series-parallel circuit

In a practical circuit, the series APF can compensate a high capacity voltage harmonic source load or several low capacity voltage harmonic source loads.

在实际应用中，串联型APF既能对单个大容量电压型谐波源负载进行补偿，也能对多个小容量电压型谐波源负载进行集中补偿。

Have a fixed attenuator series, short-circuit plug seat series, gold-plated jack series, pin series, test block series, EQ shell series accessories.

有固定衰减器系列，短路插头座系列，镀金插孔系列，插针系列，测试座系列，均衡器外壳系列等配件。

MF 51 Series, MF 91-MF 96 series NTC thermistor for temperature below 300 ℃ and the temperature control circuit.

MF51系列 、 MF91-MF96系列的NTC热 敏电阻器适用于300℃以下的测温与控温电路.

This paper describes a light, temperature and speed adjusting DDC system which is composed of MCS-48 series computer, sample-and-hold circuit. In this DDC system PID algorithm is used as the controlling algorithm.

本文主要介绍用mcs-48系列单片机，配以采样保持、A/D、D/A转换和模拟输出驱动板，并采用PID算法进行调节，构成直接数字控制DDC调光、调温、调速系统。

Based on the use of merging zone circuit and simulating a series of standard solution of uranium in organic phase, uranium in unknown organic phase sample was determined by flow injection spectrophotometry.

使用流动注射分光光度法，以合并带流路模拟有机相铀标准系列溶液，从而求出未知有机相样品的铀含量。

Circuit 11, series-parallel circuit ( no sliding rheostat ).

电路11, 串并联电路图 ( 无滑动变阻器 ).

Because CMOS circuit, steady current circuit, series-wound LED and self-recover fuse are adopted, the flash alarm has many good qualities such as low power consumption, high reliability and small volume.

由于采用CMOS电路、恒流电路、串联LED、自恢复保险丝等技术，使得该闪光报警器具有功耗低、可靠性高、体积小等优点。

The thesis offers APD signal amplify circuit chart and controlling time-series logic circuit principle chart bearingvalue.

给出了APD信号放大电路和控制时序逻辑电路原理图.

The series circuit is a circuit where the current is not divided at any point.

串联电路是在任何点上不再分开的电路.

Study of Protective Relay on Series Capacitor Compensated Lines& Study of Protective Relay and Reclosure on Double-circuit Lines on the Same Pole

串补线路继电保护的研究与同杆双回线继电保护及重合闸的研究静止无功发生器与晶闸管投切电容器协同运行混合无功补偿系统

OP07 series of operational amplifer is recommended; the fixed temperature coefficient of resistance in the circuit must be over50PPM.

运算放大器推荐使用OP07系列，电路中的固定电阻温度系数要求优于50PPM；