roll-up structure

As one of the key equipment of large-sized compound fertilizer plant, the technological parameters of three-roll mill and its structure are described, some typical troubles and their countermeasures are presented.

介绍大型复合肥生产装置中的关键设备之一&三辊破碎机的技术参数和结构，运行中常见的典型故障及分析，对处理方法进行了归纳、总结。

Tension Calculation Model and Setting During FGC Process in Cold Strip Rolling Design of the main structure parameters of tension roll assembly in cold mills CAL

冷连轧动态变规格张力计算模型及设定研究冷轧连续退火机组中张力辊组主要参数的设计

Connection Mechanism of Bimetallic Centrifugal Cast Roll with Three-layer Structure

双金属离心铸造碾辊的复合机理研究

A model tracing variable structure control methodology based on nonsingular terminal mode for second-order uncertain systems is proposed. Using this method, BTT roll channel autopilot is designed.

进一步提出基于非奇异终端滑模的二阶不确定系统的模型跟踪变结构控制方案，并将其应用于BTT导弹滚转通道的自动驾驶仪设计。

A new oversea structure design of work roll driving spindle sleeve of cold steel and strip mill is introduced, which gives the most driving forgue when the work roll diameter is small.

介绍一种国外冷轧板带轧机工作辊传动轴轴套的新结构，在采用较小的工作辊直径时，新结构所选用的传动轴扭矩达到最大。

In view of problems of roll ring structure and connecting with shaft of carbide composite roll used in bar mill, the structure, material, installation and design characteristics of three kinds of carbide composite roll which were successfully used in abroad were introduced

针对棒材轧机应用硬质合金轧辊时，辊环结构及辊环与轧辊轴连接方式存在的问题，介绍了国外3种获成功应用的硬质合金组合轧辊的结构、使用材质、安装和设计特点

Based on the analysis to the failure of the CC roll, a composite CC roll with the spiral water cooling form and the prestressed structure was developed by a new material suitable to the CC working condition.

在分析连铸辊破坏原因的基础上，提出了适用于连铸辊工作条件的新材质，试制出了带有预应力结构和螺旋水冷结构的复合连铸辊。

On Design of Variable Structure Terminal Sliding Mode Control System for Roll Channel of BTT Missile

BTT导弹滚动通道变结构最终滑态控制系统设计

The groove system, roll structure, guide structure, rolling control and rolling requirements for 4-line slitting rolling technology provided by BSW Co. are introduced in detail in this paper. In addition, the prospect of this technology is also discussed.

详细介绍BSW公司的4线切分轧制的孔型系统、轧辊结构、导卫结构、轧制控制以及对轧机的要求，展望了该技术的发展空间。

The roll-over bars of hot-formed steel tubing are bolted into this structure.

铺设超过酒吧的热点形成钢油管是螺栓到这个结构.