site engineering

As observed in the engineering construction site, the slide has been effectively stopped.

经施工现场观测, 滑体位移已渐止.

The fault fissure is very common in the engineering site and it is necessary to understand the ground motion of the site with ground fissure.

断裂缝在工程场地十分常见，研究其对场地地震动的影响很有必要。

Rock mass energy release in engineering site investigation and their engineering significance

工程勘察中的岩体能量释放及其工程意义

Special Problems on Evaluation of Seismic Safety for Offshore Engineering Site

海域工程场地地震安全性评价的特殊问题

While the upper limit of time of last faulting is 90 ka along the F9. The dam area is a relatively stable area in modern tectonic activity and is a perfect engineering site.

F9断层最后一次较强烈活动的上限时间为距今9万年左右。结果表明，电站坝区是地壳活动相对较稳定的、较好的场点。

Based on the requirement of Work norms for engineering quality supervision and Technical standard for test of building structure, this paper elaborated the relative items proceed the test of structural body on site during quality supervision, provided a basis for spreading the work fluently.

本文根据《工程质量监督工作导则》的要求，结合《建筑结构检测技术标准》，阐述了在质量监督中如何开展现场实体检测工作的有关事项，为该项工作的顺利推广提供了可靠依据。

The CPT method is used in the site testing of liquid soft ground and based on site CPT testing results, the engineering properties of liquid soft ground are analyzed.

利用CPT测试方法对流塑状软土地基进行测试，并根据测试结果对地基土的各项物理力学指标进行分析，据此考察CPT测试方法在流塑状软土地基上应用的实用性与可靠性。

However, due to having on-site spares and on-site network engineering team we have been able to keep this situation from escalating further.

然而，由于有现场备件和现场网络工程团队，我们已经能够防止这种情况进一步升级。

In practical engineering, it is often needed to know the equivalent mechanical parameters of the rock mass, it is usually unrealistic to test the rock mass properties by on-site measurements.

在实际工程中往往需要知道岩体力学参数，而通过现场的大尺度岩体试验来取得这一参数往往存在困难。

Based on site investigation, this paper probes into the technical classification, main engineering characteristics, and construction technology for cemented pebbles, and recommends the construction technology of "dredging after loosening".

通过实地试验，对胶结卵石技术分类、主要工程特性、施工工艺等进行了分析研究。提出先采用机械冲击松动后用挖船清渣的先松后挖法的施工工艺。