pressure gear

Hydraulic pressure elevating gear: This organization uses the hydraulic pressure elevating mechanism realization complete machine fluctuation.

液压升降装置: 该机构采用液压升降机构实现整机升降.

Test and research on the CBZ 2 high pressure gear pump

CBZ2高压齿轮泵性能检测试验研究

At the same time, the external gear pump noise is comparatively greater. As main noise source of hydraulic pressure system, there is about seventy percent of vibration and noise that comes from gear pumps.

同时，外啮合齿轮泵的噪声比较大，作为液压系统主要的噪声源，大约的70%的振动和噪声起源于泵。

You can easily improve the MPG on any car by keeping tyres inflated to their manufacturer-specified pressure, employ steady acceleration and drive at a steady speed that requires fewer gear changes.

保持厂商指定的轮胎膨胀度，稳定加速，少用变速杆，用稳定的速度行驶都可以轻松提高MPG。

By analyzing the pressure distribution between gears and sealing blocks in compound gear pump with three idlers, the resultant hydraulic forces acting on seal blocks are obtained.

通过对具有3个惰轮的定轴轮系复合齿轮泵各齿轮齿顶圆与密封块间的压力分布规律的分析，求出各齿轮与密封块间的液压油对密封块产生的液压力合力。

Research for The Base Pressure in The Impulse Test for Gear Pump

齿轮泵冲击试验中基础压力的研究

This is largely separated into 3 sections-Gear Ratio Control, Acceleration Control, and Side Pressure Control.

这套装置大体上可分为3部分 —— 齿数比控制部分, 加速控制部分和副压力控制部分.

More pressure was realized with a little hydraulic force by orthogonal force amplifier, so the complex tape handler, gear driver and high capacity motor etc.

该设计以比较小的液压力通过正交增力机构增力，实现了得到很大冲压力的目的。

Several apparatuses for improving extrusion, such as gear pump, pressure fluctuation controller, die thickness regulator, etc., were introduced.

介绍了几种能够提高塑料挤出制品精度的技术与装置，其中包括齿轮泵、压力波动控制器、口模厚度自动调节装置等。

Single and multistage pressure gear pumps, hydraulic motors and valves for construction machinery , vehicle mounted machines.

供建筑机械和车载机械使用的单段和多段高压齿轮泵 、 液压马达和阀门.

Bevel gear actuators are recommended when pressure exceeds limits shown.

果压差超过所列的极限值,则建议采用锥齿轮执行器.

Aiming at the characteristics of structure and performance of pump body in high pressure gear pump, squeezing casting was employed to manufacture the pump body, and the optimized die structure parameters and processing parameters were provided.

针对高压齿轮泵前后泵体结构、性能要求等特点，研究了挤压铸造生产前后泵体的工艺过程，给出了最佳的模具结构参数和工艺参数。

No hydraulic pressure, emergency lowering of landing gear by manual gear extension procedure.

无液压，按手放起落架程序紧急放下起落架。