tensile load

Effect of a Laser Discrete Pre-quenched Substrate on the Fracture Behavior of Chromium Coating/ 45 Steel Substrate under Tensile Load

拉伸载荷作用下基体表层激光离散预处理对铬镀层/45钢基开裂行为的影响

The variable displacement control strategy, variable load control strategy and variable strain rate control strategy were applied to the upper computer control software development to realize motion control of the variable scale load/ strain rate biaxial tensile testing machine.

将变比例位移控制策略、变比例载荷控制策略、变比例应变率控制策略应用到上位机控制系统软件开发中实现变比例载荷／应变率双向拉伸试验的运动控制。

The ultimate tensile load of the 3D braid increases significantly by incorporating PGA fibers into the braiding yarn.

在编织纱中掺入PGA纤维，可显著提高三维编织物的最大拉伸裁荷；

An exact relation between the cavity radius and the tensile load is obtained.

得到了空穴半径与外加载荷之间的精确关系；

Damaging constitutive law of reinforced concrete specimens under monotonic uniaxial tensile load

单调轴向荷载下钢筋混凝土拉伸损伤本构研究

Analysis of Equivalent Elastic Modulus of Single-Walled Carbon Nanotube Under Bending and Tensile Load

碳纳米管弯曲和拉伸等效弹性模量的计算分析

Experimental Research on the Behavior of Chemical Adhesive Steel Bar in Concrete Under Tensile Load

混凝土化学植筋锚固性能的试验研究

Molecular Dynamics Simulations of "Y"-Shaped, Bamboo-Shaped, and Straight Carbon Nanotubes Under Tensile Load

Y型、竹节型与直纳米碳管的力学特性研究

Behavior of inclusions in nickel-base P/ M superalloy under tensile load

拉伸载荷下镍基粉末高温合金中夹杂物行为

Experimental Research of Weld Residual Stress Relief by Tensile Load Method

焊接残余应力拉力载荷消除法的实验研究

They were then loaded on a tensile machine ( Instron 1122) for slow-pulling, fast-pulling experiment and reciprocating fatigue test at 20N load peak value separately.

将其随机分成三组，在Instron1122拉力实验仪上分别进行慢拉、快拉和20N峰值负荷条件下的反复疲劳实验。

Testing Study on working mechanism of full grouting bolt under tensile load

张拉荷载下全长粘结锚杆工作机理试验研究

Radial interference fit ( 0.1 mm)-336 MPa axile tensile load.

径向过盈配合0.1mm，轴向拉伸载荷336MPa。

Analysis on bolt strain with large deformation under shearing tensile load

锚杆拉剪大变形应变分析

Crack propagation under tensile load and calculation of stress intensity factor

拉伸载荷作用下裂纹扩展及应力强度因子计算

The fatigue experiment of steel strand with pulsating tensile load and doubly piled clamping apparatus

多绳提升的脉动载荷与张力平衡钢绞线脉动拉伸疲劳试验和双层叠加式夹具

The effect of axial tensile load on magnetic memory signals from the surface of medium carbon steel

拉伸载荷作用下中碳钢磁记忆信号的机理

Study on constitutive model and permeable coefficient tensor of rock under tensile load with micromechanics ( I): Anisotropic constitutive model

拉应力条件下岩石细观力学本构模型和渗透系数张量研究（I）：各向异性损伤本构模型

Selection of Wire Rope in the Reinforced Flexible Flat Cable and Testing and Setting of its Tensile Load

加强型扁软电缆中钢丝绳的选配及承拉能力的检测与设定

A Biomechanical Study on the Compression and Tensile Load on Skull of Mayfield Head Holder in Cervical Posterior Approach

颈椎后路手术Mayfield头架固定颅骨耐受压力和拉力的实验研究

In a tensile test, the breaking load is the break strength.

在拉伸试验中, 断裂载荷就是断裂强度.

This modulus is an indication of the stiffness of the material when subjected to a tensile load.

它反映的是材料在受到拉伸载荷时的硬度。

The result showed that the tensile load near the crack tip was dominant, and the tensile load had higher effect than the shear load.

结果表明，拉伸载荷主导界面裂纹尖端附近区域，并且拉伸效果远大于剪切效果。

Application Of Digital Spackle In Measuring Strain Filed Of Natural Fiber Textiles Under Biaxial Tensile Load

数字散斑在测量植物纤维织物双轴向拉伸应变场中的应用

Testing methods for chemical resistance of plastics under constant tensile load

确定负载下塑料耐化学试剂性测定法

Based on the dynamic mode, this paper presents the discussion on four different loads, that is, non-interference fit-50 MPa tensile load;

根据该力学模型，讨论了四种不同载荷，即，无过盈配合，套管轴向拉伸载荷50MPa；

Thanks to tensile membrane action, the actual load capacity was much grater than the design capacity using yield-line theory.

由于受拉薄膜效应的存在，混凝土板的实际承载力比按塑性铰线理论的计算结果高得多。

Box Dimension Changes Law of Metal Magnetic Memory Signal Under Tensile Load

拉伸载荷下金属磁记忆信号盒维数的变化规律研究

Analysis of mechanical behavior of fully grouted rock bolt under tensile load

张拉荷载下砂浆锚固岩石锚杆的力学分析

Using the cross model modified and MATLAB software, the composites modulus and stress on a fiber section at tensile load are calculated.

由修正后的交叉模型应用MATLAB计算了三维编织复合材料的弹性模量和拉伸载荷下纤维束截面的应力情况。