power-on reset

This paper discussed the specific design of each module of the power supply circuit, reset circuit, clock circuit, memory module, display module.

本论文详细讨论了各个模块的具体设计方案，包括电源电路、复位电路、时钟电路、存储模块、显示模块等，并在cadence环境下完成了原理图设计和PCB布线。

Audio and video input/ output circuit, Internet interface, power distributing system, system clock circuit, system boot configure circuit and reset circuit have been designed.

设计了音视频输入/输出电路、网络接口电路、电源分配系统、系统时钟网络、系统启动配置电路和复位电路等。

The hardware system includes power supply circuit, clock reset circuit, JTAG model building circuit, decoding circuit, memory interface circuit, man-machine interface circuit and numeric control constant-current source interface circuit.

硬件系统主要包括电源电路、时钟复位电路、JTAG仿真接口电路，译码电路、存储器接口电路、人机接口电路、ADC转换电路和数控恒流源接口等。

Aiming at the hardware system oneself request of security and stabilization, design the reset module, the power monitoring module, the serial EEPROM module.

针对硬件系统自身安全性和稳定的要求，设计了复位模块、电源监控模块、串行EEPROM模块。

Nucleus in a loaded dsp power or reset from the flash to load the application code.

一个加载核在dsp上 电或复位时从flash中加载应用程序源码.

Flash memory write error. Reset the power switch.

闪烁记忆写入错误, 关闭电源再重开.

A bandgap voltage comparator used as power-on reset and low voltage detect circuit is presented.

本文通过分析常规上电复位电路存在的问题,提出了一种基于带隙比较器的上电复位和欠压检测电路.

Under the equivalent martingale measure and the risk neutral pricing model, the pricing formulas of reset call options with power payoffs at the time of maturity was derived.

假设股票价格服从跳扩散过程，并且参数为时间函数的条件下，利用等价鞅测度变换方法得到了幂型支付的欧式期权的定价公式。

After power supply enter into shutdown, The power supply will rework after AC reset.

电源进入保护状态后, AC重置后电源才能重新正常工作.

With a power-on reset functions, namely, the DAC registers reset to all zeroes.

带有上电复位功能, 即把DAC寄存器复位至全零.

At first, we point out that in the embedded system the power-on reset ( POR) circuit of CPU and EPLD should not only satisfied the request of reset time but also offer correct time sequence to make POR step finished when initializing EPLD.

首先介绍了在嵌入式系统中，CPU和可编程芯片上电复位电路不仅要满足复位时间要求，而且还要有正确的时序，保证在对可编程芯片初始化时，该芯片上电复位已经结束。

The hardware circuit includes the aspects like collecting circuit, extended memory circuit, CPLD internal logic circuit, power supply and reset circuit.

系统的硬件电路包括图像采集电路、存储器扩展电路、CPLD内部逻辑电路、电源和复位电路等功能模块。

Press the power button and go to Reset

按下电源键，进入重置