side joint

The models of arthrodial cartilage defects were made in the 32 joints of 8 swine with 3 defects in each joint, and one side of the joint served as the control.

然后对8只小型猪的32个关节进行动物关节缺损的模型建立，每个关节共造3个人工缺损，选择关节左右随机对照。

The metallographic examination of joint in different welding temperature proves that the joint metal on the side of high-speed steel has a gentle structure slope at the800 ℃.

通过对不同温度接头的金相检验证明：在800℃时高速钢一侧组织梯度较小；

The symptoms of morning stiffness ( MS), joint pain ( JP) and articular swelling ( AS), erythrocyte sedimentation rate ( ESR) and C-reactive protein ( CRP) and side effects were observed before and after treatment.

观察治疗前后患者的晨僵、关节疼痛数、关节肿胀数、血沉（ESR）、C反应蛋白（CRP）等指标及副反应。

Experts said the thaw in the situation is a result of joint efforts by ZTE and the Chinese government to pressure the US side, which could serve as an example for Chinese companies in future trade disputes in a foreign market.

专家表示美国态度的放缓来源于中兴集团和中国政府对美国实施的压力，这件事也为以后中国企业处理国际贸易争端树立了榜样。

Only the CV joint at the transmission side is available upon request.

只能申请获得变速箱一侧的等速万向节。

Remove CV joint on transmission side.

拆下变速器侧的等速万向节。

The inner side surface of the ball sleeve is contained outside the joint head in an insulating way to form a cardan joint.

球套内侧面吻合包含于关节球面之外，形成万向节。

China attaches importance to the U.S.side's reiteration of its commitment to adhering to the one-China policy and abiding by the three joint communiques.

我们重视美方多次重申坚持一个中国政策、遵守中美三个联合公报。

The pattern of side bend of Mn Si multi layer weld is investigated with side bend test of weld joint, optical microscope and scanning electron microscope analysis. The relationship between weld thermal cycle, heat input and microstructure with pattern of side bend is also discussed.

本文通过焊接接头侧弯试验、光学显微镜和扫描电镜分析，对Mn－Si系多层焊焊缝侧弯形貌进行了研究，探讨了侧弯形貌与焊接热循环、焊接线能量及显微组织之间的关系。

One bare steel joint and two cruciform composite joint specimens were tested under low cyclic loading at the top of columns so that one side of the beam-to-column connections was under negative moment and the other side under positive moment.

进行了一个纯钢节点、两个组合节点的低周反复荷载试验。采用柱顶水平加载模式，连接的一侧承受负弯矩，而另一侧承受正弯矩。