primary wall

Original construction method of concrete ring wall of large scale storage tank often has some problems such as big deformation and spacing deviation of reinforcing steel bars, being difficult to control ring wall curvature and low primary formation rate.

以往大型储罐基础混凝土环墙施工极易存在钢筋变形大，间距偏差大，混凝土环墙曲率难以控制，一次成型率低等问题。

Cotton fiber cell wall is usually divided into two categories: the primary cell wall ( PCW) and the secondary cell wall ( SCW) during cotton fiber development.

在棉纤维发育过程中，纤维细胞壁发育通常可分为初生壁和次生壁两个阶段。

In China, the sectional thickness of primary component is restricted by "The Technical Criterion on Cold-formed Thin-wall Steel Structure".

我国现行《冷弯薄壁型钢结构技术规范》（GB50018-2002）对主要承重构件的截面厚度进行了限制，主要适用于仓库，厂房等公用建筑。

Choosing the positive criterion T/ NT ≥ 1.5, We were able to calculate the sensitivity of PRGS of the primary tumor, the specificity of colon wall tissue and excised edge, the sensitivity and specificity of lymph nodes.

以T/NT≥1.5为阳性标准，计算PRGS对原发肿瘤的探测敏感性和特异性、对系膜淋巴结转移的敏感性及特异性。

In the primary thickening process of the shoot bud wall, the contributions of each tissue were arranged from big to small as follows: vascular tissue ground tissue cortex+ epidermis.

在笋芽壁的增厚过程中，各组织的贡献率自大到小为：维管组织基本组织皮层+表皮，维管组织的分化发育是笋芽壁增厚的主要因素。

The results were as follows: 1. The first detectable degradation site of cell wall in middle cortical cell was primary wall, and then the intercellular space.

实验结果如下：1.透射电子显微镜观察发现小麦根中皮层细胞壁先由靠近细胞质的初生壁开始降解，然后是胞间层。

Investigation of heat transfer in outer tank wall during LNG storage tank primary container's leakage

LNG储罐主容器泄漏时外罐壁的传热特性

This initial layer, formed of both cellulosic and noncellulosic materials, is called the primary wall.

这头一层由纤维素和非纤维物质构成, 被称作初生壁.

Spalling cracks resulted from tension failure of concrete in wall joint and adjacent area are primary when the thin wall ( including the wall with visible wide beam) endured out-of-plane moment.

薄墙（包括墙上设有明梁的墙）受梁端施加的平面外弯矩时以墙上节点区与节点附近一定范围的混凝土受拉破坏形成剥离裂缝为主；

The article has studied the factors which influence liner property through the method orthogonal test finally. It has shown that wall thickness tolerance is the most primary factor affecting liner property, playing a decisive role in the armor-piercing penetration power.

本文最后通过正交试验的方法，研究了影响药型罩性能的因素中，壁厚差是影响药型罩性能最主要的因素，壁厚差大小对破甲侵彻威力具有决定性作用。

Methods 14 patients with ST-segment elevation myocardial infarction ( STEMI) within 12 hours had undergone primary PCI, 10 of whom had anterior anteroseptal wall infarction and 4 inferior wall infarction.

方法对14例急性ST段抬高心肌梗死（STEMI）患者在发病12h内行急诊PCI.其中急性前壁、急性前间壁心梗10例，急性下壁心梗4例。