Winding的例句大全

According to research, the transformer winding temperature increasing by 6 ℃ above the temperature limit, the use of life will be shortened by half.

根据研究，变压器绕组温度在规定温度极限之上每升高6℃，使用年限将缩短一半。

Computation Method of the Kinetic Property of Salinity, Temperature and Depth Probe with Releasing Winding

线圈释放式温、盐、深探头运动特性的数值计算方法研究

Temperature Rise Test of Dry-Type Air-Core Reactor and Calculation of its Winding Temperature Rise

干式空心电抗器的温升试验与绕组温升的计算

The related regulations of temperature rise test of autotransformer for autotransformer starter in IEC, GB were described, the current in every winding of autotransformer was analyzed.

叙述了IEC和GB标准中对自耦减压起动器中自耦变压器温升试验的有关规定。

Through various short-circuit current temperature rise test results, the transformer temperature, time, and a high degree of three curves, obtained directly within the thermal region transformer primary winding height of about 83.3%.

通过在不同短路电流条件下的温升试验，得到了变压器内部的温度与时间、纵向高度之间的关系曲线，得出变压器内部热区域主要集中在约绕组自下而上高度的83.3%区域。

The thermal resistance data which is got after temperature rise test on dry-type air-core reactor is treated by using curve fitting method. The method of calculating the mean temperature rise of winding is derived from the principle of thermal equilibrium.

介绍了用曲线拟合的方法对干式空心电抗器温升试验后的热态电阻数据进行处理，并利用基于热平衡原理导出的公式计算绕组平均温升的计算方法。

Through systematic and detailed analyses for the causes of fuzz in gun roving production, it is concluded that the fuzz arising is related with strand tension, fiber size lubrication, cake drying and roving winding process.

对喷射纱生产中的毛羽产生的原因作了系统、详细的分析后得出，毛羽的产生是与原丝张力、浸润剂的润滑性、原丝烘干过程、络纱过程相关。

The method of tension winding about fiber bundle is an effect way to improve the radial strength of flywheel.

利用在纤维束缠绕时施加张紧力，使得固化成型后的飞轮内部形成一定的预加径向压应力，这是提高飞轮径向强度的有效方法之一。

The process of winding can be separated from the measure to the technological parameters, the variety of the winding tension of the fiber and the temperature of the gum trough directly affects the whole performance of the winding goods.

在缠绕加工过程中，离不开对加工工艺参数的监测，缠绕时纤维张力和胶槽温度的变化直接影响缠绕制品的整体性能。

Experimental results show that with crisscross winding method and 30% to 40% of resin content and 150 N to 200 N of winding tension for a fiber strand and GPC chart analysis to determine curing time, better comprehensive performance of the composite materials can be obtained.

结果表明：采用交替铺层方式缠绕成型，含胶量控制在30%～40%（质量分数），缠绕张力控制在150N～200N，采用GPC谱图控制固化时机，得到的复合材料综合性能较好；

Research on Tension Control System in Fiber Winding and Placement and Design of the Tension Test Platform

纤维铺缠设备中张力控制器及张力测试台研究

The concrete measures such as adjusting radial winding density, assuring the starting position of cone drum belt, configuring tension exchange gear reasonably to adjust the roving tension were proposed.

并提出同时应采取调整轴向卷绕密度、确定锥轮皮带起始位置、正确配置张力变换齿轮等具体措施直接对粗纱张力进行工艺调整。

Analysis and design of tension control structure in flexibly winding drive

柔性卷绕传动张力控制机构分析与设计

This paper introduces the theories of the winding tension control system in glass cloth dipping process and discusses the changing pattern of the inner tension and the factors that influence the tension from the theory of elasticity.

介绍了玻璃布浸渍加工中收卷张力控制系统的工作原理，并从弹性理论出发，讨论了收卷过程中的内张力变化规律及其影响因素。

To get the transient characteristics, according to the mathematical model of three-phase induction motors in α-β coordinate, considering the stator winding terminal voltage constrains condition of fault operation, the practical simulation program was written.

根据三绕组单相电容异步电动机在α-β坐标系下的瞬态数学模型以及故障状态时的端点边界方程，推导出绕组的端电压约束条件，编写计算机仿真程序；

Tertiary Winding Structure Analysis of the Split-Winding Transformers

分裂变压器平衡绕组结构分析

Furthermore, there may be neutral stability concerns if there is no physical tertiary winding in the autotransformer.

而且，如果在自耦变压器中没有实值的第三线圈绕组，那么可能存在中性稳定性问题。

By means of simulation of impedance Frequency characteristics, this paper analyzes the influence of transformer tertiary winding leakage reactance on harmonic filtration. Based on theoretical analysts the authors put forward the method to solve the above-mentioned problem.

本文通过阻抗频率特性仿真，分析了变压器漏抗对滤波效果的影响，并从理论上提出了解决上述问题的方法。

Through the antenna entity deployment test, verify these connector components is reasonable in design, with a good anti winding.

通过天线实体展开试验，验证了索网反射面各部件设计合理，具有良好的防缠绕性。

Meanwhile, a distribution transformer is used to study the effect of winding deformation. It is found that the repeatability and consistency of three phases are excellent and the effect of the test leads length on the FRA results is significant.

在配电变压器上的试验表明，频响法的可重复性和三相一致性良好，测量引线的长短对测试结果有很大影响。