pull-out test

Numerical Analysis for Bolt Pull-out Test

公路边坡中锚杆抗拔试验的数值分析

This paper studied the influence of the different conductor material such as AU| Pd-Au, the different film thickness. 125 ℃. 300 ℃ thermal aging and temperature cycle on bond strength with two methods of destructive wire bond pull test and bond contact resistance test.

本文使用焊点破坏性拉力试验和焊点的接触电阻测试两种方法，研究了导体材料（Au、Pd&Au）、膜层厚度、125℃、300℃热老练和温度循环对焊点键合强度的影响。

Micromechanical analysis of single-fiber pull-out test of fiber-reinforced elastomer matrix composites

纤维增强弹性体基复合材料单纤维拔出试验细观力学分析

Study of on-line Photogrammetry System for the Measurement of Extending Rate in Draw-and-pull Test of Reinforcing Steel Bar

钢筋拉伸实时摄影测量方法的研究

Rutting test is one kind of test method in measuring pavement materials pull pressure.

其中车辙试验就是测量路面材料拉压力学的一种试验方法。

Pull thrust test is a destructive bond pull test, so only selected groups of solder joints are measured and can not cover all of the solder joints.

由于拉推力检测是破坏性检测，只能对部分焊点进行抽检而无法进行全检。

Dry spray which is removed when subjected to the specified tape pull test is not acceptable.

在规定拉带测试中会被抹去的干燥喷漆物不可接受.

Load-pull test of motor wheel truck is important for pull performance examination and service quality security.

电动轮自卸车的负载拉功试验是检验其牵引性能、保证使用质量的重要手段.

Interface Study of Smart Composite Material with Optical Fiber by Single-Fiber Pull-Out Test

单丝拔出法在光纤智能复合材料界面研究中的应用

The credibility and precision of the model are validated by systematical comparison and analysis on an in situ rock bolt pull-out test between the simulation results and field measures.

通过一个岩层锚杆拉拔试验的现场测试和数值模拟的对比分析，验证了数值模型的可靠性和精度；

The Development of Intelligent Pull Test System for Anchor Bolt

智能型锚杆拉力测试系统的研制

Dry coating which is removed when subjected to the specified tape pull test is not acceptable.

在规定转带测试中会被抹去的干膜不可接受.

And for a quick quality check, do the "pull test."

迅速检查质量，做“拉力测试”

Formerly concrete pressure resistant test and steel reinforcing pull resistant test were done by the omnipotence tester. By the reading of the dial plate, the data is calculated artificially and the curve is protracted, operation is complex, artificial factor is mighty.

过去，混凝土抗压强度试验、钢筋抗拉强度试验是在万能试验机上完成，通过表盘读数，人工计算数据及绘制曲线，操作繁琐，人为影响大。

According to the analysis on the stress status of bolt during pull-out test accompanied with the field measured curves of stress distribution of the bolt, the calculation method of anchoring strength of bolting is given based on rock properties and anchoring style.

本文从拉拔时锚杆受力分析入手，结合锚杆实测应力分布曲线，给出了基于岩性和锚固方式的锚杆支护强度的估算法。