outlet pressure

The compressor-outlet pressure is nearly constant around the circumference.

压气机出口压力沿圆周方向接近于常数.

Deicing fluid heating control system design mainly includes outlet temperature control, temperature, pressure, flow display and alarm.

除冰液的加热控制系统设计主要内容包括出口温度的控制，温度、压力、流量的显示和报警等。

There is relief function which discharges to atmosphere if outlet pressure is highter than setting pressure.

如果输出压力比设定压力高,那么排出大气来维持稳定的输出压力.

Dynamic matrix control of outlet temperature in constant pressure heating furnace

常压加热炉出口温度的动态矩阵控制

The outlet pressure of all those pumps were not lower than 0.1 Torr, and it follows that those pumps can run well by using directly the mechanical vacuum pumps as backing pumps without booster pump used.

所有这些泵的最大出口压力不低于0.1Torr，因此前级泵可直接用机械真空泵，不必用增压泵即能正常工作。

Gases move in a pipe or duct whenever the inlet pressure is higher than outlet pressure.

当进口端的压力高于出口端的压力时,气体就可以在管道内流动.

This paper describes the influences of such factors as axial speed, outlet pressure and media on the suction performance of three screw pump, and tells about the methods of and basis on how to decide cavitation point during test.

文章阐述了轴向速度、排出压力、介质等因素对三螺杆泵吸上性能的影响，并介绍了试验时判定发生汽蚀工况点的方法和依据。

From experimental readings, the dynamic changing regularity of water wall parameters and the response curve are confirmed under the disturbance of outlet pressure, heat load, inlet mass flow speed and inlet temperature. Sone theoretical analyses are given.

在出口压力、热负荷、进口质量流速和进口温度参数扰动下，确定水冷壁参数动态变化规律和响应曲线，并进行了理论分析。

Based on momentum conservation principle and conversation of energy, the calculating formulas for outlet pressure of throat, delivery pressure of gas lift jet pump and correlative size of diffusion channel are achieved.

根据喉管内流体动量守恒和扩散器内能量平衡原理导出喉道出口压力和加速泵排出压力的计算公式，并计算直接影响加速泵排出口压力的扩散器尺寸。

C-304 was improved by two ways: heat pump and different pressure. In the way of heat pump, the best operational condition was found by regulating outlet pressure of compressor and pressure-reducing value.

利用热泵和差压两种方式分别对C-304进行节能改进，热泵方式中，以压缩机和减压阀出口压力为主要调节变量，找到了最佳的操作条件，并比较两种热泵操作方式的优缺点。

Discussion on Variation of Outlet Pressure for Building Regulator

楼栋调压器出口压力波动的探讨

Low table by adjusting the outlet pressure control screw.

低压表的出口压力可由调节螺杆控制.

Experimental study on increasing outlet pressure of centrifugal air compressor

提高增压机出口压力的试验研究

Outlet pressure and flow are normally controlled by adjusting valve clearance and it causes considerable energy waste. Frequency control of motor speed is a method of solving the problem.

常规的通过调节阀门开启度来达到调节注水泵出口压力和流量的作法，会使很大一部分能量造成浪费，要解决这个问题，可以采取对注水泵进行调速的方法。

Research on Outlet Pressure Pulsation of Reverse Operation in Tubular Pump Model Experiment

贯流泵装置模型试验转轮出水口压力脉动研究

Variety results of water content and pressure were obtained under different outlet pressure.

分析了在不同出口压力下，管路中沿程含水量、沿程压力变化等规律。

Outlet pressure more steady and smoothly . For most kind of analysis instrument.

稳压效果突出,适合国内外各种分析仪器.

Find the number on the pressure difference line and note the outlet pressure index number.

找出压差线上的数字，并且注意出口压力指数。

Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure.

通过从最大进口压力减去所需要的出口压力来计算压差.

For examples, mass rate reduces as the wall temperature grows and heat transfer-outlet pressure ratio.

例如,对与同一压比条件下, 质量流量随着壁面温度的升高而降低.

Speed Rigidity Analysis to Hydaulic Circuit of Inlet Throttle Governing with Outlet Pressure

液压进口节流带背压的节流调速回路速度刚度分析

When outlet pressure is constant, increasing inlet pressure could enhance cavitation effect.

当出口压力一定时，升高入口压力可以增强空化效应；

According to measured data the variation of outlet pressure of building regulator is discussed.

根据实测数据探讨了楼栋调压器出口压力的波动情况.

An empirical formula of diameter d4 of abrasive waterjet nozzle to pump pressure P and uniform outlet velocity V_4 was established based on the design of structure parameters and performance test.

本文对射流喷头进行了结构参数设计和性能实验，得出了动力泵压力P与磨料水射流出口处均匀速度V4和磨料喷嘴直径d4的经验公式。