single converter

Fully Digital Controlled Single-Stage Isolated PFC Converter based on Full Bridge Structure

基于全桥结构全数字控制单级隔离PFC变换器

Digitally controlled single-stage isolated power factor correction AC/ dc converter

数字控制单级隔离型功率因数校正AC／DC变换器

Design for Single-stage Matrix Converter Based on DSP and CPLD

基于DSP和CPLD的单级矩阵变换器设计

Investigation on an Interleaved Discontinuous-Current-Mode Single-Stage Power-Factor-Correction Converter; The Study of CM EMI Suppression in Forward Converter Based on Passive Compensation Technique

一种交错并联断续模式单级PFC变换器的研究基于补偿原理的正激式变换器传导共模EMI抑制

However, Due to the limitations of the single-stage converter, when the bus voltage is high and wide input voltage range, the single-stage converter is not suitable for multi-output low power switching power supply.

但是由于单级变换器自身的局限性，当电源母线电压宽输入范围时，单级变换器并不适合用作多路输出小功率开关电源的主功率拓扑。

Application of Duality Principle in Design of Single-stage PFC Converter

应用对偶方法设计单级PFC变换器

The theory of conduction monitoring based upon single converter excitation system, namely the ripple monitoring theory is analyzed, the rationality of this principle and the advantage to solve the fault of converter are given, while the deficiency of this function is pointed out.

分析了单桥运行励磁系统的可控硅导通监视原理，即纹波检测原理；给出了其原理上的合理性以及其在处理整流桥故障上的优点；

Chapter four proposes a novel single-stage forward PFC converter.

第四章提出一种新型单级PFC变换器，采用变压器绕组以负反馈的方式抑制储能电容电压。

To ensure the AC/ DC transfer error caused by thermal converter to be less than 20 ppm, there are some special and tight needs for thermal converter in AC power measurement with single time.

为了保证在单次功率测量时由热电变换器引起的交、直流转换误差小于20ppm，对热电变换器提出一系列的特殊要求。

It consists of two basic units. The first unit is boost-type single-stage PFC converter, the second unit is soft-switching technology flyback converter.

该开关恒流源主要分为两个基本单元，前一单元为Boost型单级PFC变换器，后一单元为反激式软开关变换器。