MPa的例句大全

When cooling gas pressure exceeds 1 MPa, internal cooling effect is a little bit better than external cooling.

当冷气压力达到1MPa时，内冷却效果略优于外冷却。

The experiments proved that external cooling effect is better than internal cooling, when cooling gas pressure is less than 1 MPa.

实验表明，在冷气压力不大于1MPa实验条件下，外冷却的效果优于内冷却。

A fretting test of overhead electrical conductor was performed on a conductor bending fatigue test system under the conditions of an axial load of 30 MPa, a frequency of 10 Hz and a bending amplitude of 0.8mm.

在轴向静载荷为30MPa，振动频率为10Hz，弯曲振幅为08mm的试验条件下，在弯曲疲劳试验装置上对JL/G1A12526/7架空导线进行微动试验。

For cohesion c, the values of maximum stress linearly increase with the value of c increase when the depth is larger than 300m, but the values of maximum stress keep constant as c is larger than 0.7 MPa when the depth is less than 200 m.

当覆盖层深度大于300m时，最大应力值会随着粘聚力c的增大而线性增大，当覆盖层深度小于200m，c值大于0.7MPa时，最大应力值保持常数。

Crossover Scheme of 1.6 MPa Natural Gas Main by Pipe Bridge

6MPa天然气管道管桥法过河方案探讨

The vapor-liquid phase equilibrium data for the binary system of m-xylene-water at 0. 1013 MPa were determined by using an improved pant equilibrium cell. Thermodynamic consistency test indicates that the experimental data are reliable.

采用改进的Partt釜测定了在0.1013MPa下，间二甲苯－水二元部分互溶体系的气液相平衡数据，经热力学一致性检验表明，测定数据是可靠的。

The thermodynamic process of acid pressure leaching of high iron sphalerite is studied and three ε-pH figures of ZnS-H_2O system, FeS-H_2O system and ZnS-FeS-H_2O system at 150 ℃, 1 MPa have been drew, respectively.

对高铁闪锌矿高压酸浸的热力学过程进行了研究，并绘制了150℃、氧气压力为1MPa时，浸出体系中ZnS-H2O系、FeS-H2O系、ZnS-FeS-H2O系的电位-pH图。

The results indicated that higher cryogenic toughness and strength can be obtained by thermomechanical treatment than by ordinary or(α+ β) biphase heat treatment. The cryogenic toughness will increase by about 12% with the maximum room-temperature strength up to 107.8 MPa.

结果表明：高温形变热处理比普通热处理及a+γ两相区热处理有较好的低温韧性及强度，低温韧性提高12%左右，室温强度提高的最大值为107.8MPa。

The results show that the thermoplastic sheets and the flow molded parts have superior mechanical properties, that is, tensile strength, flexural strength, modulus and impact strength are greater than 60 MPa, 100 MPa, 3 500 MPa and 50 kJ/ m2 respectively.

结果表明：三种热塑性复合材料片材与制品具有优异的力学性能，拉伸强度、弯曲强度、模量和冲击强度分别大于60MPa、100MPa、3500MPa和50kJ／m2，热变形温度158℃左右。

MPa and nearly horizontal, the jacking strength is about 6.

最小主应力状态为近水平; 测点洞段围岩的抗劈裂强度一般为6.

The hydrothermal decomposition of thiodiglycol in supercritical water was examined in this paper. Experiments were performed in an isothermal, plug-flow reactor at temperatures from 425 to 525 ℃, pressures from 22 to 30 MPa, and reactor residence time from 0.6 to 63.2 s.

在等温管式平推流反应器中研究了超临界水中硫代双乙醇（TDG）的水热分解反应，反应温度为425～525℃，压力为22～30MPa，反应停留时间为0.6～63.2s。

Introduced from the West, the United States in particular, the MPA program has become a new member of the current graduate degree education system of China.

MPA教育是一项从西方尤其是美国借鉴而来的学位教育，已成为中国研究生学位教育体系的一员。

The study results also show that low-permeability reservoir gas injection has a threshold pressure, and the value of this experiment is 2.48 MPa.

低渗透油藏注气存在注气启动压力，本次实验为2.48MPa。

The titanium carbonitride powder with average particle diameter of 2 μ m was prepared at 1700 ℃ for 3 h, nitrogen partial pressure of 0.1 MPa.

在N2压力为0.1MPa的条件下，于1700℃保温3h热处理后，可以获得平均粒径为2μm的碳氮化钛粉末。

The flexural strength of sintered bodies increases from 11.5 MPa to 19.6 MPa with the solid loading increasing from 50% to 80%, corresponsively.

烧结后的炭制品当固含量的体积百分数从50%增加到80%时，相应的抗弯强度从11.5MPa增加到19.6MPa。

It is suggested that the flanges with 0.25, 0.6 MPa adopt the connection dimension for the flange with 1.0 MPa, while the thickness is kept at the original size, so as to simplify the connection dimension.

建议对0.25、0.6MPa法兰盘采用1.0MPa的对接尺寸，厚度仍采用原来的三种规格，从而实现对接尺寸的简约化。

The thermal cycling test between 153 K-393 K were performed on SiCw/ AZ91 magnesium matrix composite with the load of 20 MPa, and the tensile properties of SiCw/ AZ91 before and after thermal cycling were evaluated.

对碳化硅晶须增强AZ91镁基复合材料在153K～393K进行加载热循环试验，载荷为20MPa静载荷，测定了复合材料在热循环前后的力学性能。

The sensors have been used in a pressure detection system with the sensitivity of 56050 mV/ MPa, zero drift of less than 0.1mV/h and thermal drift of 0.013%/ ℃.

该传感器已用于充压检漏系统，其灵敏度达到56050mV/MPa.零漂小于0.1mV/h，热灵敏度漂移为0.013%/℃。

Synthesis and Structure Characterization of Oleic Acid Modified MPA Sorbitol Resin

油酸改性MPA山梨醇树脂的合成与结构表征

When the pressure is increased to 0.13 MPa, the cell performance at reactant stoichiometric ratio of 1.0 is as same as that at the condition of sufficient reactant.

当提升压力至0.13MPa，化学计量比1.0的电池性能与足量反应气体工况下的性能相当。