rolling load

The practical results of rolling 7 angle steel sLow that using open slitting pass rolling angle steel make stick flat, increase the production 5% on one pass and decrease the motor load.

通过轧制7角钢的实践，得出采用开口切分孔轧制角钢不仅使轧件平直，而且可提高单槽轧出量5%，且减轻了主电机负荷。

Taking into account the rolling load is uneven, to balance electrical loads and reduce the electrical capacity slowdown in the increase between a flywheel and electric motors.

考虑到轧制负荷很不均匀，为了均衡电机负荷，减少电机的容量，在减速机和电动机之间加有飞轮。

Thickness Target Function Method for Load Distribution During Hot Strip Rolling

热轧带钢负荷分配目标厚度函数法

Studying equivalent dynamic load of four-row tapered roller bearing in rolling mills

轧机四列圆锥滚子轴承当量动载荷的研究

The results show that speed and vertical load have an important influence on tire rolling resistance. Tire rolling resistance increase with speed and vertical load.

结果表明行驶速度和垂直载荷对轮胎滚动阻力的影响较大，轮胎滚动阻力随行驶速度和垂直载荷的增大而增大。

The influence of five parameters which include speed, inflation pressure, vertical load, crown compound elastic modulus and belt angle to tire steady state rolling resistance was mainly studied.

着重研究了轮胎行驶速度、充气压力、垂直载荷、胎冠胶弹性模量、带束层帘线角度五个参数对轮胎稳态滚动阻力的影响。

In the selection of rolling bearing's types and models, some selected bearings can not be applied to the actual working environment, suffered the impact load in excess of the allowable load.

在滚动轴承类型和型号的选择过程中，会经常出现所选用的轴承不能适用于实际的工作环境，其所受的冲击载荷超出了该轴承的许用载荷。

A technique to prevent this is load shedding by rolling blackout or voltage reduction brownout.

一种技术,以防止这种情况是由轧制负荷减少停电或电压(掉电)脱落.

The influence of recrystallization softening on hot rolling load and the quantitative calculation

再结晶软化程度对热轧力能的影响及定量化计算

The microstructure and properties of high manganese steel under the conditions of different rolling load were analyzed and studied through the OM, TEM and HD-187.5 sclerometer.

利用光学显微镜、透射电子显微镜和HD-187.5型硬度计对高锰钢在不同轧制应力条件下的组织和性能进行了分析和研究。

Application of Load Observer Control Disturbance of Rolling

负荷观测器在抑制轧钢扰动中的应用

Results show that frictional coefficient can reflect that the rolling oils of stainless steel have elastohydrodynamic lubricating property, and fail test load should be more than 981 N. grade.

结果表明摩擦因数能够反映出不锈钢轧制油具有弹性流体润滑特性，失效级负荷应大于981N；

Three Dimensional FE Analysis of Load Bearing Tire in Contact Area under Rolling Condition

负重轮实心橡胶轮胎滚动状态下接触三维有限元分析