sliding load

Moreover, the applied load and sliding cycles directly determine the wear property of the Si ( 100).

此外，外加载荷和扫描循环次数直接决定Si（100）表面的耐磨性能。

Wear rate of Si_3N_4 ceramic rose with the increase of loads between Si_3N_4 ceramic and chilled iron while the effect of relative sliding speed on wear rate of Si_3N_4 ceramic is not as significant as that of load.

Si3N4陶瓷的磨损率随载荷的增大而增大，滑动速度对磨损率的影响要小于载荷对其的影响；

The effects of sliding speed and load were considered.

分别考察了滑动速度和载荷对两种材料的摩擦因数以及磨损量的影响。

A fuzzy sliding mode controller with load adaptation is designed for the slow subsystem, and an optimal controller is desinged to stabilize the fast subsystem.

首先，采用奇异摄动将系统分为慢变和快变两个子系统。然后，对慢变子系统采用负载自适应模糊滑模控制，快变子系统采用最优控制。

Sliding Analysis on Offset Load of Single Support Continuous Box Girder Bridge

独柱支承连续箱梁天桥活载偏载时的滑移分析

Walking Model Experiment and Study of Sliding Load External Fixator ( SLEF) in Fixture of Intertrochanteric Fracture

股骨粗隆间骨折滑动加压外固定器的设计及步态模拟实验结果分析

The movement trace, velocity and load of the sliding piece were analyzed from dynamics.

从动力学角度，对滑片的运动轨迹和速度以及受力进行了分析，定性给出了受力大小和运动关系；

Typical application of load factors for sliding and eccentricity.

滑动及偏心率荷载系数的典型应用。

As the results, the friction coefficients decrease with increase of the sliding distance and normal load.

结果表明：碳化硼-碳化硼摩擦副的摩擦系数随滑行距离和载荷的增加而减小，最低摩擦系数为0.09；

Through the usage analysis of a speed governing system identified were the causes leading to the sliding load and load jump phenomenon discovered in the mechanical/ hydraulic speed governing system of a 200 MW steam turbine, which used a high-speed elastic governor as sensing elements.

通过对调速系统的使用分析，找出200MW机组采用高速弹性调速器为敏感元件的机械液压式调速系统滑负荷和负荷阶跃产生的原因。

The results show that at low sliding speed and small load, the main dry sliding wear mechanism of the coating is oxidation wear, and the wear resistance of the coating is 2~ 4 times higher than that of tempered 45 steel.

结果表明，轻载低速条件下，熔涂层的干摩擦滑动磨损机制以氧化磨损为主，与淬火低温回火态45钢相比，熔涂层的耐磨性是45钢的2～4倍；

Under several low load operation conditions, performance tests of fixed pressure and sliding pressure operation have been carried out for a125MW steam turbine.

在几种低负荷运行工况下对125MW汽轮机组进行了定压、滑压性能试验。

A small load sliding reciprocating friction tester was developed and its principle and structure was described.

描述了自行研制的小载荷下滑动往复摩擦测试平台的工作原理.

The wear characteristics of polytetrafluoroethylene ( PTFE) were tested on the model MPX-200 pin-on-disk tester in this paper. The effects of sliding speed, load, temperature and surface roughness of counterparts on wear were determined.

作者用MPX-200型栓-盘摩擦磨损试验机测试了模压聚四氟乙烯的磨损性能，考察了滑动速度、负菏、温度及偶件表面粗糙度对磨损的影响。

The plastic deformation is accelerated at high sliding speed and normal load, which is accompanied by localized melting on the worn surfaces of the frictional materials.

在高速和高压条件下塑性变形加剧，摩擦材料磨损表面可见熔融迹象；

According to the way that the anchoring load diffuses and delivers, the equations to the subsidiary stress generated by anchoring effect were deduced and the ultimate shearing strength to sliding plane was determined.

根据锚固荷载在岩体中的扩散与传递方式，推导锚固作用引起的附加应力的计算公式和确定滑面的极限抗剪强度。

The materials apply to sliding under high load.

该材料适用于高载荷下的润滑部件；

Design and Clinical Application of Sliding Load External Fixator for Intertrochanteric Fracture of Femur

滑动加压股骨粗隆间骨折外固定器的设计和临床应用

When the dipping angle of the slide surface is steep, the whole sliding will be predominant, which implies that load design could be determined by classical slice methods.

当滑动面倾角较大时，滑动效应占主导地位，抗滑桩的设计荷载可根据各种条分法来确定。

The thrust sliding bearing bears axial load, the bearing structure is largely determined by the working conditions.

推力滑动轴承承受轴向载荷，这样的工作条件很大程度上决定了轴承的结构。

Respectively when supercritical unit is in constant pressure operation and sliding pressure operation, the simulation test of primary frequency regulation is carried out at different load, and the test results are compared and analyzed.

分别对超临界机组定压运行、滑压运行时，在不同负荷下进行一次调频仿真试验，并将试验结果进行对比分析。

When the sliding velocity or load exceeds a certain critical value, the wear volumes of the two nitrided layers increase with increasing the sliding velocity or load.

当超过一定的滑动速度或载荷时，两种渗氮层的体积磨损量随载荷或滑动速度的增加而迅速增加。

Specimens by high-strength bolted slip resistance testing, the extent of the corrosion resistance of its slip coefficient, sliding load and the impact of the ultimate load. Establish the extent of corrosion performance and high-strength bolts connecting the quantitative relationship. 3.

通过高强螺栓连接试件的抗滑移试验，探讨了锈蚀程度对其抗滑移系数、滑动荷载以及极限荷载的影响，建立了锈蚀程度与高强螺栓连接性能指标的定量关系。

With increasing the applied load and sliding velocity, the friction coefficients decrease.

随着载荷和摩擦速度的增加，摩擦系数减小。