stick-slip

It is different from under point contact that there is no stick area under line contact in the partial slip regime, and load distribution within line contact area is uneven due to roughness of surface.

磨痕分析表明，承载区域接触不均匀，存在虚接触区域，其大小与表面粗糙度有关，而接触区域没有不磨损的粘着区，不同于点接触形式。

Stick-slip phenomenon; the regulation of the system of transfer disbursement;

规范转移支付制度；

Some SEM microtextures of quartzite from stick-slip and steady state slip experiments and their seismogeological significance

粘滑和稳滑实验条件下石英岩的某些显微形貌特征及其地震地质意义

Simulation results with this two-dimensional model show full sliding motion and stick-slip motion which may appear with some proper parameters.

数值仿真结果显示，在一定的参数状况下滑动导块有可能出现爬行运动状态。

Theoretical and Experimental Research on the Stick-slip Precise Transportable Platform Driven by Piezoelectric Bimorph

压电式粘滑精密运动机构驱动理论与实验研究

It shows stick-slip and high strength at the temperature range of 350-480 ℃.

在350℃&480℃间表现为有震粘滑，强度高。

The results show that stick-slip transition and slip-stick transition alternatively appears on the interface between the melt and tube wall of the capillary when the pressure oscillation goes on.

结果表明，发生压力振荡时，熔体与毛细管壁的界面出现时黏时滑转变。

Taking the cylinder that is now commonly used in the industrial application as the tested object, the friction force model of cylinder, the metewand for judging stick-slip and the stick-slip criterion including many factors are studied.

然后，以工业应用中常用的气缸为研究对象，对气缸摩擦力模型、判定气缸爬行的评价基准、气缸爬行工况参数判定式等内容进行了研究。

The result indicates that the structure of universal-shaft driving system is reasonable and the unsteadiness of stick-slip vibration doesn't occur.

结果表明该万向轴传动系统结构合理，不会出现粘滑振动失稳现象。

The criteria of overcoming low-speed slip-stick phenomenon of third-order system is given by using phase plane method, algebra analyzing method and Lyapunov stability theorem.

采用相平面法、代数分析法和李雅普诺夫稳定性定理得出了三阶系统克服低速滞滑爬行的判定定理。

Based on the characteristics of coupled wheelset, a new way to restrain stick-slip vibration is presented, whose feas.

基于耦合轮对的特点，提出采用耦合轮对抑制粘滑振动的新方法，并对其可行性进行了分析。

Theoretical analysis and numerical value solution of critical condition for stick-slip

爬行临界条件的理论分析和数值解

The macroscopic and microscopic evidences of periodical stick slip deformation in an active fault were collected and analyzed.

收集和归纳了活动断层周期性破裂（高速）变形的宏观和微观证据。

Some correlated and widespread pulse like transient variations in self potential and strain field appeared at some special situations, including sudden loading/ unloading, stick slip and fracture of rocks.

结果表明，在突然加卸载、黏滑和岩样破裂几种特定情况下，自电位和应变场均出现了互相关联的脉冲状突然变化，且具有相当大的空间展布。

The relationship between system parameter and low-speed slip-stick phenomenon is found, and the condition of choosing the parameter of PID is given, which should satisfy the purpose of overcoming low-speed stick-slip and guaranteeing the stability.

通过该判定定理得到系统参数与低速滞滑爬行的关系，在满足常规稳定控制器参数选择范围的基础上，给出了为消除低速滞滑爬行，PID控制器参数还应满足的条件。

Therefore the fracturing process associated with the main-shock as well as the ⅰ, ⅵ type small earthquakes are stick-slip of rock masses along conjugate faults trending NE and NW.

综上所述，本区破裂过程，主震及Ⅰ、Ⅳ类地震是岩块沿NE及NW向共轭构造的粘滑；

The torque feedback system is a successful technology for eliminating stick-slip vibration of drill-string assembly.

扭矩负反馈减振是控制和消除钻柱周向粘滑振动较为有效的方法之一.