processing conditions

In this article, we studied the processing techniques of the instant Jinggang red rice, and obtained the optimal production conditions by parameter selecting. The optimal conditions were: dipping temperature at 30 ℃; dipping for 60 min;

研究了井冈红米方便米饭的加工工艺，通过优化参数，得出最佳工艺条件：浸泡温度为30℃，时间为60min；红色（英文）

Under these optimal processing conditions, the chelating rate was0.6013, which was close to theoretical chelating rate of0.6135 with a relative error of1.99%.

在此条件下螯合率理论值为0.6135，实测值为0.6013，相对误差为1.99%，理论值测值与实测值之间拟合性好。

Studies of the processing conditions of glass fibre reinforced PEEK composites

玻璃纤维增强PEEK复合材料成型工艺研究

Study on Optimal Processing Conditions For Ginger Tea Production

姜汁茶生产工艺条件的研究

Under the conditions of containerless processing, Pb-4wt% Sn-12wt% Sb ternary eutectic alloys exhibit a transition from lamellasome structure to granular structure;

在落管无容器快速凝固条件下，Pb-4wt%Sn-12wt%Sb三元共晶合金组织形态由层片状转变为粒状；

In this paper, the characteristics of sponge rubber sealing strip by microwave curing continuously are introduced, as well as the design in the compound formula of sponge rubber sealing strip, the design in die sheet, and the determination in technological process and processing conditions.

介绍了微波连续硫化海绵密封条的特点，以及海绵密封条胶料配方的设计、口型设计、生产工艺路线和工艺条件的确定。

In addition, the processing conditions and technologies of dope dyeing method for the colored meta-aramid fibers produced were introduced in detail.

同时介绍了原液着色方法制备间位芳香族聚酰胺有色纤维的工艺与条件。

The aim of this article is to investigate technology for producing steamed sausage with fish and tofu, and the best processing conditions were obtained by experiments.

利用鱼和豆腐营养互补，对以豆腐和鱼肉为主要原料生产豆腐鱼肉肠的技术进行了研究，并通过正交实验确定了最佳工艺条件和配比。

SiC powders were treated by spray pelletization, and the influences of processing conditions and binder content on the crushing behavior of SiC granule during compaction were investigated.

采用压力喷雾造粒的方式对SiC粉体进行喷雾造粒处理，研究了喷雾造粒过程中工艺条件和浆料中粘合剂含量对成型过程中粉料颗粒破碎行为的影响。

The theory of parallel FDTD algorithm are introduced, and the method of region division and data exchange are further analyzed, then the parallel processing of absorbing boundary is well embedded into the general FDTD processing by selecting CPML boundary conditions.

系统介绍了并行FDTD的算法原理，对其中的区域分割和数据交换进行了深入分析，并通过采用CPML吸收边界，使吸收边界的并行化处理完全融入到FDTD的并行过程中。

PC foams were prepared by a foaming simulator at different processing conditions of foaming temperature, gas saturation pressure.

采用自制的微孔发泡模拟机研究了温度和压力以及气体饱和时间对微孔聚碳酸酯（PC）泡孔结构的影响。

Effect of processing conditions on the sensory quality of sand Artemisia noodles

工艺条件对沙蒿面条感官品质的影响

How the processing conditions affect the properties especially the drawability of a ferritic hot-rolled and annealed Ti-IF sheet steel was investigated.

研究了铁素体轧制工艺条件对一种Ti-IF钢的性能，特别是深冲性能的影响。

The result indicates that it is conducive to enhance the manganese recovery ratio by increasing the carbon content at the finishing-spot, decreasing the tapping temperature, FeO content in slag, roughing slag in tapping, properly controling tapping time under the current processing conditions.

结果表明，在现行生产工艺条件下，提高终点碳含量，降低出钢温度、渣中（%FeO）含量和出钢下渣量，合理控制出钢流钢时间，有利于提高Mn元素的回收率。

The major factors affecting the scale of processing factory of agricultural products are resource conditions, information of demand and supply, the conditions of transportation, fund, technology, management and administration etc.

