tensile-strength

The compression-strength, tensile-strength and impervious-strength of the cement concrete and so on were determined, and the effects of different industrialized SB latex products on the properties of SB/ cement concrete were examined.

实验测定了掺用工业化试验得到的水泥专用丁苯胶乳的水泥混凝土的抗压、抗拉浙江大学硕士学位论文和抗渗等性能，考察了不同水泥专用丁苯胶乳的工业化产品的影响特点。

To measure tensile strength and breaking elongation of single yard.

测定单根纱线的抗拉断裂强力和断裂伸长.

Used for measure tensile strength and breaking elongation of single yarn and print statistic results.

用于全自动测定单根纱线的断裂强力和断裂伸长,打印测试数据和统计结果.

The volume resistivity, tensile-strength and low-temperature impact brittleness of the cable material were tested, and the results indicate the cable material which filled with calcined kao.

研究了不同表面处理剂和不同比例的纳米级高岭土对电缆料的电学性能、拉伸性能和低温冲击脆性的影响。

the tensile strength of rope

绳索的抗拉强度

The increase of draw ratios in three-stage drawing process decrease the linear density of PAN fiber and improve the strength, sonic orientation and tensile modulus.

三级拉伸工艺中各拉伸比的提高均有利于PAN纤维线密度的减小及其强度、声速取向度和抗张模量的提高；

The more of the aspect ratio of the whisker, the larger of the tensile-strength in the composites.

随着晶须长径比的增加，复合材料的拉伸强度逐渐增大。

Orthotropic behavior and strength criterion of pes/ pvc membrane materials under tensile loading

PES/PVC膜材料拉伸性能的各向异性及破坏准则

The results indicate that the retention rates of tensile-strength mainly correspond to energy density, while the ones of module are related with ablative extent of carbon-fiber nearly.

激光能量密度是影响复合材料辐照后拉伸强度保留率的最主要因素，而影响复合材料辐照后拉伸模量保留率的最主要因素为连续碳纤维增强相的损伤程度。

As the caprylic aldehyde content increased strain at break and tensile strength were decreased.

弹性模量、拉伸强度、断裂伸长率和交联密度均随模压温度的升高而增大.

To measure tensile strength and breaking elongation of single yarn.

测定单根纱线的抗拉断裂强力断裂伸长.

In the tensile test, fracture appears in the heat affected zone of aluminum base metal, and its tensile-strength is 72.09 MPa.

在进行拉伸试验时，断裂发生在铝母材的热影响区，接头强度为72.09MPa。

The manufacturability, microhardness, tensile-strength of SiC whisker/ Resin Matrix Composite was investigated.

考察了SiC晶须树脂基复合材料的工艺性，硬度，拉伸强度等性能。

All of those indicate that the material overcomes the shortcomings of acellular dermal matrix and has high permeability, tensile-strength, and proper degradation speed. So it conforms to tissue engineering scaffold material requirements.

上述结果表明该材料已解决了猪脱细胞真皮基质渗透性差、降解速度过慢的缺点，并且其透气性和拉伸强度高、降解性优良且可控，符合组织工程支架材料的要求。

Concrete is a brittle material, so its compressive strength is high, but tensile is low.

混凝土是一种脆性材料, 抗压强度高, 而抗拉强度则较低.

Experimental study on tensile-strength of asphalt concrete of embankment dam

土石坝心墙沥青混凝土抗拉强度试验研究

The physical dimensions, tensile-strength, area resistance, DSC curves were measured in the experiments. The multiple separators were applied in testing batteries for initial electrical performance tests.

实验中测量了隔膜的物理尺寸、拉伸强度、面积电阻、示差扫描量热法（DSC）曲线，并应用于实验电池中，对电池电性能做了初步测试。

The notch sensitivity of high strength steel under tensile loading

高强度钢静拉伸的缺口效应

The results of performance measurement test show that tensile-strength, contraction of cross sectional area, elongation percentage, dynamic ductility of the weld all exceed their base metal.

焊后试件的性能测试结果表明，焊接接头的拉伸强度、断面收缩率、延伸率及冲击韧性均已超过母材。

The tensile-strength is between 10.20 MPa and 11.50 MPa which is better;

拉伸强度介于10.20～11.50MPa之间，具有良好的拉伸强度；

The tensile modulus and strength of the microfibrillar composites are significantly enhanced with increasing the hot stretching ratio, indicating that the microfibers have a good reinforcement on the PET/ PE composites.

复合材料的拉伸模量和拉伸强度随拉伸比增加显著增加，表明微纤化对材料具有良好的增强效果；

The results show that the tensile-strength and the resistance to water, to ultraviolet and to heat of compound modified waterproofing films exceed their of single modified waterproofing films.

结果表明：复合改性涂膜拉伸强度增大，并且耐水性、耐紫外老化性和耐热老化性优于同样条件下单一改性防水涂膜。

Brittle materials tensile-strength tester

脆性材料抗拉强度测试仪

Polyimide ( PI) film materials have been widely applied in many fields such as aviation, national defense, electronic device and optical-communication for their high tensile-strength^ high modulus and high dimensional stability.

高强、高模、高尺寸稳定性和加工性能优良的聚酰亚胺薄膜材料在航天航空、国防军工、电机电器、电子通讯等高新技术产业显示着广阔的应用前景。

Proper additive Mg and rare earth can improve the hardness, wear-resisting property tensile-strength, elongation percentage of TiC/ Al, TiC/ Al-Si composite.

加入适量添加剂Mg和稀土CeO2使原位TiC／Al，TiC／Al-Si复合材料的硬武汉科技人学硕1：论义度、咐磨性、抗拉强度、延伸率得到很大的提高。