tensile region

High temperature properties of continuous casting high carbon steels were measured by tensile tests with a Gleeble 1500 system and two embrittlement temperature regions of region I and region III were found.

采用Gleeble-1500热模拟试验机测量了高碳钢连铸板坯的高温力学性能，得到了第Ⅰ、第Ⅲ脆性温度区的温度范围。

Experimental Research and Analysis of Welding Residual Stress of the Tensile Anchorage Region; Study on Drawing Force of Root Layer in Masonwork Affected by Anchor Bolt Type and Anchor Depth

斜拉桥锚拉板区域焊接残余应力试验研究分析锚栓类型、锚固深度对基层砌体拉拔力影响的研究

Besides, the specimen-machine attended mode and preinstalled hole in the specimen tensile region play a important role in the accuracy of the test result.

而试件两端的连接方式和试件受拉区是否预设缺口则对试验结果的准确性产生重要影响。

The position of tensile region of the section at mid-supports goes down as the span-depth ratio reduces.

中间支座截面受拉区的位置随着跨高比的减小而下移；

First, establish finite element model, make reasonable arrangements for model size, tensile region heighten, restricted location.

首先，建立起有限元模型，对各种模型中的尺寸、受拉区高度、约束位置进行合理的布置。

The results show that the plastic extension would not occur in tensile region until eccentricity is large and slenderness ratio is small.

研究结果表明：除相对偏心率很大及长细比很小的情况外，工字形截面偏心压杆受拉翼缘不会进入塑性状态；

Rock bridge obliquity certain Angle, the greater the tensile stress in the region to concentrate on rock bridge, when prefabricated crack is bigger than 75 °, tensile stress in rock evenly distributed gradually.

岩桥倾角一定时，裂纹倾角越大，拉应力越在岩桥区域集中，预制裂纹大于75°时，拉应力逐渐在岩体中均匀分布。

Aging of earth dams is universal appearance of objective reality. Its process of development is that the dam body firstly shows weak stress region, then tensile region and finally shows cracks.

土坝老化是客观存在的普遍现象，其发展过程是：坝体出现弱应力区→出现受拉区→出现裂缝。

The model was partitioned into four regions, where region A ( MMT platelet), B and D stand tensile deformation, and region C stands both tensile and shear deformation.

模型划分为四个区域：以拉伸变形为主的A（蒙脱土片）、B和D区，和同时承受拉伸和剪切两种变形的C区。

Meantime, combined the flexural carrying capacity ultimate state characteristic of concrete thin-walled box girder, when the strain of longitudinal steel at tensile region firstly arrives at 0.01, the ultimate flexural capacity calculated formula and designed formula of concrete thin-walled box girder has been obtained.

同时，结合混凝土薄壁箱梁抗弯承载力极限状态下的特点&以受拉区钢筋应变达到0.01为标志，推导得出了混凝土薄壁箱梁抗弯极限承载力计算公式和设计公式。

The volume strain forms a compressive region at the centre area of reservoir, and a tensile at the bank area and expands in all directions being consistent with the distribution of epicenter of induced earthquake.

体应变一般在库中心位置形成压缩区，而在库岸边则形成拉伸应变区并同时向四周扩展，与诱发地震震中分布相一致。

To set fiber reinforced polymer/ plastic ( FRP) composite in tensile region of glued laminated timber ( glulam) beams is effective measure to improve structural behaviors.

在胶合木梁的受拉区设置纤维增强复合材料（FRP）是提高胶合木（glulam）梁结构性能的有效方法。

At the same time the paper establishes the solid finite element model of T-beam, and analyses the fatigue cracks, and the time-stress history of the reinforcement in tensile region and of the concrete in compressive zone under automobile load spectrum.

同时建立了T型梁有限元实体模型，分析了车辆荷载谱作用下梁的疲劳开裂、压区混凝土以及拉区钢筋的应力时间历程等问题。