影响农产品加工厂规模的主要因素有资源条件、需求情况、运输条件、资金条件、技术条件、经营管理等。

The paper introduces the test method and measurement technique of submarine explosion with single spherical charge, including test conditions, test design, test system, shock profile analysis, test data processing and statistical comparison.

介绍了单个球形装药海底裸爆试验方法及测试技术，包括试验条件、试验设计、试验测试、波形分析及试验数据统计处理等；

The paper put foward the basic principle, technological process and conditions that product the tetrabromoethane, light magnesium oxide and ammonium chloride taking the waste residue from processing the maltol& the basic magnesium bromide as raw material. The production cost was estimated.

提出了以麦芽酚生产中的废渣&碱式溴化镁为主要原料，生产四溴乙烷，轻质氧化镁和氯化铵的基本原理、工艺过程和主要工艺条件，并估算了成本。

The selection of golden powder, binder and thickener of gold print for T/ C and all cotton fabrics as well as the effect of processing conditions and operations on print result are studied.

以涤棉和纯棉织物作为试验材料，探讨了金粉印花的金粉、粘合剂、糊料的筛选，以及工艺条件、操作对金粉印制效果的影响。

In this paper, the square-error analysis and cross-test are used to determine the optimal processing conditions of inner electrolytical decolorization of printing and dyeing waste liquid.

通过正交试验，利用方差分析来确定内电解法对印染废水脱色的最佳工艺条件。

The optimum processing conditions were ageing time 24 h;

最佳工艺条件为老化时间24h；

Study of the effects of the TPF resin and the processing conditions on the strengthening of wet-process hardboard

TPF树脂增强处理湿法硬质纤维板影响增强效果合理工艺条件的研究

By adjusting the screw speed of the twin-screw extruder, temperatures of different heating stages, the optimal processing conditions for grafting reactions are determined.

通过调整双螺杆挤出机的螺杆转速、不同加热段的温度，确定了接枝反应的最佳工艺条件。

Therefore , good processing conditions for manufacturing microcellular plastics are discussed by experiments.

并通过部分实验加以讨论, 提出了挤出制备微孔泡沫塑料的较佳工艺条件.

Two processing method of extracting RNA from brewing yeast was studied, that is high concentration saline method& ammonia analyzation method, the latter was studied mainly. the best processing conditions were both obtained, then the two method were compared.

研究了从啤酒酵母中提取RNA的两种方法，即浓盐法和氨解法，并主要对氨解法进行了研究，分别得出了最佳工艺条件，同时对两种方法进行了比较。

By contrast, rules are only executed when the conditions for that rule are exactly matched as a result of other system processing ( for example, applying payment against an outstanding balance).

与之相对，只有在其他系统处理（例如，为未清偿余款提供支付）导致准确匹配相应规则的条件时，该规则才会执行。

The rheological and extrusion contrast tests on PVC resins were made by using RM-200 intelligent torque rheometer and used plastic extruder used in small experiments, and the properties of processing products and processing process conditions were analyzed.

采用RM-200智能转矩流变仪和小型实验用塑料挤出机进行PVC树脂流变及挤出对比试验，并分析了制品的性能及加工工艺条件。

Influence of the related processing conditions on the structure and optical properties of high refractive index titanium oxide thin films deposited by reactive electron beam evaporation ( EB) on K9 glass is discussed.

研究了工艺条件对电子束蒸发沉积在K9玻璃上TiO2薄膜的结构和光学性能的影响。

The technology flow and processing conditions of soft-can razor clam product were discussed in this paper.

探讨了蛏子软罐头的工艺流程及工艺条件，研究了关键工艺的条件参数。

The aim of this article is to explore the relationship between processing conditions, structures and the properties of isotactic polypropylene ( i-PP) prepared via a new processing methodology of iso-channel angular extrusion ( ICAE).

采用等通道转角挤出方法对等规聚丙烯进行自增强挤出，研究和分析挤出工艺条件与材料结构、性能之间的关系。

Effect of processing conditions on polyester blended air-textured yarn

加工工艺条件对聚酯混纺空气变形纱的影响