thrust load

The design of the bump foils was discussed and the configuration of an aerodynamic compliant foil thrust bearing with higher load capacity was obtained.

得到了一种承载能力较高的弹性箔片动压气体推力轴承支承拱箔结构设计方案。

The self-made convert structure radial-thrust hybrid bearings test stand can bear radial load, thrust load and both the two direction loads at the same time.

自制的径向-推力联合动静压轴承试验台采用倒置结构，可实现径向加载、轴向加载以及两个方向同时加载。

It was found by calculation that thrust load has an evident effect on contact angle while radial load influence feebly, clearance has a great impact on load distribution and appropriate interference fit increases carrying capacity, but the maximum needle burthen also increases.

计算结果表明，角接触球轴承的轴向载荷对工作接触角影响明显，而径向载荷影响很小；游隙对滚针轴承载荷分布的影响很大，适当过盈可提高承载力，但滚针最大负荷增大。

Distribution of load in bearings under combined radial and thrust load

复合载荷作用下滚动轴承中的载荷分布

Single thrust ball bearing can be subject to the axial load from single direction.

单向推力球轴承可承受单一方向的轴向载荷.

The safety running of hydrogenerator needs thrust bearing sharing thrust load.

水轮发电机组的正常运转要求各推力轴承轴瓦应均匀地承受推力负荷。

Thrust vectoring jet flow interferes the flow over aircrafts, drives its aerodynamic load to vary, and may potentially influence the controllability of aircrafts.

矢量推力喷流对飞行器绕流具有干扰作用，引起飞行器气动载荷变化，对飞行器操纵性也有潜在影响。

The evolvement process of the Longmen Shan foreland basin consist of several stages of thrust belt tectonic load and several stages of thrust belt denudation unload. It can be divided into three tectonic load stages and three denudation unload stages.

龙门山前陆盆地的演化过程是由冲断带若干次构造负载阶段与剥蚀卸载阶段组成的，总体上可以分为三个构造负载阶段和三个剥蚀卸载阶段。

Though in terms of structure system, rigid-framed tied arch bridge belongs to an arch bridge without thrust, and its load path is clear, the construction process is long and complex.

从结构体系上看，刚构系杆拱桥属于无推力结构，传力路径明确，但是，结构的形成过程较为复杂、漫长。

To verify the measuring properties in random direction, the force is applied in the direction of coordinate axes and different quadrant with a specially designed thrust misalignment load device.

为验证该测力平台对任意空间力的测试性能，使用专门设计的推力偏心加载装置在坐标轴和四个象限分别对测力平台进行加载。

Analysis and Elimination of Bearing Thrust Load of Turbo-Charged Turbine

增压透平膨胀机组轴承推力载荷分析及消除

Finite element model to analyze cylinder-cylinder intersection under crosswise thrust load

柱壳接管受横向推力应力分析的有限元模型

Measuring Rocket Thrust Misalignment by Using Load Identification Technique

载荷识别技术在火箭推力偏心测试中的应用

Calculation results show that through interaction characteristic optimization, the efficiency of the integrated propulsor can be dramatically increased compared with individual propeller under the same thrust load coefficient.

计算结果表明，与单独螺旋桨推进器相比，在同样的推力负荷下，干扰特性优化可使组合推进器敞水效率大幅度地提高。

These bearings typically offer high thrust load capability and dynamically compensate for any misalignment.

这些轴承通常提供高推力负荷能力和动态补偿任何偏差.

It's demonstrated that thrust bearing load of Francis hydrogenerator with down-shelf supporting structure can be regarded as maximum vertical excitation force of hydropower house vibration.

同时论证了对于下机架承重的混流式水轮发电机组可采用其推力轴承负荷作为水电站厂房振动的最大垂直激振荷载。

The Investigation of the Influence of Thrust Vectoring Jet Flow on Aircraft Aerodynamic Load

矢量推力喷流对飞行器气动载荷影响的研究

The load that is caused by forces seeking to tilt, bend, or shove a shaft out of line. ( See: Thrust Load)

径向载荷：该载荷是由轴的倾斜、弯曲、挤压或偏心所造成（参见：轴向载荷）。

Radial-thrust floating-ring hybrid bearing can sustain not only the radial load but also the thrust load.

径-推联合浮环动静压轴承即能承受径向载荷又能承受轴向载荷。

Design of Large Tilting Pad Thrust Bearing at Heavy Load and Low Speed

重载、低转速条件下大型可倾瓦推力轴承的设计

It is verified by both theory and practice that this rotor-bearing system, to which small thrust load is applied, is suitable for small load and high-speed machine with cantilevered end.

从而从理论和实践上证实了这种轴承系统适用于受有较小推力载荷的悬臂支承轻载高速机械。

RADIAL FORCE: The load on a bearing perpendicular to the axle, this and the Thrust load are forces that affect the design and application of bearings.

径向力：与轴承的轴线所垂直的载荷；它和轴向力是影响轴承设计和应用的两个力。