MPa的例句大全

The reflectance of the black coatings, the thickness of which can reach 25 μ m, can be as low as 7%, and the bonding strength between the black coating and the matrix can be as high as 234 MPa.

发黑膜对光的反射系数最低可达7%，厚度可达25μm，与基底的结合力达234MPa以上。

Its heat pressure can be up to hundreds of MPa while the graphite is heated;

石墨被加热后，其晶体自身的热压力可达几百MPa；

The Model of MPA Education in China for Improving the Civil Servant Capacity

基于公务员能力提升的我国MPA教育路径选择

The results show that the tensile strength of the UHMWPE fiber strands is greatly decreased when the temperature is higher than 123 ℃, and the ballistic absorption energy is up to the highest value when the molding pressure is about 12.5 MPa.

结果表明，温度超过123℃后拉伸强度有大幅的下降，而成型压力为12.5MPa时达到最大值。

Ultra-high pressure waterjet with pressure 200~ 250 MPa has been used to remove rust automatically and to prevent from re-rusted in a series of testing research.

以200～250MPa的超高压纯水射流进行了除锈自动作业和防止返锈的一系列试验研究。

Performance evaluation procedure based on MPA method for uni-directional eccentric structures

基于MPA的单向偏心结构性态评估方法

By controling the conditions of uni-directional solidification the material could obtain very high tensile strength which reached a level of 2300 MPa or higher.

通过控制定向凝固条件，可使材料具备极佳的抗拉性能，其抗拉强度值可达2300MPa以上。

After hardening 4h and 8h the compressive strength of the patched concrete is bigger than 20 MPa, which can satisfy the request of fast patching.

修补混凝土硬化后4h、8h抗压强度大于20MPa，能满足快速修补的要求；

On the application of namo SiO_2 in 100 MPa high-strength cement-based composites

纳米SiO2在高强水泥基路面材料中的应用

The experimental results indicated that this blocking agent have following advantages: its gelatification time can be controlled and adjusted between 2-72 hours, its compressive strength can reach from 26 MPa/ m to 61 MPa/ m, and its stability is perfect within a long time.

实验结果表明，有机复合交联堵剂的成胶时间在2-72小时可调可控，抗压强度可达26-61MPa／m，而且具有很好的长期稳定性。

Ability of methanol dehydration and methanol synthesis hybrid catalyst in slurry bed was investigated under reaction conditions of 240-280 ℃ and 5.0 MPa.

在温度240-280℃、压力5.0MPa的反应条件下，考察了浆态床反应器中甲醇脱水催化剂和甲醇合成催化剂的稳定性。

MPA Workshop on Environmentally Sound Technologies for Domestic Wastewater Treatment

利用无害环境技术处理家庭废水讲习班

The result has shown that the residual stress at the filet and the journal of the crankshaft treated with BMP process is higher, the average being 400 MPa, three times higher than that of the medium-frequency hardened crankshaft.

结果表明，BMP工艺处理的曲轴轴颈及过渡圆角处的残余应力均较高，平均为400MPa，是中频淬火曲轴的4倍。

At the sauce temperature 50~ 60 ℃ and pressure 25 MPa, through twice homogenization the stable spicy taste sauce is obtained.

料液温度50~60℃，压力25MPa均质2次，可获得稳定性良好的花椒麻辣调味汁。

RESULTS: ① The increase of height of gingival wall could decrease the stress of adamantine layer ( 0.1-0.27 MPa), which had no significant effect on dentin.

结果：①龈壁高度的增加，使牙釉质应力减少（0.1～0.27MPa），对牙本质无明显影响。

The suitable proportion of core material and wall material was 1.2 ∶ 1 And high pressure homogenization can effectively increase the MEE and MEY, its suitable homogenizing pressure was 30 MPa~ 40 MPa.

心材与壁材的适宜比例为12∶1；高压均质可有效地提高天然维生素E的微胶囊化效率和微胶囊化产率，其最佳均质压力为30MPa～40MPa；

Cracked 1-hexene is copolymerized with ethylene in 2L stainless autoclave for slurry polymerization and gas phase stirring polymerization. Polymerization is carried as follows: pressure 1. 03 Mpa;

以半炼蜡裂解1-己烯为原料，在2L不锈钢釜中进行了与乙烯共聚的淤浆聚合和气相搅拌聚合试验研究，聚合工艺条件为：压力1.03MPa；

If the hydraulic unit locked the top of cylinder, the hydraulic oil cannot leak and the cylinder stopcock could not ascend, then the oil pressure of the cylinder would theoretically increase ten MPa.

如果油缸上腔亦加液压锁，液压油无法泄漏，油缸活塞不会上移，则油缸内油压理论上将增加10MPa。

The HAZ Grain Growth Diagram of the New Generation Steel with Yield Strength 400 MPa

400MPa级新一代钢铁材料焊接热影响区晶粒长大图

Its strength strength is 5.18 MPa under normal temper at ure;

在常温下，压剪强度为5.18MPa；