shear coefficient

A method to estimate the temperature coefficient for shear modulus

一种计算剪切模量温度系数的方法

Dissipated energy due to axial plastic deformation is proportional to that of lateral plastic deformation and the proportional coefficient is dependent on inclination angle of shear band.

轴向塑性变形消耗的能量与侧向塑性变形消耗的能量成正比，其比例系数与剪切带倾角有关；

The influences of casing length, casing thickness, frictional coefficient and interference value on contact pressure, frictional shear traction are analyzed.

通过分布加载和改变相关参数的方法，分析套管长度、套管厚度、摩擦因数以及过盈量对接触压力、摩擦剪切力等影响规律。

The distributions of temperature, stress, strain, strain rate, displacement and viscous damping coefficient within ductile shear zone at different time intervals are distinguished in the cases of accelerating creep age and strain softening.

并对加速蠕变和应变软化两种情况，给出了不同时刻韧性剪切带内的温度、应力、应变、应变率、位移和粘滞系数的分布特征，描述了岩石递进变形的规律。

The results indicated: Shear stress, tensile stress and springiness may be employed to assess the texture quality of noodles which have big width coefficient of variation and relatively small thickness coefficient of variation.

结果表明，在面条宽度变异系数较大、厚度变异系数相对较小的情况下，剪切应力、拉断应力和弹性，可用于面条质构品质的评价；

Wax deposition of Xinjiang crude oil is investigated on a test loop and the following conclusion can be derived: the deposit coefficient decreases as the shear stress at the pipe wall increases incurred by the change of the temperature or velocity of tile flow.

通过对新疆的几种油样进行试验研究，结果表明，当温度或流速发生变化从而引起管壁剪切应力变化时，沉积系数随着管壁剪切应力的增大而减小。

Series solutions were derived for the in-plane strain, deflection and bending strain that satisfy the simplified boundary conditions to calculate the shear lag coefficient.

根据简化的边界条件，得到了面内应变和弯曲应变的级数解，进而求得剪力滞后系数。

Besides, the effect of diffusion coefficient on interlaminar shear stength of composites is investigated.

此外, 还研究了扩散系数对芳纶纤维复合材料的层间剪切强度的影响.

Aiming at anti-slide performance and anti-seepage performance in pavement performance we measured the texture depth and water permeability coefficient. Finally, we researched on interlaminar shear strength between the micro surfacing and pavement using the determined gradation and the optimum emulsified asphalt content.

路用性能测试主要针对抗滑性能和防渗水性能进行了构造深度和渗水系数的测定。最后，采用确定的级配和最佳改性乳化沥青用量，研究微表处与原路面的层间剪切性能。

And the formula for angle of shear plane is modified by chip shortening coefficient.

并通过切屑变形系数来修正模型中的剪切角计算公式。