shear distribution

Patterns of shear stress may contribute to the focal distribution atherosclerotic lesions.

研究发现,血液流动力的形式与动脉粥样硬化的发生发展有密切的关系.

The structural analysis of the anchor rod is carried out with analytic approach and the shear stress distribution of the interface of the anchor-section of tensioned and compressed anchor rod under elastic stage is given.

用数值分析的解析法对锚杆进行结构分析，得出了拉力型锚杆和压力型锚杆锚固段界面弹性状态下的剪应力分布规律。

The software ANSYS and MATLAB were employed to analyze and simulate the velocity, pressure, shear stress and viscosity distribution in fishtail sheet extruder die based on the three-dimen-sional FEM.

本文利用ANSYS和MATLAB软件，对鱼尾型片材机头中熔体的速度、压力、剪切应力和粘度的分布进行三维有限元模拟和分析。

The results show, after two passes through route B_A and B_C, the sample strain distribution turns to be inhomogeneous, and shear deformation mainly concentrates on cross position of two passes shear surface.

研究结果表明，采用路径B A、B C两道次挤压后，试样横截面内部的应变分布不均匀，剪切变形主要集中于两道次的剪切面的交叉处。

The distribution of storey shearing force in frame-shear wall structure is discussed.

讨论了框剪结构在弹性和弹塑性工作状态下楼层剪力的分配机理.

UNBALANCE SHEAR FORCE DISTRIBUTION CALCULATION OF BRAKE CHAMBER OF ABOIDEAU WHICH WAS CONVERTED INTO TRAPEZOIDAL CROSS-SECTION Discussion on calculation of unbalanced cutting power distribution in the design of sluice bottom board structure

水闸闸室化算梯形横截面上不平衡剪力的分配计算闸底板结构设计中不平衡剪力分配计算问题的探讨

Moment and shear geometric sequence method is based on moment and shear distribution method.

本文所介绍的弯矩剪力等比数列收敛法是以弯矩剪力分配法为基础，通过采用适当的弯矩、剪力的传递方式。

Firstly, this paper does theoretical research when tension acts on the bolt tip, and derives the distribution law of the bolt shear stress and axial force, and defines three different bolt stress state.

首先，本文对锚杆端部受拉力时做了理论研究，推导出锚杆剪应力与轴力的分布规律，并定义了锚杆三种不同的受力状态。

The stress distribution is studied under different serosity pressure. ( 7) The normal stresss and shear stresss at any section are studied.

研究了不同注浆压力对土体应力分稚的影响：（7）研究了注浆过程中土体中任一截面处正应力与剪应力的对比关系。

The software ANSYS is used to calculate the stress of the shear connectors, getting the ultimate bearing capacity of the shear studs and load slip curve, and analyze the stress distribution characteristics of shear studs in concrete which is in the compressive state.

利用大型通用有限元计算软件ANSYS对该剪力连接件进行了加载计算，得到了剪力钉的极限承载力和荷载滑移曲线，分析了混凝土受压状态下的剪力钉应力分布特征。

Wall shear stress and pressure distribution of spiral flow in pressure crevice

压力缝隙螺旋流边壁切应力及压力分布

In academic analysis of lateral shear distribution in anchoring systems, the slippage and its softening effect ought to be taken account.

在锚固的理论分析中，应对界面滑移及软化因素对侧阻力分布的影响予以足够重视。