Ignition的例句大全

In-cylinder thermodynamic state dominates the ignition and combustion process of the HCCI gasoline engine.

缸内热力学状态对汽油机HCCI着火及燃烧过程有着决定性的影响。

Study on Ignition Properties of Coals by Using Thermogravimetry

煤着火特性的热重分析研究

Arc ignition is adjustable for different thickness of work pieces, thrust current can be regulated to satisfy various welding requirements.

焊接热引弧可调，适用于不同板厚工件的焊接引弧。推力电流调于各种焊接工艺要求。

Its application in the high energy ignition controll system realizes the most important three functions namely, constant current, dwell angle controlling and protection during supply interruption and circuit breaking off.

它在高能点火控制器中的应用，实现了专用点火芯片中最重要的3种功能，即恒流、闭合角控制及停电断电保护。

An experimental investigation on three-dimensional effect of ignition process of propellant charge in large caliber guns

大口径火炮发射装药点火过程三维效应实验研究

Theoretical Studies on Laser Induced Plasma Ignition Mechanism and the Threshold Detection

激光等离子体点燃机理分析与阈值测试研究

Based on 4105Q-diesel, single-fuel natural gas engine is developed with the removal of diesel injection system, proportion mixture device induction tract, throttle governor, and ignition system increased, and compression ratio reduced.

基于4105Q型柴油机为原型机开发的单燃料天然气发动机，去掉柴油机燃油喷射系统，增加比例式混合器供气系统、节流阀体、点火系统、降低压缩比。

In the line-of-sight coordinate system, the relation motion equation is given and the ignition line of impulse engines is put forward according to the concept of zero effort miss, and the correct thrust orientation is gotten.

在视线坐标系中建立了子弹相对运动方程，根据零效脱靶量的概念，给出了脉冲发动机的点火曲线，并得到发动机正确的推力方向。

Premixed combustion shows better Performance, including extended stable range 、 simple ignition 、 lower heat loss and more powerful Thrust output in catalytic experiments.

实验研究发现，铂催化环境下，微喷管内的预混燃烧表现出了良好的燃烧性能，包括较为宽阔的稳燃范围，良好的点火性能、较低的散热损失以及较高的推力输出等。

Ignition Theory and Factors Affecting the Delay Time in Second of Electric Delay Detonators

延期电雷管的发火原理及影响秒量因素的探讨

One of the reasons causing these problems is the difficulty in controlling the time of ignition.

其原因之一是着火时刻难以控制。

Compared with other ignition methods, digital ignition has the advantages of good adaptability, fast responsibility, and precise control of the time of ignition.

数字点火方式具有适时性好、响应快、控制点火时刻更为精确等其他点火方式无法比拟的优点。

The critical temperature of propellant is 520~ 525K and the delay time of ignition decreases with increasing the outside flame temperature.

推进剂产生热危险性的临界温度为520~525K；在外界火焰作用下，发动机内的推进剂将点火燃烧，随着外界火焰温度的上升，推进剂起始燃烧的延迟时间减少。

And the ignition temperature becomes lower, the delay time of ignition becomes shorter and the highest temperature becomes lower with the increase of compact density.

随压坯密度提高，体系点火温度降低，点火延迟时间缩短，所达到的最高温度也降低。

Under the condition of reasonable controlling on time of ignition of two level or multilevel spherical charge, the downgoing energy of seismic wave can be improved and the vibration of surface can be reduced.

在合理控制两级或多级球形装药起爆时间条件下，能提高地震波的下传能量，同时减少地表的振动。

By the experiments, we have proved that the delayed time of ignition is not only dependent on the surface-to-mass ratio of aluminum dust, but also on the content of pure aluminum in an aluminum particle.

点火延迟与铝粉颗粒的比表面积和活性铝的含量有关，而与环境的氧含量基本无关；

The experiment shows that the system has realized the real time test of ignition process with high reliability and accuracy.

实验表明该系统能实现对点火性能参数的准确、可靠、高精度的实时测试。

The melting time of the ignition resister decreased exponentially with increasing the voltage.

随着点火电压的提高，桥膜熔断时间呈指数衰减。

The ignition delay time of plasma ignition is less than that of conventional spark ignition, while the percentage of the reduced ignition delay time declines as the working frequency increases.

等离子体的点火延迟时间小于常规火花点火的点火延迟时间，随着工作频率的提高，点火延迟时间减少的程度下降。

The charge flux of plasma, the delay time of laser ignition and the absorbability of laser by plasma were tested to study the effects of plasma and ablation on laser ignition processes of energetic materials.

通过测试激光点火的延迟时间、等离子体电荷通量和等离子体对激光的吸收能力，研究了激光等离子体和烧蚀对激光点火过程的影响。