sliding velocity

The relationship of abrasion loss and friction coefficient with respect to load, sliding velocity and sliding distance are discussed and wear mechanism of ceramic is analyzed.

对氧化铝陶瓷的耐磨损性能进行了检测与分析，讨论了载荷、滑动速度、滑动距离与磨损量、摩擦系数之间的关系，分析了陶瓷磨损过程机理。

The Effect of Sliding Velocity on Wear Characteristics of Aluminium Alloy-Graphite Composites

滑动速度对铝合金-石墨复合材料磨损特性的影响

The friction oxide generated in the wear surface, and the degree of oxidation increased and aggravated with the increase of load and sliding velocity.

磨面随着摩擦的进行氧化现象明显，氧化程度随着载荷及滑动速度的增加而加剧。

Friction Vibration(ⅱ) Relation between Dynamic Friction and Sliding Velocity

摩擦振动（二）（二）动摩擦力与滑动速度的关系

By the introduction of a compensation term in the design of the sliding mode observer that counteracts the effect of system deviations to the velocity reconstruction, the exponential observation error is converged to a bounded region.

在滑模观测器设计中引入补偿项，动态抵消系统偏差对速度重构的影响，确保观测误差指数收敛到有界域。

Effects of sliding velocity on wear properties of WC_p/ Fe-C functionally graded composites

滑动速度对WC P／Fe-C功能梯度复合材料磨损性能的影响

Effect of sliding velocity on the frictional behaviors of in situ granular eutectics reinforced austenite steel matrix composites

滑动速度对团球共晶体增强奥氏体钢基自生复合材料摩擦学性能的影响

Friction and Wear Behavior of the Materials under Very High Sliding Velocity

高速干摩擦条件下铝基复合材料的摩擦磨损行为研究

Effects of Sliding Velocity and Abrasive Materials on Wear Behaviour of UHMWPE and PTFE

滑动速度和磨料对UHMWPE和PTFE磨损的影响

The scuffing-resistant capability of friction pairs is enhanced with reducing sliding velocity.

摩擦副的抗胶合能力都随相对滑动速度的提高而下降。

Effect of Different Atmosphere on Dry Friction Behavior of Steel against Brass at High Sliding Velocity

环境气氛对钢／铜摩擦副高速干摩擦行为的影响

Movement analysis of ball sliding type constant velocity universal joint

滑球型同步万向联轴器运动分析

Analyses of formation mechanism and sliding velocity of vast landslides of poorly consolidated rocks

半成岩大型滑坡机制和滑速分析

The effects ofload and sliding velocity on the wear properties of the composites were discussed and the wear mechanisms were also investigated.

滑动速度对复合材料的摩擦因数影响较小，但对磨损率影响较大。

The mechanisms of influences of the sliding velocity on the frictional behavior are analyzed with the critical transition temperature theory and Archard wear theory.

运用临界转变温度理论与Archard磨损理论分析了相对滑动速度对EAMC摩擦学性能影响的机制。

Normal pressure, temperature of tool surface and relative sliding velocity between tool and workpiece are obtained through the above finite element analysis.

利用二维热力耦合有限元模型对不锈钢时的切削过程和热传递过程进行了仿真分析，得到了刀具表面的应力、温度以及刀具与工件之间的相对滑移速度。

Research on Discrete Sliding Model Variable Structure Control of Hydraulic Elevator Velocity System.

液压电梯速度系统离散滑模变结构控制的研究.

The friction coefficient and its fluctuation range decreased with the increasing load in the case of the same sliding velocity.

滑动速度相同时，摩擦系数及其波动幅度均随载荷的增加而减小。

With increasing the applied load and sliding velocity, the friction coefficients decrease.

随着载荷和摩擦速度的增加，摩擦系数减小。

As load and sliding velocity increased, thermal effect aggravated wear rate of pure copper and its composites.

载荷与滑动速度提高引起的热效应使得纯铜及其复合材料的磨损率增高；

The average friction coefficients present a similar variation with normal load and sliding velocity for the two nitrided layers during the dry sliding in vacuum.

在真空干滑动时两种渗氮层的平均摩擦系数随法向载荷和滑动速度的变化趋势相似。

The results indicate that the friction forces keep constant with load and sliding velocity increasing for OTS/ MPS composite SAMs.

结果表明，OTS/MPS复合自组装分子膜的摩擦力随着载荷和滑动速度的增加而基本保持不变；

The average friction coefficient increases obviously with increasing the load, but decreases with increasing the sliding velocity ( except for the case of lower load).

平均摩擦系数随载荷明显增加，而随滑动速度的增加有所降低（低载荷时除外）；并且，其降低幅度随载荷增加而增大。

A constitutive relation between flow shear stress rate and the relative sliding velocity of shear band is also obtained.

推导了剪应力（率）与剪切带相对错距（速度）的本构关系。

So the frequency domain equal energy wave door method with frequency modulated continuous triangular wave system signal is designed for estimating the distance along the axes and the radial velocity through two range wave doors scanning the main valve area of the echo while sliding.

故设计采用调频连续三角波体制信号，通过两个距离波门对主瓣回波区进行滑动扫描的频域等能量波门法估计轴心距离和径向速度。

The characteristics of loess interface landslide and loess-mudstone layer plane landslide are low sliding velocity, short sliding distance and low stability after sliding.

黄土接触面滑坡、土泥岩顺层滑坡的滑速低、滑距短，滑体具有稳定性差、活性强的特点。

The relative sliding velocity, the coefficient of friction and frictional heat flux between contact tooth flanks are calculated.

研究了啮合过程中轮齿的相对滑动速度和齿面摩擦因数以及摩擦热流密度的计算方法；

Meanwhile, with the increase of the mean velocity of abrasive, the wall sliding velocity will increase.

同时壁滑速度随磨料平均速度增加而增大。

However, the friction coefficient between Ni and APS increased with sliding velocity increasing and reduced with load increasing.

而镍与APS间的摩擦系数随滑动速度的增大而增大，随载荷的增大而减小。

It is found that the friction coefficient increases with the increase of sliding velocity, and there is critical velocity.

试验发现，摩擦系数随滑动速度的增加而增加，存在临界滑动速度。