shear of

The drum flying shear of AISC Hot Strip Rolling Mill Plant has been introduced from Germany.

鞍钢热轧带钢厂的鼓式飞剪是从德国引进的.

The product of vertical wind profile ( VWP) which based on VAD methods are introduced detailedly. This product is useful to ascertain the type of thermal advection, the shear of vertical wind, etc.

详细介绍了基于VAD技术的垂直风廓线产品（VWP）的应用技术，此产品对确定热力平流类型、垂直风切变等都是有用的。

According to relative calculation formula and structural requirement, a series A-ρ sv formula of skew-sec-tion shear of the flexural member is derived.

结合有关的计算公式及构造要求，推导出一组受弯构件斜截面受剪箍筋计算的A&ρsv公式。

The failure modes by shear of recycled aggregate concrete beams without stirrups are similar to the natural aggregate concrete beams without stirrups. Three failure types of recycled aggregate concrete beams are diagonal tension 、 shear-compression and diagonal compression.

再生混凝土无腹筋梁的破坏形式与普通混凝土无腹筋梁的破坏形式并无本质区别，仍然是斜拉破坏、剪压破坏、斜压破坏三种破坏形态。

The shear of woven fabrics results largely in the alteration in the angle between warp and weft yarn.

机织物的剪切作用，大部分由经纱和纬纱之间角度的改变所形成。

Using the Fujian theatre and Daqing theatre as examples, it is concluded that the frame shear-wall structure is adopted, and the relative floor distribution should base on the different function of the rooms.

以福建大剧院和大庆大剧院为例，总结出大剧院的抗侧力体系应选择框架-剪力墙结构，不同使用功能的空间应采用不同的楼板布置方法。

New Methods on the Determination of Martensitic Transformation Shear Angle and Lattice Parameters;

马氏体相变切变角和点阵常数测定的新方法◆剪切角可调，减少板料扭曲变形。

The software ANSYS is used to calculate the stress of the shear connectors, getting the ultimate bearing capacity of the shear studs and load slip curve, and analyze the stress distribution characteristics of shear studs in concrete which is in the compressive state.

利用大型通用有限元计算软件ANSYS对该剪力连接件进行了加载计算，得到了剪力钉的极限承载力和荷载滑移曲线，分析了混凝土受压状态下的剪力钉应力分布特征。

The thickness of slab is determined by punching shear capacity. Punching Shear of Concrete Slabs With Shear Rein force ment

其厚度一般是由冲切条件控制的。配抗剪钢筋混凝土板的冲切

A modified formula for the modulus of elasticity in shear of the composite materials

复合材料剪切弹性模量G（23）的修正公式

The shear strengths of slip soils is the stress of the test study, which involves peak shear strength ( fully softened shear strength) and residual shear strength.

其中，滑带土的强度特性是本次研究重点，包括峰值强度（完全软化强度）和残余强度。

The storey element, which can model one storey of the frame-shear wall structure is fabricated. Based on SRSS method, the frame-shear wall structure with shear wall interruption at different heights is analyzed. The conditions of interruptable shear wall height are established.

构造能模拟一层框剪结构的层单元，用振型分解反应谱法分析不同高度和结构刚度特征值的断层剪力墙框剪结构的地震反应，设定可中断剪力墙高度的条件。

Making use of the test features of ring shear apparatus, the change law of shear strength of soils under large shear displacement can be studied.

利用环剪仪的试验特点，可以研究土体在较大剪切位移下抗剪强度的变化规律。

Pseudo Dynamic Test and Static Elastic-Plastic Finite Element Analysis of Reinforced Concrete Frame-Shear Wall Structure

框架&剪力墙结构拟动力试验与弹塑性有限元分析

Analysis shows that as long as the sliding devices and displacement restriction and energy absorption devices are selected properly, the base shear of the system may be controlled not to exceed a certain level by the designer.

分析表明，只要合理地选用隔震元件及限位消能元件，体系的基底剪力完全可以由设计者控制在某一个水准。

Electric Control System of Automatic Selected Length Shear of Plastic Detonating Booster

塑料导爆管定长自动剪切电气控制系统

~ ( 40) Ar/~ ( 39) Ar Geochronology of the Qiugemingtashi& Huangshan Ductile Shear Zone in East Tianshan, Xinjiang, NW China

新疆东天山秋格明塔什&黄山韧性剪切带~（40）Ar/~（39）Ar年代学研究

Based on gradient-dependent plasticity where an internal length parameter is included to consider the microstructural effect, the distributions of shear deformation, shear strain and temperature in adiabatic shear band were derived considering the slow and sharp decrease of load-carrying capacity beyond the peak shear stress.

采用梯度塑性理论，考虑了峰值剪切应力之后的材料承载能力缓慢降低的过程及承载能力快速降低的过程，推导了剪切带内部的剪切变形、应变及温度分布的公式。

Failure Analysis and Improvement Measures for Multiple Flying Shear of Unit 260

260机组倍尺飞剪故障分析及改进措施

Experimental Study on Heat Transfer Characteristics of Thermal Syphon under Different Natural Working Fluid; Effect Mechanism of Fibre Orientation on the Adiabatic Shear of as-Extruded WHA

CPU重力热管使用不同天然工质时的传热特性实验研究热挤压钨重合金纤维方向对绝热剪切特性的影响规律及机理研究

After deboned, the faceplates occurred the permanent bending deformation and elastic buckling in the vertical main direction of compression load, and the foam core happened the shear failure and permanent plastic deformation.

上下面板和泡沫夹芯脱胶分离后，面板主要垂直于压缩载荷的方向发生弹性屈曲和永久的弯曲变形，泡沫夹芯在冲击损伤的附近发生剪切失效和永久的塑性变形。

The Relationship between the Weather in an Easterly Wave and the Vertical Shear of Basic Air Flow

东风波天气区域分布与基本气流垂直切变的关系

Secondly, under the shear of whipping, two fat globules crush into each other and the MFGM between them is punctured by fat crystals, the liquid fat flows and wets crystals making two fat globules melded.

搅打剪切作用下，两个相邻脂肪球相互碰撞，晶体脂肪刺破两脂肪球之间的脂肪球膜，液体脂肪润湿结晶脂肪并且发生流动，将两个脂肪球连接在一起；