thrust plane

Taper ratio and optimum value of taper-flat sector thrust bearing with double-side resistive oil edges posterior inclined plane appliance

双封油边斜&平面固定瓦推力轴承的最佳斜面比

During the friction resistant testing of the engine crankshaft thrust bearing, there are two most important parameters that are the push& pull force and the temperature of the thrust plane.

汽车发动机曲轴止推瓦止推耐磨性能试验中，止推面推拉力、止推片温度是两项重要的控制检测参数。

The 2008 Wenchuan Ms 8.0 earthquake has produced hundreds of kilometers rupture zones on the surface, and thrust fault plane can be seen in many sites. However, the thickness of the fault gouge with sliding or scratches is only a few millimeters.

汶川地震地表破裂长达数百公里，很多地点可见逆冲断层面，但具有滑动或擦痕的断层泥只有薄薄几毫米。

In this thesis, the compressive ultimate strength of grilIagestructures subjected in plane thrust is studied.

本文研究了板架结构在受面内压力作用下的压缩极限屈曲强度.

Summarized that synclines are open, anticlines are tightly closed, and plane distribution pattern of folds was parallel and juxtaposition. The faults were mostly thrust fault, and tectonic types can be divided into 3 styles: compression tectonic style, strike-slip style and extending tectonic style.

认为研究区内向斜开阔、背斜紧闭，褶皱构造的平面展布以平行并列式为主，断裂多为逆冲断层，构造样式可划分为压缩构造样式、走滑构造样式和伸展构造样式三大类型。

The switch control method includes the double thrust ( DT) switch, the switch between phase plane control ( PPC) method and quasi-slide control ( QSC) method, and the angle feedback ( AF) switch.

该切换控制方法主要包括双重推力水平切换，相平面控制律与准滑模控制律切换和角度反馈切换。