MPa的例句大全

Commercial Trial-production and Properties of High Strength Vanadium Bearing Hot Rolled Reinforced Bar of 460 MPa Grade

460MPa级高强度含钒钢筋的生产试制和性能

At 2. 1 MPa, the content of heat stress protein in the plasma and malonaldehyde in the brain extracellular fluid were elevated slightly.

1MPa氦氧和氢氧环境下，大鼠血浆热应激蛋白（HSP-70）含量和小鼠脑细胞外液丙二醛（MDA）含量均略有升高。

Almost retentive water of mixed soil was efficiency ( 0~ 1.5MPa).

土壤中加入绿宝保水剂后，所保持的水分绝大部分为有效水（0～1.5MPa）。

WG was usually misdiagnosed as primary lung cancer or metastasis while MPA was usually misdiagnosed as lung infection and interstitial pneumonia.

WG常误诊为原发性或转移性肺癌，而MPA则常被误诊为肺部感染和间质性肺炎。

Objective To evaluate the effects of nylestriol with small dose of MPA replacement treatment on lipids, blood pressure, and body mass index in postmenopausal women.

目的探讨尼尔雌醇联合小剂量安宫黄体酮（MPA）替代治疗对绝经妇女血脂、血压及体质量指数的影响。

Then it analyzes the relationship between the MPA training and teaching resources: interaction and coordinated development& teaching resources provide the material basis, intelligence support, and system security for MPA training and MPA training promotes the rational allocation and optimization and integration of teaching resources.

然后分析了MPA培养与教学资源的关系：相互影响、协调发展的关系，教学资源为MPA培养提供物质基础、智力支撑和制度保障；MPA培养促进教学资源的合理配置和优化整合。

According to theory of measure of viscosity with capillary, pressure viscosity relation at high presssure of lubrication grease with nano-particle tester is developed, which can apply pressure circumstance of 400 MPa, the shear rate of the tester can be adjusted in a range of 20-300/ s.

根据毛细管粘度测量的基本理论，研制了适合测量含纳米颗粒润滑脂在高压条件下的压粘关系的试验台，试验台可以提供的最高压力为400MPa，剪切率范围在20-300/s内。

Recently a masters level education program in public administration ( MPA) was established within China with the aim of fostering high-level public service personnel.

为建设高效率的国家公务员队伍，我国公共管理硕士（MPA）教育日前启动。

The largest amplitude of maximum horizontal principal stress is about 17 MPa in all the boreholes in the dams areas, and the orientations are mainly NNE or NEE though influenced by local topography;

各坝址孔中最大水平主应力值最高约为17MPa，最大水平主应力方向受局部地形地势影响变化较大，但大多数孔方向仍为NNE或NEE；

According to simulating analysis, the absolute error of 90% forecasting data is smaller than 0. 01 MPa.

经仿真分析，SVM模型90%以上预测数据的绝对误差控制在0.01MPa；

First, it gives an overview of the MPA program: it is a professional and interdisciplinary degree program based on extensive borrowing from other relevant fields of study since public service requires a wide variety of expertise.

第一步，对MPA教育作了简要介绍；它是一项跨学科的职业学位教育，建立在广泛借鉴其它相关学科的基础之上，这是因为公共服务需要多方面的知识和技能。

The optimized stress on the round arc surface of bottom griddle comb is 7.7 MPa more than former stress;

作用在下层梳子圆弧面上的等效应力较优化前增加了7.7Mpa；

microstructure and mechanical properties of 2200 mpa grade ultra-high strength low alloy steels

2200MPa级超高强度低合金钢的组织和力学性能

the maximum methane conversion of 48.5% and methanol yield of 41.5% were obtained under the conditions of 7.0 mmol catalyst, methane pressure of 3.5 mpa, reaction temperature of 473 k, reaction time of 3 h, and 50% sulfur trioxide concentration.

在工艺条件为催化剂用量7·0mmol，反应温度473K，反应压力3·5MPa，反应时间3h和发烟硫酸中SO3含量50%时，甲烷转化率可达48·5%，目的产物甲醇收率为41·5%。

Result shows that hydrogen-oxygen fuel rich gas generator cycle is better than other system scheme when chamber pressure is lower than 12.7MPa;

结果表明：当室压低于127MPa时，应当采用氢氧富燃燃气发生器循环；

Methods Sixty patients of advanced cancer were randomly divided into two groups, 30 patients in group A treated with TCM and MPA, 30 patients in group B treated with MPA.

方法60例晚期肿瘤病人随机分为两组，A组30例为中药加醋酸甲羟孕酮，B组30例为单纯醋酸甲羟孕酮。

The catalytic oxidation of para-aminophenol in supercritical water with oxidation catalyst Cu~ ( 2+) and oxidant H_2O_2 was investigated in a tubular continuous flow reactor at 24~ 30 MPa, 480~ 500 ℃.

采用Cu2+为催化剂、H2O2为氧化剂，在一连续流反应器中进行了催化超临界水氧化对氨基苯酚实验。

Microstructure and Mechanical Properties of 710 MPa Hot-Rolled High-Strength Steel

710MPa级热轧高强钢的组织性能

The ultra-filtration condition was: NF-2 nanometer membrane, pressure of 1.0 mPa.

超滤分离条件：NF-1纳滤膜、截留分子量2000D、超滤压力1.0mPa。

A low carbon high strength steel with lower yield strength reached 700 MPa was developed through controlling rolling and controlling cooling, and its microstructures and strengthening mechanisms were analyzed.

通过控制轧制与控制冷却，研制出下屈服强度为700MPa级的低碳高强度钢，并对其组织及强化机制进行了分析。