Tungsten的例句大全

Application of Iterated Target Transformation Factor Analysis in Spectrophotometry& Simultaneous Determination of Molybdenum and Tungsten in Geological Samples

迭代目标转换因子分析光度法同时测定化探样品中钼、钨

Failure Analysis of Pure Tungsten Target Surface under Electron Bombardment

纯钨靶在电子轰击下的失效分析

Photoelectric System for Measuring the Diffuse Reflectivity of Tungsten Target Surface under Shock-Compression

测量冲击压缩下靶板表面漫反射率的光电系统

The results show that the saturation activity increases with increases of the electron beam energy and the tungsten target thickness.

结果表明，随钨靶厚度及入射电子束能量的增加，As增加。

By changing target board thickness, the residual speed was measured after the tungsten alloy 105 simulative penetrator penetrated 45# steel with different thickness at the same speed.

采用改变靶板厚度的方法，测量了约在相同速度的条件下钨合金105模拟穿甲弹侵彻不同厚度45钢板后的剩余速度。

The design and manufacture technique of drill bits with impregnated diamond and tungsten carbide bar are presented in this paper. The technique on the bit of impregnated and tungsten carbide bar with diamond composite is proposed.

介绍了针状硬质合金-金刚石复合型钻头的设计与制造工艺以及在孕镶针状硬质合金钻头基础上复合金刚石的研究方法。

The results show that this process greatly decreases the slumping and distortion of tungsten heavy alloy, increases the homogeneity of the microstructure and local hardness, etc, because of the formation of three dimensional rigid net backbone with tetrakaidecahedron in the solid state sintering stage.

由于在固相烧结阶段形成了坚固的十四面体形的三维连通网络骨架，阻碍了液相烧结中钨颗粒偏析所引起的变形，合金的性能和显微组织的均匀性大大提高。

Methods for chemical analysis of molybdenum& The tetraphenyl arsonium chloride hydrochloride-thiocyanate photometric method for the determination of tungsten content

GB/T4325.28-1984钼化学分析方法四苯砷氯盐酸盐-硫氰酸盐光度法测定钨量

This Paper introduces the method of staining on dissolving tungsten ore test and its theoretical principle.

本文介绍了商品性钨矿样品的溶矿、染色试验方法和理论原理。

The separation of tungsten and cobalt by use of disused hard alloy anvil as materials and adopting alkali fusion method, roasting, digestion hydrolytic decomposition and crystallization is introduced, as well as the technique of production and principle of 12-phosphoric tungsten acid.

介绍了以废硬质合金顶锤为原料，采用碱熔法处理，结合焙烧、浸取、水解、结晶等方法，分离钨和钴，然后制取12-磷钨酸的原理和生产工艺。

However, due to high melting point of tungsten and ductile-brittle transition temperature, crocodiling, lamination and cracking were easily formed in roll processing.

由于金属钨的高熔点、高韧-脆转变温度，因此钨板在轧制过程中易出现张嘴，分层，开裂等现象。

Temperature Profile Analysis of Tungsten Type Composition

钨系延期药燃烧温度场分析

Laser Raman spectroscopy and temperature programming reduction study of supported tungsten oxide

负载氧化钨催化剂的拉曼光谱和程序升温还原研究

Effect of Glass Phase on High Temperature Stability of Thick Films in Tungsten System

钨系厚膜材料中玻璃相对高温稳定性的影响

The effect of following factors on thermal fatigue resistance of GJW50 steel-bonded tungsten carbide, such as, austenitizing temperature, tempering temperature and hardness, has been studied.

研究了奥氏体化温度，回火温度及硬度对GJW50碳化钨钢结硬质合金热疲劳抗力的影响。

Fractal study of dynamic tension fracture for PM tungsten alloy

钨合金动态拉伸断口的分形维数

But, pumping heat out of your house isnt cheap, and turning on one air conditioner is the same as running dozens of Tungsten light bulbs.

但是，将热气从家里抽出并不便宜，而且打开一台冷气机等同于使用数打钨丝灯泡。

Distortion of PIM tungsten heavy alloy during liquid phase sintering

PIM高密度合金在液相烧结过程中的变形

The density of tungsten heavy alloy plates liquid phase sintered in continuing furnace was investigated with drainage, and its distributions both in width and length were studied.

采用阿基米德排水法，测量了连续液相烧结钨基高比重合金板的密度，并对其在长度和宽度方向上的密度分布进行了研究。

Effect of concentration of sodium tungstate in electroplating bath on properties of nickel-tungsten-phosphorus Ternary Alloy

钨酸钠加入量对铜基镍-钨-磷合今镀层性能的影响