superheating

The metastable characteristics of decompression CO2 in depression were analyzed and the nucleation mechanism in CO2 superheating liquid was explored.

对迅速降压中的CO2的亚稳态平衡特性进行分析，研究CO2过热液的成核机理。

The Measure of Preventing a Air Heater Tube Wall Temperature from Superheating

浅谈防止空气预热器壁温超温的措施

This paper discuses how to increase thermal efficiency by increasing superheating areas to reduce transportation energy consumption mainly produced by old steam locomotive.

冶金运输的主要设备为老式蒸汽机车，为降低运输能耗，采用增大过热面积，提高热效率的方法，取得了良好的节能效果。

The results show that there exists more thick needle-plate like and needle like Al_3Fe phase without superheating and chilling;

试验表明：合金未热速处理时，Al3Fe相大多呈粗大的针片状和针状；

Effect of Melt Superheating on the Solidification Behavior and Structure of Hypoeutectic Aluminum-silicon Alloy

熔体过热处理对亚共晶Al-Si合金凝固特性和组织的影响

Thus it can be seen, medium segmentation market competition already near superheating.

由此可见, 中型的细分市场的竞争已近白热化.

The experiment results show that the effect of superheating temperature on secondary dendrite spacing is unnoticeable when Al-7% Si alloy is superheated in the temperature range of 750-1 100C. Dendrite morphologies become well distributed with the increase of superheating temperature.

实验结果表明：亚共晶Al-7%Si合金在750-1100℃进行熔体温度处理时，过热温度对二次枝晶的细化作用不明显，而组织的均匀性随着过热温度的升高而变好；

Superheating of steam while maintaining the temperature over a range of boiler operating conditions.

·在大的操作范围内继续维持正常的蒸汽过热度.

But after WTO, because of the customs duty's adjustment and quota's cancellation, competition appears superheating in the wristwatch industry with high degree marketability.

但加入WTO之后，闭税的调剂，配额的撤长，市场化火平较上的脚外业合做呈现黑暖化。

the crack in investment castings is commonly created around ingate due to easily forming superheating at root of ingate.

铸件内浇道根部易出现过热，裂纹一般产生在靠近内浇道处。

Although the league tournament last act's proximity, the Asian crown qualifications compete also enter the superheating.

虽然联赛尾声的接近, 亚冠资格的争夺也进入到白热化.

The purpose of superheating the steam is to ensure that it is fairly dry.

过热蒸汽是为了保证蒸汽相当干燥.

This week 6 entered 5 competitions already to enter the superheating stage.

本周的6进5比赛已经进入了白热化阶段.

Today, it's widely assumed that the glass was created by a long-ago meteor or comet crash superheating the sand to around 2000 degrees Celsius ( 3600 ° F). What the glassy desert must've looked like in the minutes immediately following the impact we can only imagine.

如今，人们普遍认为这种玻璃是很久以前由于陨石或彗星碰撞使沙漠过热约2000摄氏度（3600°F），我们只能想象，紧接着数分钟后受波及的玻璃沙漠是何种模样。

In fact, market all quarters rescue the city dispute to tend to the superheating.

事实上, 市场各方的救市纷争已趋向白热化.

The support structure groaned and started to melt and sag from the superheating core.

支撑结构摇头长叹一声,并开始溶化,从凹陷过热的核心.

Snatches ten game in the contests to enter the superheating condition, the score has nipped tightly.

抢十局里的较量进入白热化状态, 比分一直咬得非常紧.

Superheating of steam while maintaining temperature over a range of boiler operating conditions.

在大的操作范围内继续维持正常的蒸汽过热度.

Carbides in hypereutectic chromium white irons are inclined to be rodlike and isolated after compound inoculation under the condition of superheating, which is due to the rise of Cr/ C in micro-area of molten cast irons.

铬系过共晶白口铸铁经过热处理和复合孕育处理后，铸铁熔液局部微区Cr/C的升高有利于碳化物的改性，使碳化物趋于棒状、细小且孤立分布。

Especially joins WOT officially after China, domestic various Commercial bank and Foreign bank in international service competition trend superheating.

尤其在中国正式加入WOT后，国内各家商业银行和外资银行在国际业务上的竞争趋向白热化。

analyses on the cascade superheating temperature control system

串级过热气温控制系统分析

Superheating of heat medium which can cause explosion must be avoided in operation of the organic heat medium boiler.

提出利用雷诺数法来防止盘管式有机热载体炉导热油过热的方法。

Superheating of heat explosion must be avoided in operation of the organic heat medium boiler.

提出利用雷诺数法来防止盘管式有机热载体炉导热油过热的方法.

Effects of the Superheating Temperature and the Cooling History on As-cast Microstructure of AZ Series Magnesium Alloys

过热温度和冷却历史过程对AZ系列镁合金铸态组织的影响

The effects of technical parameters on the thickness of solidified shell were studied, such as base strip thickness, liquid steel superheating and dipping time.

研究了母带厚度、钢液过热度、浸渍时间等工艺参数对薄带凝固层厚度的影响规律。