supported beam

Shows the deflection of a simple beam supported end , loaded from 1 or more points.

计算两端各受多点力的简易支撑梁的变形.

A new way that both steel temporary bridge supported by the primary piers and the simple-supported beam bridge work together to bear the heavy loa.

提出了一种利用原桥墩、台架设临时钢便桥与原桥组合受力共同承担大件通过的运输方案。

Vibration and Stability of Simply Supported Beam Subjected to Temperature Load

面内温度载荷作用下简支梁的振动和稳定

By using the knowledge about shear diagram, moment diagram and extreme value of quadratic function, this paper discusses on the calculating method of maximum shear and maximum moment of simple-supported beam under moving loads.

应用剪力图、弯矩图和代数二次函数极值的知识，对简支梁受移动载荷作用时最大剪力和最大弯矩的计算方法进行了论证。

It'showed that the method is feasible through dynamic model test of simply supported beam.

用简支梁的动力模型试验数据验证了算法应用的可行性.

Influence of axial load on bend and vibration of simply supported beam

轴向力对简支梁弯曲与振动的影响

The deflection upwards of simple supported beam is calculated by the means of unites elastic and plastic analysis into Finite-Element theory.

利用混凝土的弹性徐变计算理论对预应力混凝土简支T梁的起拱度进行了编程计算。

The paper provides the theory basis that the arched beam replaces the additional simply supported beam in high pipe dock.

为拱梁在高桩码头结构中的应用提供了一定的理论依据。

According to the section temperature field distribution of the the whole heating process, derived the normal cross section ultimate flexural bearing capacity calculation formula of the simply supported prestressed steel reinforced concrete beam under high temperature.

3根据升温全过程构件截面温度场的分布，推导高温下预应力型钢混凝土简支梁的正截面极限抗弯承载力计算公式。

Method of calculating Simple Supported Curved Beam in Skew Bridges

山区斜交桥的壅水计算斜交简支平面曲梁的实用计算

A New Method of Simple-Supported Beam Bridge with Large Skew Angle

大斜交角度简支梁桥设计新法

Identification of Excitation Source of Simply Supported Beam Based on Principal Component Analysis

基于主分量分析的简支梁结构激励源识别

The sensitivity analysis of bend and wrest frequency for cable-supported bridge beam

索支承体系桥梁弯扭频率的敏感性分析

Comparing the calculation results of a simply supported beam assembled by "64 Type" beam units and that of the truss model, the theory of strength design is discussed.

将此方法的计算结果与传统桁架模型的计算结果进行比较，对拼组结构的强度设计理论进行讨论。

The frequency equations of the simply supported beam and cantilever beam are given.

以简支梁和悬臂梁为例,结合具体的边界条件,导出它们相应的频率方程.

Optimized Design for Simple Supported Beam of Steel Reinforced Concrete

钢筋混凝土简支板优化设计方法

On the basis of the fatigue stress spectrum in the member bars which are located in the representative part of the bridge, the traditional fatigue analysis method is applied to evaluate the fatigue life of the main member bars in the simply supported beam of NYRB. 4.

得到桥梁主要杆件的疲劳应力谱，采用传统疲劳分析方法对南京桥简支跨主要构件进行了疲劳剩余寿命评估。