Tension的例句大全

Digital testing of the dynamic tension of warp yarns on warp knitting machines Trends

经编机经纱动态张力数字化测试

Testing of the Roving Tension and Some Discussions

粗纱纺纱张力的测试与探讨

An Approach to the Manipulation of Yarn Quality through Controlling Roving Strength Testing of the Roving Tension and Some Discussions

控制粗纱强力掌握成纱质量的探讨粗纱纺纱张力的测试与探讨

At the same time, the basic principle and the testing method of the tension version of the split Hopkinson bar are introduced briefly.

同时本文简要介绍了分段式Hopkinson拉杆实验技术的基本原理和实验方法。

Based on the world-wide researches, the reasonable and feasible testing conditions of direct tension for asphalt mixture included specimen dimension, judgment, controlled mode, load frequency and test temperature are determinated.

在国内外研究成果基础上，提出了合理可行的沥青混合料直接拉伸疲劳试验中试件尺寸、失效判据、控制方式、加载频率和试验温度等条件。

By testing the oxygen sensor tension waveform signal by automobile oscilloscope, the paper analyzes the tension waveform of the standard signal which is emitted by oxygen sensor, introduces the general step of diagnosis engine breakdown by oxygen sensor waveform analysis and its practical applications.

通过汽车示波器对氧传感器的信号电压波形测试，介绍了氧传感器的标准信号电压波形、氧传感器波形分析法诊断发动机故障的一般流程及其具体应用。

Analyzing testing data of chain tension, fatigue cumulative damage change of the plow chain is got under different cutting depths, and it accords with fatigue cumulative damage change of plow chain by simulating dynamic model. It provides references for reliability analysis of plow chain.

分析刨链张力实验数据，得到不同刨深情况下的刨链疲劳累积损伤规律，与通过动力学模型仿真得到的刨链疲劳累积损伤规律一致，为刨链可靠性分析提供了依据。

P_ 33/ P_o ( P_ 33, transient tension of tetanic contraction at the 33 s) was reduced significantly in SUS, and it manifested an increase in fatigability during tetanic contraction in SUS.

但是，高频强直收缩第33秒收缩张力与最大张力之比（P33/Po）却明显降低。

In high-frequency tetanic contraction, the maximal tension ( Po) of soleus was reduced respectively by 32.8%, 60.1% and 77.6% after one ( P < 0.05), two and four weeks of ( P < 0.01) tail-suspension ( SUS).

与对照组比较，悬吊1wk大鼠SOL高频强直收缩的最大张力（Po）降低32.8%，但统计学无差异（P>0.05）；悬吊2wk组降低60.1%（P

Simple Tension Control Strategy for Variable Length Tethered Satellite System

可变绳长绳系卫星系统的一种简单张力控制策略

The density ρ and surface tension γ of lithium tetraborate melt have been systematically measured from 1100K up to about 1500K. The experimental results indicate that the melt density and surface tension decreased linearly with increasing temperature.

系统测量了四硼酸锂（Li2O-2B2O3）熔体的密度ρ、表面张力γ随着温度的变化规律，实验结果表明在1100K到1500K范围内Li2O-2B2O3高温熔体的密度和表面张力随着温度的升高均线性减小。

Studies of the effect of substituent on IHE tension of Tetrahedrane

四面体碳烷张力的取代基影响研究

Temperature correction in estimation of cable tension

斜拉桥索力测试的温度修正

It produces a considerably large ex-Tensional force in the upper part of the crust and a horizontal shear stress in the middle and lower parts of the crust at the same time.

它能够在地壳上部产生足够大的伸张应力场，同时在地壳中部或下部产生水平切应力场。

Both the instability generated in illness and the dramatic tension generated in theatricality push the plot forward. In addition, the subtle selection of narrative perspective of illness and narrative voice of illness also contributes to the realization of thematic significance.

品特戏剧中的疾病产生的不稳定性以及戏剧性生成所形成的张力，推动着剧情的发展，而疾病叙述视角与叙述声音的精心选取，有力地实现了主题意义的彰显。

Based on the real example, the feasibility analysis was done through theoretical arithmetic on one-end tension of long tendons. The research can provide the theoretical support for the application.

立足于工程实际，通过理论计算分析了长索单端张拉的可行性，针对单端张拉对结构所产生的影响进行计算，为长索单端张拉在工程上的应用提供理论支持。

Tension leveller is divided into 3 levels: coordinating control among every technology device of process: process section;

分为三级控制，生产线工艺段各工艺设备之间的协调控制；

The theoretical critical impact velocity in tension is discussed: For OFHC copper, the theoretical critical impact velocities ( the plastic wave speed reaches zero) in tension are calculated with J-C and Z-A constitutive relations and the obvious differents are indicated. 7.

讨论了理论临界冲击拉伸速度：从理论临界拉伸速度的定义出发。采用J-C及Z-A本构关系计算了OFHC材料塑性波趋于零时的不同的临界冲击拉伸速度。

Oil-air Lubricate System of Tension Leveller of Continuous Casting Machine

连铸拉矫机油气润滑系统

The data calculated agreed with actual data and this model is used to optimize technical parameters of tension leveller.

所建模型已用于对此拉矫机工艺参数设定值的优化调整。