pressure-plotting model

In this dissertation, we set up a mathematical model of the atmospheric pressure glow discharge and deduce a group of equations.

本文首先建立了大气压辉光放电的数学模型，推导出一类非线性气体放电方程，并对这类方程进行了数值求解。

On methods for embedding pressure cell under model foundation brain box

模型基础下压力盒的埋设方法

Structural model test for surrounding concrete of steel spiral case keeping constant internal pressure

三峡水电站充水保压蜗壳三维仿真整体结构模型试验

This paper analyzes the coal mixed match, boiler combustion and sliding pressure operating of steam turbines, building the fuzzy math model of coal mixed match, boiler combustion advanced control model based on parameter prediction and steam turbine advanced operating model based on sliding pressure operation.

本文通过对燃煤掺配、锅炉燃烧、汽轮机滑压运行进行系统分析，建立了混煤掺配的模糊数学技术模型、基于参数预测的锅炉燃烧优化控制模型和基于滑压运行的汽轮机优化运行模型。

Measuring Stress in the Ground Pressure Model by the Strain Gauge

矿山地压相似材料模型应力测量的应变砖法

Then on the basis of the cylindrical tank hydrodynamic pressure formula, the ESD hydrodynamic pressure formula which may be helpful for the designing is presented by analyzing on the numerical hydrodynamic pressure results from ESD finite element model.

结合圆柱形消化池动水压力公式，通过不同地震作用下动水压力数值计算结果，给出了针对卵形消化池动水压力的计算公式，为工程人员的设计工作提供参考依据。

The experimental result shows that the normal pressure distribution on the surface of the model blade is a conicoid, the maximum of the normal pressure is in the middle of the model blade.

研究结果表明，法向压力在模型铲刀表面呈二次曲面分布，在模型铲刀的中部取得最大值。

A model for calculating the water impact of solid and fluid phases is established and used for comparing gas storge tank, pressure release valve and slowly closed back pressure valve, which further proves the function of the gas tank in reducing water impact pressure.

本文通过建立固液两相流水击计算模型对储气罐、泄压阀、缓闭逆止阀等进行了比较计算，进一步论述了储气罐减缓水击压力的作用。

We propose a DLA viscous fingering model based on pressure gradient. The model, which is called pressure-guided rule, combines geometric space and pressure gradient. We investigate the DLA walking problem of particles in pore space and simulate the viscous fingering development process.

提出了基于压力梯度的DLA指进模拟方法，通过定义几何空间和压力梯度结合的压力导向行走规则，研究了粒子在岩心孔隙空间的DLA行走问题，模拟了粘性指进的发展过程。

Lower to note the pressure of mold, reduce to model and protect to press time.

降低注塑压力，减少成型和保压时间。