thermal intensity

Can remove the TAB fungus in the concentration fruit juice, reduces the thermal sterilization intensity, simultaneously enhances each physics and chemistry target.

可去除浓缩果汁中的TAB菌，减少果汁热力杀菌的强度，同时提高果汁的各项理化指标。

The results show that under the same condition, the thermal radiation intensity of the complex is higher than that of the opal quartz by over 10%.

与乳白石英玻璃相比较，在相同的条件下，其热辐射强度可提高10%以上。

The concept of thermal stress intensity factors in a current-carrying plate with two same penetrated collinear cracks was built in this article.

文中建立带有两个等长度共线穿透裂纹载流薄板的热应力强度因子的概念。

The result provides valid method for thermal stress intensity factor calculation at high efficiency in MSC. Marc.

本文研究结果为热应力强度因子在MSC.Marc环境下的高效率计算提供了有效的方法。

The study of XPS indicated obvious increase in the oxidation state of iron after the thermal oxidation and the intensity change of the Fe 2p_ ( 3/ 2) spectra showed that some intermediate stages occurred during the oxidation of film surface.

XPS研究表明，热氧化后铁原子价态明显升高，再根据Fe2（p3/2）谱的强度变化，说明薄膜表面氧化时经过某些中间阶段；

Three Dimensional Static Thermal Analysis and Thermal Intensity Calculation of Control Valve

电动调节阀的三维稳态热分析及热强度计算

The novel on-line supervision technique of water temperature difference and thermal current intensity of blast furnace cooling stave based on CAN Bus is introduced. The principle, structure and composition of system are described.

详细介绍一种采用CAN总线技术的高炉冷却壁水温差及热流强度在线监测技术，描述该系统的工作原理、组成及结构。

The Novel On-Line Supervision System of Water Temperature Difference and Thermal Current Intensity of Blast Furnace Cooling Stave Based on CAN Bus

基于CAN总线技术的高炉冷却壁水温差及热流强度在线监测系统

The Welding and Patch Welding of the Thermal Intensity Alloy Assembly in Aircraft Engine

航空发动机中热强合金组件的焊接与补焊

Calculation of Thermal Stress Intensity Factor for Semi-elliptical Surface Cracks of Thin Pipeline

薄壁管道半椭圆表面裂纹热应力强度因子计算

Taking the metal thermal intensity as object function for structural optimization, this paper calculates the heat dissipating capacity of finned radiator of double water of passageway with Matlab. Through analyzing the outcome of numerical value, the optimum dimension of structure of the radiator is obtained.

本文以金属热强度为结构优化的目标函数，利用Matlab对双通水道带翅片的散热器的散热量进行计算，通过对数值结果的分析，得出该种散热器的最佳结构型式。

Supervision of Furnace Thermal Current Intensity and Prediction of Furnace Lining Thickness

高炉热流强度的监测与炉衬厚度预报

Thermal weight function ( TWF) method was introduced to calculate thermal stress intensity factors ( SIF) in axisymmetric thermal shock problems.

热权函数法利用温度与热权函数的乘积的积分来直接计算热冲击过程中裂纹尖端的应力强度因子过渡过程。

Various spectral amplitude codes are studied for evaluation with respect to their performance against three noises namely shot noise, thermal noise and phase induced intensity noise ( PIIN).

为了评估抗三种噪声性能，即散射噪声、相位噪声（PIIN）和热噪声，本文研究了各种光谱幅度编码。

By using the numerical Laplace inversion method, the variations of the temperature distribution along the crack surface and extended line and transient thermal stress intensity factors are presented.

利用Laplace数值反演方法，给出了裂纹面及延长线上的温度分布及动态热应力强度因子随时间变化的规律。

At higher thermal radiation intensity, all samples produced the heat release rate and peaks have increased, the total heat release increased, mass loss increased, but the effective heat of combustion is about the same.

在较高的热辐射强度下，所有的试件产生的热释放速率及其峰值都有所增加，总放热量增大，质量损失增多，但有效燃烧热都相差不大。

The example showed that the value of thermal stress intensity factors near the crack tips caused by point heat source was minus and this could counteract parts of stress intensity factors intension caused by tension loaded in distance and the crack extension could be arrested.

算例分析表明，点热源在裂纹尖端附近产生的热应力强度因子为负值，可以部分抵消无穷远处施加的拉应力产生的应力强度因子的作用，进而达到止裂的目的。

With the material technology improved and non-Fourier effect more widely applied, it is very necessary to research the thermal stress intensity.

所以，随着材料技术的提高以及非傅里叶效应越来越广泛的应用，针对热应力强度的研究是非常必要的。

The gravitational thermal analysis, machine intensity analysis and contact angle determination were employed to characterize the performance of Polyvinylidene Fluoride membrane after hydrophilic modification.

用热重分析、机械强度分析和接触角测定对亲水改性后的聚偏氟乙烯膜进行了表面性能表征。

Thermal stress intensity factor solutions from weight function are discussed too for their new applicable extent.

还讨论了有关热应力强度因子权函数解的适用范围。

Transient thermal stress intensity factors for a functionally gradient material with symmetrical structure

对称型梯度功能材料的瞬态热应力强度因子

On-line supervision technology of furnace water temperature difference and thermal current intensity

高炉炉缸水温差及热流强度在线监测技术

Satellite infrared brightness temperature is calculated according to the black body radiation law using the object thermal radiation intensity data collected and recorded by on-board sensors.

卫星红外亮温是利用星载传感器收集、记录地物的热辐射强度数据，根据黑体辐射的定律计算得到的亮度温度。

The results show that the closed finned tube is much more excellent than the opening finned tube on gross heat, heat of unit volume and metal thermal intensity with the same geometric parameters.

观察发现，几何参数相同时，封闭式翅片形式在总散热量、单位体积散热量和金属热强度方面均优于开放式翅片形式。

Density, porosity, thermal expansion coefficient and intensity were tested by Archimedes-method, show the distance and bend resist of three point etc.

用示差法、阿基米德法、三点弯曲法等方法测试出材料的热膨胀系数、密度、吸水率、气孔率、强度等。

As a result, heat dissipating capacity, metal thermal intensity and free convection heat transfer coefficient of the longitudinal closed finned tube are higher than those of the open finned tube.

结果表明，封闭式纵向翅片管的散热量、金属热强度以及自然对流换热系数都要高于开放式翅片管。

A Study on the Heat Transfer and the Thermal Intensity of Piston

活塞的传热和热强度研究

The results show that the thermal stability and machine intensity were improved compared to Polyvinylidene Fluoride membrane.

结果表明，与聚偏氟乙烯膜相比，改性膜的热稳定性和机械强度均有所提高。

To attain good strengthening effect with good thermal intensity and wear-resisting property, it is very important to determine optimized heat treatment process parameters.

为了使热处理后的ADC12合金保持较好的强化效果，同时又具有较好的热强度和耐磨性，确定优化的热处理工艺参数显得尤为重要。

The basal thermal radiation experiments including intensity of thermal radiation, inverse square law and Stefan Boltzmann law have been studied using PASCO thermal radiation system. The experimental result is fitted, and it is in good agreement with theoretical values.

利用PASCO热辐射实验装置，进行了辐射体辐射出射度、反平方定律、斯特藩-玻尔兹曼辐射定律等基本实验的研究，并对测量结果进行了数据拟合，实验结果和理论模拟符合得很好。