normal direction

The recrystallization textures consist of cube orientation rotated by 20 ° round normal direction ( ND) and { 011} 〈 122 〉 orientation for samples overaged and then cold rolled.

冷轧前进行过时效处理，其再结晶织构主要由绕法向旋转了20°的立方取向（Cube+ND20）和{011}〈122〉取向构成；

The results show that the emission direction of the hot electrons at the rear side of the target shifts towards the target normal direction as the target thickness increases.

实验发现，随着靶厚度的增加，靶后超热电子的发射方向向靶的法线方向移动，同时电子束的发散角变大。

Through the present calculation of rock mass stability, it is considered that the angle 6 between the force acting on the breaking face and the normal direction of the face would be more appropriate to take the angle of internal friction of rock.

通过对目前稳定岩体的计算，认为内破裂面作用力与法线夹角δ值取岩石内摩擦角比较合适。

The unsteady state term was discretized using the full implicitly schemes. For the diffusion terms, the normal direction vector ( the first diffusion) and the tangent direction vector ( the second diffusion) were calculated by using the intersectant and iterative algorithm.

对于非稳态项采用全隐格式，对于扩散项，采用法向扩散项（一次扩散项）和切向扩散（二次扩散项）进行相互交叉迭代的算法。

When Zircaloy-4 plate is rolled at high a tempera-ture, { 10` 11}` 2113 and { 11` 21}` 2113 slips are the basic deformation systems, thus the operations of them make basal pole orientate along the normal direction of plate.

Zr-4合金板在a相高温区轧制时，{10`11}`2113和{11`21}`2113锥面滑移是主要的形变系统，所以轧制后形成基极取向集中于轧面法向的织构。

The workpiece is clamped on the rotating table, and the normal direction of the workpiece at a certain angle with the direction of polishing tool spindle by controlling the angle of precision swing table.

将工件固定在旋转工作台上，然后对摆台的角度进行控制，以此来确保研抛工具主轴方向和工件法线方向成一定角度。

And the motions in the normal direction and the tangent direction of the wheels were researched and the kinematic equations and the nonholonomic kinematic state space used in the acceleration control were obtained.

重点研究滚轮的法向和切向运动，建立了机器人运动学方程和无奇异性的非完整运动学状态空间。

The center of the circumcircle corresponding to the triangle formed by the three selected points is just the circle center of the compact, and the normal direction of the triangle plane determines the angle of the cutter teeth.

这3个测点构成1个三角形，三角形对应的外接圆圆心就是复合片圆心，三角形所在平面的法线方向决定了切削齿的角度。

The regularity of the residual _ stress changing along length and normal direction of interface derived model.

得到层内应力沿长度方向和界面法线方向分布的变化规律.

An algorithm of point in polygon testing based on normal direction is presented.

提出了基于法线方向的点包容检测算法.

Considerable residual stresses exist in the normal direction.

在其厚度方向存在着可观的残余应力.