.

Recheck clearance on all valves again after locknut is tightened.

防松螺母拧紧后,再对所有气门的间隙重新检查一次.

It has locknut fasten rotor to a spindle.

配有防松螺母固定转子与中心轴.

Research on a new-type intelligent locknut

一种新型智能防松螺母的研究

The adjusting nut and the anti-fake seal fixing body are arranged on locknut through screw threads.

调整螺母、 防伪 印模固定体用螺纹安装在锁母上.

Position locknut over top of fuel pump module.

将锁定螺帽放在燃油泵模组上.

The valve is mainly made up of handle, body, disc, locknut and seal etc.

手动密闭闸阀主要由把手 、 阀体 、 插板 、 锁紧螺钉、密封装置等部件组成.

Recheck clearance again after tightening locknut . Readjust clearance as necessary.

拧紧防松螺母后,再一次检查间隙,视需要重新调节间隙.

The locknut is rotated to lock the spring chuck, so as to clamp a drill bit which is enabled to rotate along with the spindle to carry out the drilling processing.

通过转动锁紧螺母锁紧弹簧夹头从而夹紧钻头，使钻头跟随主轴旋转进行钻削加工。

Fuel Pump Module Locknut

燃油泵模组锁定螺帽

To replace seat/ stem module shut off supply, loosen locknut and back off adjusting screw.

要更换阀座/杆模块，先关闭供应管道，松开锁紧螺母，退出调节螺丝。

Secure with locknut and gaskets. Install valve assembly.

用放松螺母和垫圈紧固. 安装阀门总成.